Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jakub Zajicek has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The Influence of Lubricant and Sheet Thickness of 1.4376 During Deep Drawing

    by Martin Ovsik, Jakub Zajicek, Ondrej Stalmach, Michal Stanek

    This work is concerned with the influence of lubricant, sheet thickness, position of production during sheet metal forming (deep drawing) on mechanical properties. The deep drawing process was carried out on a BUP-600 instrument using the Erichsen method, which uses a 20 mm diameter ball draw bar. The individual forming tests were carried out on 1.4376 plate with thicknesses of 1.5 mm and 1 mm. The drawing of the sheets was carried out with and without lubricant to assess the effect of the lubricant on the resulting properties. The actual forming results of the plates were verified by FEM analysis in AutoForm software, which pointed out the critical areas on the part. These specified locations were further subjected to mechanical property measurements. As shown in this work, the areas of sheet metal forming showed significant strengthening, which was reflected by an increase in mechanical properties at each location. The difference in mechanical properties between the unformed area of the sheet metal and the area on the sheet metal that was formed by deep drawing was up to 63% (Vickers hardness, indentation modulus). The lubricant had a significant impact on the drawing process; when applied, both the drawing distance and the force increased by approximately 25%. This can result in additional cracking of the sheet metal parts. This research has significant implications for the deep drawing of sheet metal in practice, pointing out the issue of critical points that need to be further accounted for and possibly eliminated or at least minimized. Plastic deformation occurring during deep drawing leads to an increase in material hardness and tensile strength. As a result, the formed parts achieve improved stiffness and load-bearing capability. The study contributes to a better understanding of how strain hardening can be maximized in critical regions of the drawn part without inducing fracture. Furthermore, the research describes the influence of sheet thickness variation during the drawing process, which is essential for maintaining the structural integrity of the component. The study further emphasizes the significance of lubrication and friction conditions in reducing the forces required for drawing, thereby preventing crack initiation and surface defects on the drawpiece.

  • Open Access

    Effect of Cutting Conditions on Roughness and Cutting Force When Machining a Freeform Surface with Barrel Tools

    by Martin Reznicek, Cyril Horava, Jakub Zajicek, Martin Ovsik

    Barrel tools are relatively new tools that use atypical geometries to achieve shorter production times and improve surface quality. They have been increasingly used in the finishing operations industry, where they are gaining more and more popularity. For their optimal use, it is necessary to know how these tools behave during work in terms of how they load the machined product and what surface qualities they can achieve. For this reason, this study was conducted to compare two tools when machining a free surface. The obtained surface quality and the force load caused by the tool were evaluated. It was found that barrel tool machining results in a heterogeneous surface caused by different cutting speeds along the length of the tool and that the two obtained regions show differences in the obtained roughness. Even though the operation was classified as a finishing process, a difference of up to 30% was identified in the cutting forces acting on the tool and the workpiece.