Katariina Kylämäki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Katariina Kylämäki has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Hannu Kuutti
VTT Technical Research Centre of Finland Ltd, 02150 Espoo, Finland
4 shared publications- Henna Lintusaari
Aerosol Physics Laboratory, Physics Unit, Tampere University, 33014 Tampere, Finland
4 shared publications - Hilkka Timonen
Atmospheric Composition Research, Finnish Meteorological Institute, Helsinki, Finland
4 shared publications - Laura Salo
Aerosol Physics Laboratory, Physics Unit, Faculty of Engineering and Natural Sciences, Tampere University, Tampere, Finland
4 shared publications - Leïla Simon
Paul Scherrer Institute (Villigen, Switzerland)
4 shared publications - Matti Rissanen
Aerosol Physics Laboratory, Physics Unit, Tampere University, Tampere, Finland
4 shared publications
Latest Publications
- Open Access
- 20 July 2026
- Published by Copernicus GmbH
- Vol. 2026, 1-25
Comment on egusphere-2026-224
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- 20 July 2026
- Published by Copernicus GmbH
- Vol. 2026, 1-25
Open AccessComment on egusphere-2026-224
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- Open Access
- 24 March 2026
- Published by Copernicus GmbH
- Vol. 2026, 1-25
Comment on egusphere-2026-224
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- 24 March 2026
- Published by Copernicus GmbH
- Vol. 2026, 1-25
Open AccessComment on egusphere-2026-224
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- Open Access
- 5 March 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-25
Comparison of two oxidation flow reactors for measuring aged aerosol from passenger car exhaust
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- 5 March 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-25
Open AccessComparison of two oxidation flow reactors for measuring aged aerosol from passenger car exhaust
Oxidation flow reactors (OFRs) are a practical way to assess the secondary aerosol (SecA) mass formation potential of any gas mixture of interest in relatively short processing timescales. In this study, two OFRs were assembled in parallel and used to investigate the photochemical aging and formation of secondary aerosol from exhaust emissions of seven passenger cars. The potential aerosol mass OFR (PAM-OFR) and the Dekati OFR (DOFR) have differences in reactor volume, wall material, residence time and ultraviolet (UV) wavelengths, but the particle number and mass size distributions measured after them were comparable when averaged over the transient driving cycle. The average secondary particle mass emission factor (EF) for all 34 cycles was 22.90 mg km-1 for the PAM-OFR and 15.77 mg km-1 for the DOFR. The fuel and exhaust after-treatment technology affected the difference between the PAM-OFR and the DOFR EFs. With gasoline cars, fast bursts of SecA formation during cold start and highway driving were captured more clearly by the DOFR, which led to DOFR EFs exceeding PAM-OFR EFs. However, with modern diesel cars, the CNG car or hybrid cars that all produced low fresh PM emissions, the SecA mass EFs were higher from the PAM-OFR than from the DOFR. OH exposure did not cause the differences in emission factors between the OFRs, because the OH exposure range was small. Background SecA formation from the PAM-OFR was visible in the particle size distributions of the cleanest cars, which was corrected for in the EF calculations. On average, the PAM-OFR produced more background particle mass (9.10 μg m-3) than the DOFR (0.36 μg m-3).
- Open Access
- 5 March 2026
- Published by Copernicus GmbH
Supplementary material to "Comparison of two oxidation flow reactors for measuring aged aerosol from passenger car exhaust"
- 5 March 2026
- Published by Copernicus GmbH
Open AccessSupplementary material to "Comparison of two oxidation flow reactors for measuring aged aerosol from passenger car exhaust"