RSRenaldo Springer

Renaldo Springer

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Renaldo Springer has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Asymmetric Degradation via Chromium Poisoning in Solid Oxide Cells under Fuel Cell and Electrolysis Operation Modes

    by Doyeub Kim, Long Q. Le, Julian Escobar, Renaldo Springer, Lorraine Seymour, Christopher Coyle, Seraphim V. Belko, Michael Fuller, Tian Liu, Olga A. Marina, et al.

    Chromium (Cr) poisoning from metallic interconnects (ICs) is widely regarded as a critical degradation pathway in solid oxide cells (SOCs). This study systematically investigates the operational-mode-dependent Cr migration-comparing fuel cell mode (solid oxide fuel cells, SOFCs) vs. electrolysis mode (solid oxide electrolysis cells, SOECs)-from button cells to a scaled-up, large-area configuration. In button cell tests (~1,500 h), SOFC mode showed severe degradation, with an area-specific resistance (ASR) increase of ~180%, driven by deep inward Cr diffusion, Sr-Cr co-segregation, and precipitation of resistive secondary phases extending down to the barrier layer interface. Under both SOEC modes (50% and 90% steam), Cr-induced degradation was negligible, with ASR degradation rates of uncoated IC cells closely matching those of reference cells at each steam content (within ~1% and ~6%, respectively). Further, a scaled-up cell with an uncoated interconnect operated stably under SOEC mode for ~1,000 h, and post-mortem analysis along the flow path confirmed that Cr penetration into the electrode bulk remained predominantly suppressed across the entire active area, with only modest spatial variation toward the outlet. This asymmetry is proposed to arise from a coupled physical and electrochemical mechanism: the continuous outward O₂ flux generated during oxygen evolution reaction (OER) acts as a convective barrier against incoming Cr species, while anodic operation concurrently suppresses electrochemical Cr deposition at active boundaries. These findings broaden material selection tolerances and relax coating requirements for electrolysis-dominated stack configurations.

  • Open Access

    Durability of SOECs under Operation Modes: Impact of Nickel Oxide in Hydrogen Functional Electrodes

    by Doyeub Kim, Tian Liu, Sangbong Ryu, Lorraine Seymour, Renaldo Springer, Olga A. Marina, John S. Hardy, Kerry Meinhardt

    This study investigates the long-term durability of solid oxide electrolysis cells (SOECs) with a focus on how commercially sourced nickel oxide (NiO) precursors affect the stability of Ni–YSZ hydrogen functional electrodes. Cells fabricated using different commercial NiO powders were operated for 1500 h under both potentiostatic and galvanostatic conditions. Initial electrochemical performance and long-term durability were both found to vary with the NiO precursors and the operating mode. Electrochemical impedance spectroscopy coupled with distribution of relaxation time analysis showed that degradation evolves through coupled contributions from charge-transfer-related polarization and interfacial integrity. Post-mortem microstructural characterization revealed dark intragranular features in all cells; however, their prevalence varied among cells derived from nickel oxides obtained from different commercial sources. Under potentiostatic operation, degradation was dominated by Ni coarsening/agglomeration with limited interfacial damage, whereas galvanostatic operation more clearly exposed interfacial vulnerability, evidenced by delamination at the hydrogen functional electrode/YSZ interface. Elemental mapping showed localized Si- and Mg-rich oxides near active regions without evidence of continuous insulating-layer growth within the investigated timeframe under both operation modes. The findings indicate that tailoring the chemical and microstructural characteristics of NiO precursors provides a viable route to enhance long-term SOEC durability.

  • An All-Aqueous Thermally Regenerative Ammonia Battery Chemistry Using Cu(I, II) Redox Reactions

    by Renaldo Springer, Nicholas R. Cross, Serguei N. Lvov, Bruce E. Logan, Christopher A. Gorski, Derek M. Hall

    Thermally regenerative ammonia batteries (TRABs) are electrochemical energy conversion devices that convert low-grade waste heat into electrical power. To date, reported TRABs have suffered from poor performance due to their reliance on dissolution and deposition redox reactions with transition metals. Here we present a new TRAB chemistry that uses ligands to stabilize aqueous Cu(I) and Cu(II) ions, thereby creating the first reported all-aqueous TRAB. Rotating disc electrode studies were conducted to evaluate thermodynamic and kinetic parameters of prospective anolyte and catholyte chemistries. The use of NH 3 (aq) and Br − (aq) ligands resulted in a cell potential difference of 695 ± 2 mV with rate constants of 101 ± 5 μ m s −1 and 819 ± 236 μ m s −1 , respectively. Single-cell tests achieved power densities up to 350 W m −2 which are the highest reported for single metal TRABs at 25 °C. Coulombic efficiencies exceeded 90% and their energy storage densities were two to four times of those reported for alternative TRAB chemistries.


  • SOI wafer flow process for stencil mask fabrication

    by J. Butschke, A. Ehrmann, B. Höfflinger, M. Irmscher, R. Käsmaier, F. Letzkus, H. Löschner, J. Mathuni, C. Reuter, C. Schomburg, et al.