Baydaa K. Khudhair
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Baydaa K. Khudhair has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Ahmet Atak
Department of Industrial Design, Faculty of Architecture and Design, OSTIM Technical University, Ankara 06374, Turkey
1 shared publication - Haider Khazal
Mechanical Department, Engineering College, University of Basrah, Basrah 61004, Iraq
1 shared publication - Hassanein I. Khalaf
Mechanical Department, Engineering College, University of Basrah, Basrah 61004, Iraq
1 shared publication - Mahmood Alhafadhi
Department of Mechanical and Energetic, University of Dunaújváros, H-2400 Dunaújváros, Hungary
1 shared publication - Raheem Al-Sabur
Mechanical Department, Engineering College, University of Basrah, Basrah 61004, Iraq
1 shared publication
Latest Publications
- Open Access
- 21 March 2026
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 10 (3) , 109
Data-Driven Thermal Optimization of Drill Geometry in Titanium Machining: FEM Modeling and Experimental Insights
The current study offers a deeper understanding of the thermal behavior of AISI 420 stainless-steel drill bits during titanium alloy machining. It utilizes non-linear simulations with the finite element method (FEM) to analyze heat generation, accumulation, and dissipation. The FEM formulation displays the time-dependent temperatures for the tool and hole during the drilling process. The simulation was examined during drilling and subsequent stages, up to room temperature. The study explored a wide range of drill bit lengths (60–160 mm) and tool diameters (2–10 mm). Significant convergence of 4.1% was achieved when compared to infrared thermography data. Furthermore, increasing the tool length beyond 120 mm did not significantly increase the thermal effect. Moreover, increasing the tool diameter up to 10 mm also did not significantly increase the thermal efficiency compared to tool diameters between 2 and 5 mm based on a constant tool length. An exploratory data analysis (EDA) heatmap correlation matrix was used to examine the most efficient variables and the optimum tool geometry. The results obtained provide a clear understanding of the optimal geometry choice for steel drilling tools when used in drilling titanium alloys.
- 21 March 2026
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 10 (3) , 109
Open AccessData-Driven Thermal Optimization of Drill Geometry in Titanium Machining: FEM Modeling and Experimental Insights
The current study offers a deeper understanding of the thermal behavior of AISI 420 stainless-steel drill bits during titanium alloy machining. It utilizes non-linear simulations with the finite element method (FEM) to analyze heat generation, accumulation, and dissipation. The FEM formulation displays the time-dependent temperatures for the tool and hole during the drilling process. The simulation was examined during drilling and subsequent stages, up to room temperature. The study explored a wide range of drill bit lengths (60–160 mm) and tool diameters (2–10 mm). Significant convergence of 4.1% was achieved when compared to infrared thermography data. Furthermore, increasing the tool length beyond 120 mm did not significantly increase the thermal effect. Moreover, increasing the tool diameter up to 10 mm also did not significantly increase the thermal efficiency compared to tool diameters between 2 and 5 mm based on a constant tool length. An exploratory data analysis (EDA) heatmap correlation matrix was used to examine the most efficient variables and the optimum tool geometry. The results obtained provide a clear understanding of the optimal geometry choice for steel drilling tools when used in drilling titanium alloys.