MDMegha A. Deshmukh

Megha A. Deshmukh

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Megha A. Deshmukh has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Oxygen Evolution Electrocatalysts with Trinuclear, Mixed‐Valence Iron Motifs on Electronically Aligned Carbon Dots

    by Megha A. Deshmukh, Giorgio Zoppellaro, Emiliano Fonda, Lukáš Zdražil, Shounik Paul, David Panáček, Hanuman Thorat, Zdeněk Badura, Michele Melchionna, Manuela Bevilacqua, et al.

    The oxygen evolution reaction (OER), a bottleneck for water electrolysis, remains limited by the adsorbate scaling relations and sluggish interfacial electron transfer (IET). We address these challenges by anchoring mixed‐valence Fe 3+ /Fe 2+ motifs on aspartic‐acid–derived carbon dots (AspCDs). Spectroscopic analyses support trinuclear Fe 3 sites, which offer redox flexibility and proximal active centers. The Fe 3 site binds the substrate (OH − ) and is electronically coupled to the AspCD scaffold. Together with the work function‐aligned scaffold for electron abstraction from OH − , these features establish effective inner‐sphere IET from OH − , through the active Fe 3 center and the AspCDs host to the electrode. Simultaneously, the mixed valency buffers the charge build‐up during the successive proton‐coupled electron transfers. The catalyst drives fast and selective O 2 generation and minimizes H 2 O 2 formation, while sustaining at least ∼70 h of continuous operation with a gradual ∼90 mV total potential increase. Thus, the Fe 3 /AspCDs catalyst requires only 110 mV overpotential at 10 mA cm −2 , shows particularly effective kinetics with a low Tafel slope of 41 mV dec −1 , and has a turnover frequency of 2.1 s −1 . The design integrates crucial physicochemical properties for highly efficient OER, and the principle can be generalized to other systems toward further advances in the field.


  • Chemiresistive sensor based on polythiophene-modified single-walled carbon nanotubes for detection ofNO2

    by Sumedh Gaikwad, Gajanan Bodkhe, Megha Deshmukh, Harshada Patil, Arti Rushi, Mahendra D. Shirsat, Pankaj Koinkar, Yun-Hae Kim, Ashok Mulchandani

    In the present investigation, a chemiresistive sensor based on conducting polythiophene-modified single-walled carbon nanotubes (SWNTs) for NO2detection has been reported. The SWNTs were aligned across 3 μm gap between two gold microelectrodes on Si / SiO2substrate. Alignment of SWNTs was carried out by using AC dielectrophoretic technique and it was confirmed by current–voltage (I–V) measurement. Aligned SWNTs were modified by conducting polythiophene using charge controlled potentiostatic deposition and it was confirmed by field-effect transistor (FET) and electrochemical measurements. Polythiophene-modified SWNT devices were used for the NO2detection in chemiresistive modality. This sensor exhibited very good linear response range from 10 ppb to 10 ppm.