Yeldos Nugumarov
Research Subjects
Research Interests
Yeldos Nugumarov has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Aliya R. Togasheva
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
3 shared publications - Akshyryn Zholbasarova
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
2 shared publications - Danabek Saduakassov
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
2 shared publications - Nurzhaina Nurlybai
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
2 shared publications - Ryskol Bayamirova
Department of Geology and Petrochemical Engineering, Yessenov University, Aktau 130000, Kazakhstan
2 shared publications - A.T. Zholbasarova
Yessenov University
1 shared publication
Latest Publications
- 25 June 2026
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- Vol. 153 (3) , 119-131
Paraffin formation in the reservoir oil of the Uzen deposit
The paper presents the results of a study of the conditions of formation of asphalt-resin-paraffin deposits (AFS) in the reservoir oil of the Uzen deposit using the example of the Yu-13 horizon. The studies were performed using PVT analysis with an acoustic resonance system (ARS), as well as the "cold rod" method. The temperature ranges of the onset of crystallization of paraffins, the formation of zones of mass crystallization and complete solidification of oil have been established. It is shown that the temperature of the beginning of crystallization of paraffins is comparable to the current reservoir temperature, which causes a high probability of precipitation of the solid phase in the reservoir and the bottomhole zone. It is revealed that the determining factor of paraffin formation is the temperature regime, while the influence of dissolved gas is of secondary importance. The results obtained can be used to substantiate technological solutions to prevent and reduce the intensity of AFS at the Uzen field.
- 25 June 2026
- Published by Oil Research and Engineering Center of the National Engineering Academy of the Republic of Kazakhstan in Neft i Gaz
- Vol. 153 (3) , 119-131
Paraffin formation in the reservoir oil of the Uzen deposit
The paper presents the results of a study of the conditions of formation of asphalt-resin-paraffin deposits (AFS) in the reservoir oil of the Uzen deposit using the example of the Yu-13 horizon. The studies were performed using PVT analysis with an acoustic resonance system (ARS), as well as the "cold rod" method. The temperature ranges of the onset of crystallization of paraffins, the formation of zones of mass crystallization and complete solidification of oil have been established. It is shown that the temperature of the beginning of crystallization of paraffins is comparable to the current reservoir temperature, which causes a high probability of precipitation of the solid phase in the reservoir and the bottomhole zone. It is revealed that the determining factor of paraffin formation is the temperature regime, while the influence of dissolved gas is of secondary importance. The results obtained can be used to substantiate technological solutions to prevent and reduce the intensity of AFS at the Uzen field.
- Open Access
Risk Assessment of Asphaltene–Resin–Paraffin Deposition During Reservoir Cooling in the XIII Horizon of the Uzen Oil Field
This study presents a risk assessment of asphaltene–resin–paraffin deposition (ARPD) in the producing formations of the XIII reservoir unit of the Uzen oil field at a late stage of development. The crude oil is characterized by an extremely high paraffin (wax) content of up to 29 wt.%. Long-term operation of the reservoir pressure maintenance (RPM) system with cold water injection has resulted in significant reservoir cooling, with temperatures declining from the initial 60–65 °C to 20–30 °C in zones of intensive waterflooding. To refine the critical phase transition temperatures of paraffin components, a dynamic laboratory approach was applied using a Wax Flow Loop system, which simulates wax deposition processes under flowing conditions. The results indicate that the wax appearance temperature (WAT) ranges from 41.0 to 44.0 °C, significantly exceeding the current bottomhole temperatures in the cooled zones of the reservoir. Intensive bulk crystallization of paraffins occurs within the temperature interval of 33.5–35.0 °C, while loss of oil flowability is observed at 25–34 °C, corresponding to the gelation and structural network formation of wax crystals under reduced thermal conditions. The obtained results confirm the inevitability of bulk oil structuring and solid wax phase precipitation directly within the reservoir porous medium. This process leads to blockage of low-permeability interlayers, deterioration of filtration properties, and a reduction in the displacement efficiency factor by 20–35%. Under the current thermal regime, ARPD should therefore be considered not merely as an operational flow assurance issue, but as a systemic factor limiting reservoir development efficiency. The research results substantiate the need to transition from reactive ARPD removal methods to proactive management of the thermal regime of the reservoir and wells, as well as to the differentiated application of thermal and chemical treatment methods.
Open AccessRisk Assessment of Asphaltene–Resin–Paraffin Deposition During Reservoir Cooling in the XIII Horizon of the Uzen Oil Field
This study presents a risk assessment of asphaltene–resin–paraffin deposition (ARPD) in the producing formations of the XIII reservoir unit of the Uzen oil field at a late stage of development. The crude oil is characterized by an extremely high paraffin (wax) content of up to 29 wt.%. Long-term operation of the reservoir pressure maintenance (RPM) system with cold water injection has resulted in significant reservoir cooling, with temperatures declining from the initial 60–65 °C to 20–30 °C in zones of intensive waterflooding. To refine the critical phase transition temperatures of paraffin components, a dynamic laboratory approach was applied using a Wax Flow Loop system, which simulates wax deposition processes under flowing conditions. The results indicate that the wax appearance temperature (WAT) ranges from 41.0 to 44.0 °C, significantly exceeding the current bottomhole temperatures in the cooled zones of the reservoir. Intensive bulk crystallization of paraffins occurs within the temperature interval of 33.5–35.0 °C, while loss of oil flowability is observed at 25–34 °C, corresponding to the gelation and structural network formation of wax crystals under reduced thermal conditions. The obtained results confirm the inevitability of bulk oil structuring and solid wax phase precipitation directly within the reservoir porous medium. This process leads to blockage of low-permeability interlayers, deterioration of filtration properties, and a reduction in the displacement efficiency factor by 20–35%. Under the current thermal regime, ARPD should therefore be considered not merely as an operational flow assurance issue, but as a systemic factor limiting reservoir development efficiency. The research results substantiate the need to transition from reactive ARPD removal methods to proactive management of the thermal regime of the reservoir and wells, as well as to the differentiated application of thermal and chemical treatment methods.
- Open Access
Comparative Analysis of Methods for Determining the Wax Crystallization Onset Temperature of High-Paraffin Crude Oil from the Uzen Field
This study is devoted to a comparative analysis of modern methods for determining the wax crystallization onset temperature (WCOT) of high-paraffin crude oil from the Uzen field. The objects of investigation were crude oil samples from the 13th reservoir horizon with a paraffin mass content ranging from 22.5% to 27.5%. For the first time in the practice of the oil and gas industry of Kazakhstan, a comprehensive comparison of results obtained using two fundamentally different approaches was performed: the light transmittance method using the KING-UNNP-70 apparatus, which simulates reservoir conditions (pressure of 12 MPa), and a dynamic method using a Wax Flow Loop facility, which reproduces crude oil flow in a pipeline. The experimental results showed that the light transmittance method detects the appearance of the first microcrystals at temperatures of 38.0–41.7 °C, whereas the dynamic method yields higher WCOT values, ranging from 41.0 °C to 44.0 °C. It was also found that the temperature of bulk crystallization, characterizing intensive solid phase formation, lies within the range of 33.5–35.0 °C. The results confirm that under flow conditions, paraffin crystallization begins at higher temperatures compared to static conditions, which is of critical importance for the design of crude oil gathering and transportation systems. The obtained data allow more accurate prediction of the risks of asphaltene–resin–paraffin deposits (ARPD) formation and optimization of technological operating conditions of wells at the late stage of field development.
Open AccessComparative Analysis of Methods for Determining the Wax Crystallization Onset Temperature of High-Paraffin Crude Oil from the Uzen Field
This study is devoted to a comparative analysis of modern methods for determining the wax crystallization onset temperature (WCOT) of high-paraffin crude oil from the Uzen field. The objects of investigation were crude oil samples from the 13th reservoir horizon with a paraffin mass content ranging from 22.5% to 27.5%. For the first time in the practice of the oil and gas industry of Kazakhstan, a comprehensive comparison of results obtained using two fundamentally different approaches was performed: the light transmittance method using the KING-UNNP-70 apparatus, which simulates reservoir conditions (pressure of 12 MPa), and a dynamic method using a Wax Flow Loop facility, which reproduces crude oil flow in a pipeline. The experimental results showed that the light transmittance method detects the appearance of the first microcrystals at temperatures of 38.0–41.7 °C, whereas the dynamic method yields higher WCOT values, ranging from 41.0 °C to 44.0 °C. It was also found that the temperature of bulk crystallization, characterizing intensive solid phase formation, lies within the range of 33.5–35.0 °C. The results confirm that under flow conditions, paraffin crystallization begins at higher temperatures compared to static conditions, which is of critical importance for the design of crude oil gathering and transportation systems. The obtained data allow more accurate prediction of the risks of asphaltene–resin–paraffin deposits (ARPD) formation and optimization of technological operating conditions of wells at the late stage of field development.