ZLZhenlin Li

Zhenlin Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Zhenlin Li has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Single-Layer Wideband CP Filtering Reflectarray With Wide Out-of-Band Rejection via Intrinsic Orthogonality of CMs

    by Ming Fu, Xinhuai Wang, Zhenlin Li, Ying Mei, Yin Li, Yin Xu, Xiaowei Shi, Lei Zhu

    This article proposes a novel design method for a circularly polarized filtering reflectarray (CPFRA). The method first exploits the inherent orthogonality of characteristic modes (CMs) to convert circularly polarized (CP) reflection responses into the modal characteristic angle difference ( $\Delta $ CA) of the reflecting cell. The $\Delta $ CA is then correlated with the modal resonance frequency difference ( $\Delta f_{\mathrm {res}}$ ), which can be effectively tuned via characteristic mode analysis (CMA). With the aid of CMA, multiple appropriate $\Delta f_{\mathrm {res}}$ are obtained to synthesize the desired CP filtering reflection response. For next-generation low-Earth orbit (LEO) satellite applications (e.g., Starlink), three design strategies for the wideband CPFRA with wide out-of-band rejection are further formulated using the proposed method and applied to a single-layer right-triangular patch reflectarray (RA) cell. By adjusting the locations of six grounded vias loaded near the three edges of the cell, multiple modal current path lengths are modified to obtain the target $\Delta f_{\mathrm {res}}$ . Ultimately, the fabricated RA exhibits a 3-dB gain bandwidth of 28.86% and a 3-dB axial ratio (AR) bandwidth of 32% in the passband, along with 15-dB rejection bandwidths of 37.92% and 33.84% in the lower and upper stopbands, respectively. These results validate the effectiveness and feasibility of the proposed design method and strategies.


  • A Single-Layer Wide-Beam Patch Antenna for Ku-Band Wide-Angle Scanning Phased Arrays

    by Ming Fu, Fulin Xue, Zhenlin Li, Xinhuai Wang, Yin Li, Yin Xu, Xiaowei Shi

    This letter presents a single-layer, wide-beam patch antenna for Ku-band wide-angle scanning phased arrays. The antenna is based on a U-slot patch and is designed using characteristic mode analysis (CMA). By sequentially loading inverted-L stubs, grounded vias that connect U-shaped strips, and open U-shaped strips on the U-slot patch, the antenna size is reduced, complementary endfire beams are introduced, and endfire radiation is enhanced, respectively, thereby enabling multiple wide-beam characteristic modes. Then, these modes are simultaneously excited at the optimized location to synthesize a hemispherical E-plane pattern. As a critical component of the proposed antenna, the grounded vias that connect the U-shaped strips are configured as two parallel equivalent inverted-F antenna (IFA) structures, enabling resonance on a low-profile single-layer substrate to produce endfire radiation for expanding beamwidth. The fabricated antenna exhibits an E-plane half-power beamwidth (HPBW) of up to 181°. Its 1×8 linear phased array prototype with defected ground structure (DGS) exhibits mutual coupling below –16.8 dB, a scanning range of ±76° for a 3‑dB gain reduction, and a sidelobe level (SLL) below –8.2 dB across the band. These results indicate the antenna's potential as a terminal in satellite-communications applications such as unmanned aerial vehicle terminals and low earth orbit (LEO) satellite constellations after further optimization.


  • Reconfigurable Dual-Band Circularly Polarized Reflectarray With Small Frequency Ratio Incorporating Precoding Technology

    by Fulin Xue, Ming Fu, Zhenlin Li, Guangyin Feng, Hao Chen, Yin Li

    This communication proposes a dual-band circularly polarized (CP) reflectarray design scheme based on precoding technology. Compared with traditional co - aperture arrays, this design allocates two circularly polarized elements to different frequency channels at 23 GHz and 26 GHz, respectively. This enables independent manipulation of dual-band beams, with the higher and lower bands boasting a mere frequency ratio of 1.13. By introducing the element sequential rotation technology and 1-bit active coding, the axial ratio (AR) bandwidth of the array is effectively improved, and the beam scanning ability is realized. To validate its performance, a 10 × 10 reflectarray prototype was simulated and fabricated. Experimental results demonstrate that the array achieves a beam scanning range of ±30° in the two-dimensional (2D) plane. At the 0° direction, the peak gains for the 23 GHz right-hand circularly polarized (RHCP) and 26 GHz left-hand circularly polarized (LHCP) beams are 18.12 dBic and 18.35 dBic, respectively. The 3-dB gain bandwidths are 7.8% (22.3 to 24.1 GHz) and 7% (25.0 to 26.8 GHz), while the 3-dB axial ratio bandwidths are 7.05% (22.15 to 23.77 GHz) and 5.85% (25.04 to 26.55 GHz). The aperture efficiencies are 13% @ 23 GHz and 10.85% @ 26 GHz, respectively.


  • A Folded Fabry–Perot Antenna With Low Profile

    by Ming Fu, Zhenlin Li, Xinhuai Wang, Yin Xu, Yin Li, Xiaowei Shi

    This letter proposes a novel folded Fabry-Perot antenna (FFPA) architecture for profile reduction. The architecture uniquely combines an orthogonally polarized conversion reflective surface (OPCRS) at the bottom layer with a polarization-selective partially reflective surface (PSPRS) at the top layer, creating two additional transmission paths to reduce profile height while adding two adjustable reflection phase parameters. Unlike most existing low-profile Fabry-Perot antennas (FPAs), which rely on either a partially reflective surface (PRS) or a ground with specific low-reflection phase characteristics and thus face significant design complexity, the proposed FFPA eliminates these constraints and simplifies the design process. Theoretical derivations confirm that FFPAs achieve high gain with a lower profile than conventional Fabry-Perots (CFPAs) under identical PSPRS conditions, regardless of the reflection phase characteristics of the PSPRS or OPCRS. A prototype FFPA exhibits a 16.9-dBi gain comparable to that of CFPA at 73.24% (0.3755λ) of the CFPA's profile. Moreover, leveraging the OPCRS's negative reflection phase, it also achieves a 12.1-dBi gain at a mere 17.86% (0.0915λ) of the CFPA's profile. These results validate the FFPA's low-profile characteristics and design flexibility, highlighting its significant potential for multifunctional, low-profile FPA applications.