Miguel García-Rollán
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Miguel García-Rollán has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Juana Maria Rosas
Departamento de Ingenierí́a Química, Universidad de Málaga, Andalucia Tech, Campus de Teatinos s/n, 29010 Málaga, Spain
4 shared publications - Jorge Bedia
Chemical Engineering Department, Universidad Autónoma de Madrid, Campus Cantoblanco, E-28049 Madrid, Spain
3 shared publications T. Cordero
3 shared publications- Carolina Belver
Chemical Engineering Department, Universidad Autónoma de Madrid, Campus Cantoblanco, E-28049 Madrid, Spain
2 shared publications J. Rodríguez-Mirasol
2 shared publicationsJosé Rodríguez-Mirasol
2 shared publications
Latest Publications
- Open Access
Cotton-Supported UiO-66-NH2 Photocatalyst for Efficient Solar Degradation of Acetaminophen
Emerging pharmaceutical pollutants such as acetaminophen (ACE) pose health and environmental risks. Solar photocatalysis provides a sustainable and efficient treatment option. In this study, UiO-66-NH2 metal–organic framework was immobilized on cotton fabrics to enable their application in both batch and continuous flow systems. Cotton, a biodegradable and low-cost support, was first functionalized by two strategies: hydroxylation (-OH) and carboxylation (-COOH), to promote MOF anchoring. Cotton fabric functionalization and MOF growth were confirmed by ATR and X-ray diffraction, while SEM and EDX analyses revealed that carboxylated fibers achieved higher MOF loading. Photocatalytic experiments under simulated solar irradiation demonstrated significantly higher degradation of acetaminophen when the carboxylated cotton fabric-based catalyst (F-COOH-UiO-66-NH2) was used. Mott–Schottky analysis and band alignment revealed that, under the applied reaction conditions, hydroxyl radical generation was not favored due to the position of the valence band. Studies with scavengers identified the superoxide radical as the dominant oxidative agent responsible for the photodegradation process. In particular, the F-COOH-UiO-66-NH2 system demonstrated its suitability for application in continuous flow systems, achieving acetaminophen conversion of up to 50% under simulated solar irradiation. This confirms its potential for scalable application in practical water treatment technologies. These results reinforce the feasibility of immobilizing MOF-based photocatalysts on functionalized textile waste, offering a dual-purpose solution that combines the removal of pharmaceutical pollutants with the valorization of waste materials. The synergistic integration of high photocatalytic efficiency, sunlight harvesting and recyclability of the materials underlines the eco-friendly and cost-effective nature of the proposed strategy.
Open AccessCotton-Supported UiO-66-NH2 Photocatalyst for Efficient Solar Degradation of Acetaminophen
Emerging pharmaceutical pollutants such as acetaminophen (ACE) pose health and environmental risks. Solar photocatalysis provides a sustainable and efficient treatment option. In this study, UiO-66-NH2 metal–organic framework was immobilized on cotton fabrics to enable their application in both batch and continuous flow systems. Cotton, a biodegradable and low-cost support, was first functionalized by two strategies: hydroxylation (-OH) and carboxylation (-COOH), to promote MOF anchoring. Cotton fabric functionalization and MOF growth were confirmed by ATR and X-ray diffraction, while SEM and EDX analyses revealed that carboxylated fibers achieved higher MOF loading. Photocatalytic experiments under simulated solar irradiation demonstrated significantly higher degradation of acetaminophen when the carboxylated cotton fabric-based catalyst (F-COOH-UiO-66-NH2) was used. Mott–Schottky analysis and band alignment revealed that, under the applied reaction conditions, hydroxyl radical generation was not favored due to the position of the valence band. Studies with scavengers identified the superoxide radical as the dominant oxidative agent responsible for the photodegradation process. In particular, the F-COOH-UiO-66-NH2 system demonstrated its suitability for application in continuous flow systems, achieving acetaminophen conversion of up to 50% under simulated solar irradiation. This confirms its potential for scalable application in practical water treatment technologies. These results reinforce the feasibility of immobilizing MOF-based photocatalysts on functionalized textile waste, offering a dual-purpose solution that combines the removal of pharmaceutical pollutants with the valorization of waste materials. The synergistic integration of high photocatalytic efficiency, sunlight harvesting and recyclability of the materials underlines the eco-friendly and cost-effective nature of the proposed strategy.
- Open Access
- 6 August 2025
- Published by Elsevier in Carbohydrate Polymer Technologies and Applications
- Vol. 11
Cellulose and xylan nanofiber mats via electrospinning: Lignin-enhanced properties in wood-inspired biocomposites
- 6 August 2025
- Published by Elsevier in Carbohydrate Polymer Technologies and Applications
- Vol. 11
Open AccessCellulose and xylan nanofiber mats via electrospinning: Lignin-enhanced properties in wood-inspired biocomposites
- Top Cited PapersOpen Access
- 22 April 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 383, 125394
Key adsorbents and influencing factors in the adsorption of micro- and nanoplastics: A review
- 22 April 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 383, 125394
Top Cited PapersOpen AccessKey adsorbents and influencing factors in the adsorption of micro- and nanoplastics: A review
- Open Access
- 21 December 2024
- Published by Elsevier in Biomass and Bioenergy
- Vol. 193
Oxidative electrochemical depolymerization of lignin using highly active self-standing electrocatalysts prepared by electrospinning of lignin
- 21 December 2024
- Published by Elsevier in Biomass and Bioenergy
- Vol. 193
Open AccessOxidative electrochemical depolymerization of lignin using highly active self-standing electrocatalysts prepared by electrospinning of lignin
- Open Access
- 14 December 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 503
Photodegradation of acetaminophen on titania fibers prepared by electrospinning
- 14 December 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 503
Open AccessPhotodegradation of acetaminophen on titania fibers prepared by electrospinning
- Open Access
- 4 April 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (8) , 7018-7032
Biobased Vanillin Production by Oxidative Depolymerization of Kraft Lignin on a Nitrogen- and Phosphorus-Functionalized Activated Carbon Catalyst
- 4 April 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (8) , 7018-7032
Open AccessBiobased Vanillin Production by Oxidative Depolymerization of Kraft Lignin on a Nitrogen- and Phosphorus-Functionalized Activated Carbon Catalyst
- Open Access
- 24 April 2023
- Published by Elsevier in SSRN Electronic Journal
Bio-Based Vanillin Production by Oxidative Depolymerization of Kraft Lignin on a Nitrogen and Phosphorus Functionalized Activated Carbon Catalyst
In the context of an integral biorefinery concept, the sustainable production of vanillin from oxidative depolymerization of lignin has been studied, using also lignin as raw material for catalysts preparation. Specifically, vanillin was produced from Kraft lignin using heterogeneous catalysts based on activated carbons prepared by chemical activation of sodium lignosulfonate with H3PO4. A novel redox catalytic system, which allows the heterogenization of the nitrobenzene group, was proposed. A copper catalyst was also prepared for comparison purposes. The experiments were performed in a batch reactor, under alkaline conditions, using initial PO2 of 2.5-10 bar and temperatures of 125-200 ºC. The highest vanillin yield was obtained at 200 ºC and 10 bar for the proposed catalyst, being this amount, the maximum yield obtainable from that technical lignin. This vanillin yield was 30% higher than that obtained without heterogeneous catalyst. The catalyst was successfully reused, without any regeneration treatment, evidencing no signs of deactivation. The possibility of transferring oxygen from oxidized P groups to reduced N groups in a redox cycle seems to be responsible for this sustained catalytic activity. To promote zero waste production, the obtained residual lignin was used to prepare an activated carbon, with ABET ⁓1000 m2/g.
- 24 April 2023
- Published by Elsevier in SSRN Electronic Journal
Open AccessBio-Based Vanillin Production by Oxidative Depolymerization of Kraft Lignin on a Nitrogen and Phosphorus Functionalized Activated Carbon Catalyst
In the context of an integral biorefinery concept, the sustainable production of vanillin from oxidative depolymerization of lignin has been studied, using also lignin as raw material for catalysts preparation. Specifically, vanillin was produced from Kraft lignin using heterogeneous catalysts based on activated carbons prepared by chemical activation of sodium lignosulfonate with H3PO4. A novel redox catalytic system, which allows the heterogenization of the nitrobenzene group, was proposed. A copper catalyst was also prepared for comparison purposes. The experiments were performed in a batch reactor, under alkaline conditions, using initial PO2 of 2.5-10 bar and temperatures of 125-200 ºC. The highest vanillin yield was obtained at 200 ºC and 10 bar for the proposed catalyst, being this amount, the maximum yield obtainable from that technical lignin. This vanillin yield was 30% higher than that obtained without heterogeneous catalyst. The catalyst was successfully reused, without any regeneration treatment, evidencing no signs of deactivation. The possibility of transferring oxygen from oxidized P groups to reduced N groups in a redox cycle seems to be responsible for this sustained catalytic activity. To promote zero waste production, the obtained residual lignin was used to prepare an activated carbon, with ABET ⁓1000 m2/g.
- Open Access
- 26 November 2022
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 11 (1)
MgO-containing porous carbon spheres derived from magnesium lignosulfonate as sustainable basic catalysts
- 26 November 2022
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 11 (1)
Open AccessMgO-containing porous carbon spheres derived from magnesium lignosulfonate as sustainable basic catalysts
- 5 September 2022
- Published by Elsevier in Bioresource Technology Reports
- Vol. 19
Pyrolysis of pistachio shell, orange peel and saffron petals for bioenergy production
- 5 September 2022
- Published by Elsevier in Bioresource Technology Reports
- Vol. 19
Pyrolysis of pistachio shell, orange peel and saffron petals for bioenergy production
- Open Access
- 31 August 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (21) , 17225-17240
Deactivation of a Biomass-Derived Zirconium-Doped Phosphorus-Containing Carbon Catalyst in the Production of Dimethyl Ether from Methanol Dehydration
- 31 August 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (21) , 17225-17240
Open AccessDeactivation of a Biomass-Derived Zirconium-Doped Phosphorus-Containing Carbon Catalyst in the Production of Dimethyl Ether from Methanol Dehydration