Virgil Gavriliuc
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Virgil Gavriliuc has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Kenji Watanabe
National Institute for Materials Science
2 shared publications Kristina Vaklinova
Institute for Functional Intelligent Materials, National University of Singapore, Singapore, Singapore
2 shared publications- Maciej Koperski
Institute for Functional Intelligent Materials, National University of Singapore, Singapore 117544, Singapore
2 shared publications - Alexey I. Berdyugin
National University of Singapore
1 shared publication - Amoz Chua
Department of Materials Science and Engineering, National University of Singapore, Singapore, Singapore
1 shared publication - Denis S. Baranov
Moscow Institute of Physics and Technology, 141700, Dolgoprudny, Russia
1 shared publication
Latest Publications
- Open Access
- 4 May 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Polymer-free van der Waals assembly of 2D material heterostructures using muscovite crystals
The advent of van der Waals (vdW) heterostructures has enabled formation of bespoke materials with atomic precision, where numerous quantum and topological phenomena have already been discovered. This atomic-layer tunability, however, comes at a cost: individual 2D layers must be picked up, moved, and placed in a deterministic manner while keeping their interfaces atomically clean. Recent advances in machine learning and robotics place even stronger emphasis on the deterministic aspect of vdW assembly. Current polymer-based transfer methods satisfy neither the determinism nor cleanliness requirements. To this end, solutions are needed where adhesion can be dynamically and deterministically controlled without leaving organic contamination. Here, we present a polymer-free transfer technique employing thin muscovite (mica) crystals. Temperature control over mica adhesion enables deterministic pick-up, stacking, and release of 2D materials, while their crystalline, inorganic nature ensures pristine interfaces and suppresses strain. Fully compatible with existing fabrication workflows, this approach enables the assembly of demanding vdW heterostructures, including those with exposed conductive layers, moiré superlattices and suspended membranes. Our method represents a promising strategy for vdW heterostructure fabrication toward its automatisation.
- 4 May 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Open AccessPolymer-free van der Waals assembly of 2D material heterostructures using muscovite crystals
The advent of van der Waals (vdW) heterostructures has enabled formation of bespoke materials with atomic precision, where numerous quantum and topological phenomena have already been discovered. This atomic-layer tunability, however, comes at a cost: individual 2D layers must be picked up, moved, and placed in a deterministic manner while keeping their interfaces atomically clean. Recent advances in machine learning and robotics place even stronger emphasis on the deterministic aspect of vdW assembly. Current polymer-based transfer methods satisfy neither the determinism nor cleanliness requirements. To this end, solutions are needed where adhesion can be dynamically and deterministically controlled without leaving organic contamination. Here, we present a polymer-free transfer technique employing thin muscovite (mica) crystals. Temperature control over mica adhesion enables deterministic pick-up, stacking, and release of 2D materials, while their crystalline, inorganic nature ensures pristine interfaces and suppresses strain. Fully compatible with existing fabrication workflows, this approach enables the assembly of demanding vdW heterostructures, including those with exposed conductive layers, moiré superlattices and suspended membranes. Our method represents a promising strategy for vdW heterostructure fabrication toward its automatisation.
- Open Access
- 26 February 2026
- Published by IOP Publishing in 2D Materials
- Vol. 13 (2) , 021002
Surface defects in carbon-doped hexagonal boron nitride for negative-contrast direct laser writing
Radiative defects in hexagonal boron nitride (hBN) are active in a broad spectral range from deep ultraviolet to near-infrared wavelengths. Representatives of these defects act as bright single photon sources, spin-1 systems, and multiproperty atomic-scale sensors. They are predominantly investigated in bulk hBN films, where defects are decoupled from surface and interfacial effects. Here, we demonstrate a novel class of surface defects optically active in the green/yellow visible spectral range, which exhibit photophysical properties distinct from their bulk counterparts. High-power resonant laser illumination quenched the emission from the ensemble of such defects, which was attributed to a light-driven structural reconfiguration. The quenched defects were found to recover their emissive capabilities via a thermal cycling process, revealing an activation energy of 24.5 meV for the structural transition. Alternatively, permanent quenching of the defects was triggered by surface chemistry, involving lithiation-enabled attachment of functional groups. These mechanisms were utilized to realize negative-contrast direct laser writing, designing arbitrary geometric emissive patterns on demand in a microscopic configuration. The surface-active radiative centers in hBN appear particularly attractive for exploring environmental sensitivity, surface science, and coupling to photonic structures or electronic devices by taking unique advantage of the two-dimensional characteristics of the host lattice.
- 26 February 2026
- Published by IOP Publishing in 2D Materials
- Vol. 13 (2) , 021002
Open AccessSurface defects in carbon-doped hexagonal boron nitride for negative-contrast direct laser writing
Radiative defects in hexagonal boron nitride (hBN) are active in a broad spectral range from deep ultraviolet to near-infrared wavelengths. Representatives of these defects act as bright single photon sources, spin-1 systems, and multiproperty atomic-scale sensors. They are predominantly investigated in bulk hBN films, where defects are decoupled from surface and interfacial effects. Here, we demonstrate a novel class of surface defects optically active in the green/yellow visible spectral range, which exhibit photophysical properties distinct from their bulk counterparts. High-power resonant laser illumination quenched the emission from the ensemble of such defects, which was attributed to a light-driven structural reconfiguration. The quenched defects were found to recover their emissive capabilities via a thermal cycling process, revealing an activation energy of 24.5 meV for the structural transition. Alternatively, permanent quenching of the defects was triggered by surface chemistry, involving lithiation-enabled attachment of functional groups. These mechanisms were utilized to realize negative-contrast direct laser writing, designing arbitrary geometric emissive patterns on demand in a microscopic configuration. The surface-active radiative centers in hBN appear particularly attractive for exploring environmental sensitivity, surface science, and coupling to photonic structures or electronic devices by taking unique advantage of the two-dimensional characteristics of the host lattice.