Anas M. M.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anas M. M. has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Dinesh Kabra
Department of Physics, Indian Institute of Technology (IIT) Bombay, Mumbai 400076, India
2 shared publications - Kavaipatti Ramanathan Balasubramaniam
Indian Institute of Technology Bombay
2 shared publications - Sudhanshu Mallick
Indian Institute of Technology Bombay
2 shared publications Abhijit Singha
Indian Institute of Technology Bombay
1 shared publication- Abhijit Singha
Department of Energy Science and Engineering IIT Bombay Mumbai India
1 shared publication Ajay Kumar
Indian Institute of Technology Bombay
1 shared publication
Latest Publications
- 29 September 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (40) , 55253-55264
Mixed Carbazole Self-Assembled Monolayers Enable Scalable Large-Area (>5 cm2) Efficient Wide Bandgap Perovskite Solar Cells
Scalability and operational stability remain critical challenges for wide-bandgap perovskite solar cells (PSCs). Here, we report a mixed self-assembled monolayer (SAM) based on a carbazole moiety as a hole transport layer (HTL) to enable large active area (>5 cm2) PSC fabrication. Buried-interface reveals a compact grain size, reduced pinholes, and enhanced large-area film homogeneity of perovskite films prepared on mixed SAM. Top photoluminescence (PL) study show a recombination exponent (k) of 1.175 for the mixed-SAM HTL/perovskite films, indicating suppressed non-radiative losses. Optimized small-area devices (1.2 cm2) achieve a power conversion efficiency (PCE) of 20.30%, with an open-circuit voltage (VOC) of 1.204 V and fill factor (FF) of 81.32%, alongside enhanced damp-heat stability (T75 > 680 h). Voltage and FF losses are analyzed via transient PL based analytical model and empirical FF model, respectively. Upon scaling to 5.2 cm2, a PCE of 18.88% was maintained with only ∼7% relative efficiency loss majorly associated with reduced FF due to increased series resistance with increased area by almost 433% of the transparent conducting oxide substrate. These results establish mixed-SAM engineering with optimal chemical and electronic properties as an effective route toward scalable, efficient, and stable wide-bandgap PSCs.
- 29 September 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (40) , 55253-55264
Mixed Carbazole Self-Assembled Monolayers Enable Scalable Large-Area (>5 cm2) Efficient Wide Bandgap Perovskite Solar Cells
Scalability and operational stability remain critical challenges for wide-bandgap perovskite solar cells (PSCs). Here, we report a mixed self-assembled monolayer (SAM) based on a carbazole moiety as a hole transport layer (HTL) to enable large active area (>5 cm2) PSC fabrication. Buried-interface reveals a compact grain size, reduced pinholes, and enhanced large-area film homogeneity of perovskite films prepared on mixed SAM. Top photoluminescence (PL) study show a recombination exponent (k) of 1.175 for the mixed-SAM HTL/perovskite films, indicating suppressed non-radiative losses. Optimized small-area devices (1.2 cm2) achieve a power conversion efficiency (PCE) of 20.30%, with an open-circuit voltage (VOC) of 1.204 V and fill factor (FF) of 81.32%, alongside enhanced damp-heat stability (T75 > 680 h). Voltage and FF losses are analyzed via transient PL based analytical model and empirical FF model, respectively. Upon scaling to 5.2 cm2, a PCE of 18.88% was maintained with only ∼7% relative efficiency loss majorly associated with reduced FF due to increased series resistance with increased area by almost 433% of the transparent conducting oxide substrate. These results establish mixed-SAM engineering with optimal chemical and electronic properties as an effective route toward scalable, efficient, and stable wide-bandgap PSCs.
- Open Access
- 9 January 2026
- Published by Royal Society of Chemistry (RSC) in EES Solar
- Vol. 2 (2) , 369-380
Bandgap-tunable transparent perovskite solar cells for 4T Si/perovskite tandem photovoltaics with PCE > 30% via rational interface management
Energy-level-engineered hole transport layer for 4T Si/perovskite tandem solar cells with minimized interface defects and enhanced photovoltaic performance.
- 9 January 2026
- Published by Royal Society of Chemistry (RSC) in EES Solar
- Vol. 2 (2) , 369-380
Open AccessBandgap-tunable transparent perovskite solar cells for 4T Si/perovskite tandem photovoltaics with PCE > 30% via rational interface management
Energy-level-engineered hole transport layer for 4T Si/perovskite tandem solar cells with minimized interface defects and enhanced photovoltaic performance.