Ammar Adil Al-Bakri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ammar Adil Al-Bakri has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ahmad Kamal Ariffin
Department of Mechanical and Materials Engineering Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia
1 shared publication Mohammed Abdul Razzaq
Mechanical Engineering Department, College of Engineering, Alqadisiyia University, Iraq
1 shared publicationMohd Salehudin Fafmin
Department of Mechanical and Materials Engineering, Faculty of Engineering & Built Environment, 43600 UKM Bangi, Selangor, Malaysia
1 shared publication- Zainuddin Sajuri
Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM)
1 shared publication
Latest Publications
- Open Access
- 21 June 2016
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 78 (6-9)
TENSILE AND FRACTURE BEHAVIOUR OF VERY THIN 304 STAINLESS STEEL SHEET
Specimen with rectangular cross-section usually used to measure the tensile properties of materials. However, the specimen size and thickness may affect the results. In this study, tensile and fracture behaviours of very thin 304 stainless steel sheet were investigated. The thickness of the stainless steel sheets investigated were 100 and 300 µm. Tensile samples were cut into dumbbell-shaped of rectangular cross-section with same width for both thickness according to ASTM E8. The results showed that 100 µm thin steel sheet exhibited higher tensile strength with no clear evidence of yielding as compared to 300 µm sheet. The fracture morphology images observed by scanning electron microscopy revealed that both specimens fracture in ductile mode. Formation of dimples on the fracture surface could be recognized easily in 300 µm sample at higher magnification as compared to 100 µm sample.
- 21 June 2016
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 78 (6-9)
Open AccessTENSILE AND FRACTURE BEHAVIOUR OF VERY THIN 304 STAINLESS STEEL SHEET
Specimen with rectangular cross-section usually used to measure the tensile properties of materials. However, the specimen size and thickness may affect the results. In this study, tensile and fracture behaviours of very thin 304 stainless steel sheet were investigated. The thickness of the stainless steel sheets investigated were 100 and 300 µm. Tensile samples were cut into dumbbell-shaped of rectangular cross-section with same width for both thickness according to ASTM E8. The results showed that 100 µm thin steel sheet exhibited higher tensile strength with no clear evidence of yielding as compared to 300 µm sheet. The fracture morphology images observed by scanning electron microscopy revealed that both specimens fracture in ductile mode. Formation of dimples on the fracture surface could be recognized easily in 300 µm sample at higher magnification as compared to 100 µm sample.