M. M. El-Kholy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
M. M. El-Kholy has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
A. Abdelmotaleb.
Prof., and Head of Ag. Eng. Dept., Fac. of Ag., Kaferelsheikh Univ., Egypt
1 shared publication- Alaa Eldin Salem
UAE University
1 shared publication - Mahmoud Younis
Sohar University
1 shared publication - Mohamed I. Ayad
El-Menoufia University
1 shared publication N. H. Abou-El-Hana
Lecturer, Ag. Eng. Dept., Fac. of Ag., Kaferelsheikh Univ., Egypt
1 shared publication- Samir Tayel
Prof. of Ag. Eng., Fac. of Ag. Eng., Al-Azhar Univ., Cairo. Egypt
1 shared publication
Latest Publications
- Open Access
- 1 July 2015
- Published by Egyptian Knowledge Bank in Misr Journal of Agricultural Engineering
- Vol. 32 (3) , 1143-1160
DRYING BEHAVIOR OF PEANUTS USING A ROTARY DRYER
A study was carried out to test and evaluatehigh-temperature short-time drying behavior of peanuts pods using a laboratory scale rotary dryer. The experimental work was conducted at six different levels of cylinder surface temperature 55, 65, 75, 85, 95 and 105 oC, three levels of cylinder rotational speed 3, 6 and 9 (r.p.m) and three peanut batch masses 1, 1.5 and 2 (kg/batch). The high temperature rotary drier was evaluated in terms of operating factors likewise moisture regiem, drying temperature, pods and kernels temperatures, batch mass feed, cylinder rotational speed and compatibility of experimental data to Lewis models. The optimal treatment of the high temperatur dried pods of peanuts was slected in terms of physical characteristics of microbiological quality parameters, percentages of broken, splitted, shriveled kernels, oil content of peanuts, free fatty acids and peroxide value of peanuts oil. The results show that, heating surface temperature of 65 oC, cylinder rotational speed of 6 r.p.m and pods batch mass of 1.5 kg recorded the lowest values of kernels splitting, broken and shriveling percentages. The mathematical analysis showed that, Lewis model could satisfactorily describe the drying behavior of high moisture peanuts pods.
- 1 July 2015
- Published by Egyptian Knowledge Bank in Misr Journal of Agricultural Engineering
- Vol. 32 (3) , 1143-1160
Open AccessDRYING BEHAVIOR OF PEANUTS USING A ROTARY DRYER
A study was carried out to test and evaluatehigh-temperature short-time drying behavior of peanuts pods using a laboratory scale rotary dryer. The experimental work was conducted at six different levels of cylinder surface temperature 55, 65, 75, 85, 95 and 105 oC, three levels of cylinder rotational speed 3, 6 and 9 (r.p.m) and three peanut batch masses 1, 1.5 and 2 (kg/batch). The high temperature rotary drier was evaluated in terms of operating factors likewise moisture regiem, drying temperature, pods and kernels temperatures, batch mass feed, cylinder rotational speed and compatibility of experimental data to Lewis models. The optimal treatment of the high temperatur dried pods of peanuts was slected in terms of physical characteristics of microbiological quality parameters, percentages of broken, splitted, shriveled kernels, oil content of peanuts, free fatty acids and peroxide value of peanuts oil. The results show that, heating surface temperature of 65 oC, cylinder rotational speed of 6 r.p.m and pods batch mass of 1.5 kg recorded the lowest values of kernels splitting, broken and shriveling percentages. The mathematical analysis showed that, Lewis model could satisfactorily describe the drying behavior of high moisture peanuts pods.
- Open Access
- 1 January 2009
- Published by Egyptian Knowledge Bank in Misr Journal of Agricultural Engineering
- Vol. 26 (1) , 251-281
THIN LAYER DRYING OF GARLIC SLICES USING CONVECTION AND COMBINED (CONVECTION - INFRARED) HEATING MODES
Thin layer drying of garlic slices has been studied under convection and combined infrared–convection heating modes. Four levels of inlet air temperature 45, 55, 65, and 75°C and three levels of air velocity of 0.25, 0.75, and 1.25 m/s were used for the convection drying experiments. While, for the combined infrared-convection, three levels of radiation intensity of about 0.075, 0.15 and 0.225 W cm-2 and three levels of air temperatures 45, 55 and 65°C were studied at inlet air velocity of 0.75 m/s. Three mathematical models (Page, Modified Page, and Henderson and Pabis) were examined for describing the drying behavior of garlic slices under the above mentioned experimental parameters. The results were compared to their goodness of fit in terms of coefficient of determination (R2), Standard deviation (SD), average percentage of error (% E), chi-square (χ2) and the modeling efficiency (EF). The results showed increases in drying rate, thermal efficiency, rehydration ratio, flavor strength, and colour difference, and showed decreases in drying time and specific energy consumption for the combined (infrared–convection) heating mode in comparison with convection only. The Page model satisfactorily described the drying behavior of garlic slices and predicted the changes in garlic slices moisture content as compared with the modified Page and the Henderson and Pabis models. Meanwhile, for the convection heating mode, the drying constant (k) increased with the increase of air temperature and air velocity while, the constant (n) decreased, while, for the combined mode, the drying constant (k) increased with the increase of radiation intensity and air temperature. However, the constant (n)decreased.
- 1 January 2009
- Published by Egyptian Knowledge Bank in Misr Journal of Agricultural Engineering
- Vol. 26 (1) , 251-281
Open AccessTHIN LAYER DRYING OF GARLIC SLICES USING CONVECTION AND COMBINED (CONVECTION - INFRARED) HEATING MODES
Thin layer drying of garlic slices has been studied under convection and combined infrared–convection heating modes. Four levels of inlet air temperature 45, 55, 65, and 75°C and three levels of air velocity of 0.25, 0.75, and 1.25 m/s were used for the convection drying experiments. While, for the combined infrared-convection, three levels of radiation intensity of about 0.075, 0.15 and 0.225 W cm-2 and three levels of air temperatures 45, 55 and 65°C were studied at inlet air velocity of 0.75 m/s. Three mathematical models (Page, Modified Page, and Henderson and Pabis) were examined for describing the drying behavior of garlic slices under the above mentioned experimental parameters. The results were compared to their goodness of fit in terms of coefficient of determination (R2), Standard deviation (SD), average percentage of error (% E), chi-square (χ2) and the modeling efficiency (EF). The results showed increases in drying rate, thermal efficiency, rehydration ratio, flavor strength, and colour difference, and showed decreases in drying time and specific energy consumption for the combined (infrared–convection) heating mode in comparison with convection only. The Page model satisfactorily described the drying behavior of garlic slices and predicted the changes in garlic slices moisture content as compared with the modified Page and the Henderson and Pabis models. Meanwhile, for the convection heating mode, the drying constant (k) increased with the increase of air temperature and air velocity while, the constant (n) decreased, while, for the combined mode, the drying constant (k) increased with the increase of radiation intensity and air temperature. However, the constant (n)decreased.
- 1 August 1994
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 5 (4) , 199-202
Electrical, spectral and thermochromic properties of some hydrazone derivatives
- 1 August 1994
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 5 (4) , 199-202
Electrical, spectral and thermochromic properties of some hydrazone derivatives