Jiapeng Dai
Research Subjects
Jiapeng Dai has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Jin Qian
Shanghai Marine Diesel Engine Research Institute, Shanghai 201108, China
1 shared publication - Linye Yu
Shanghai Marine Diesel Engine Research Institute, Shanghai 201108, China
1 shared publication - Ming Zhong
School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
1 shared publication - Xu Liu
School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
1 shared publication - Yongan Min
Shanghai University
1 shared publication
Latest Publications
- Open Access
- 5 April 2026
- Published by MDPI AG in Lubricants
- Vol. 14 (4) , 157
Friction and Wear Behavior of Carburized Steels Against Ceramic Balls Under Starved Lubrication
Starved lubrication poses a critical challenge to hybrid ceramic bearings operating under severe conditions. This study investigates the tribological behavior of carburized 20CrMo steel sliding against Al2O3 ceramic balls and GCr15 steel balls under dry sliding, with oil-lubricated tests as a reference. Under oil lubrication, the 20CrMo/Al2O3 pair exhibits superior wear resistance, attributed to the high hardness of the ceramic counterpart. Under dry sliding, however, this pair shows a slightly lower friction coefficient but a wear rate approximately three times that of the 20CrMo/GCr15 pair. This counterintuitive behavior stems from two mechanisms: lower contact stress and friction-induced work hardening in the GCr15 pair, which together suppress wear. Further analysis reveals that secondary carbides in the carburized layer detach under repeated high shear stress, acting as hard third-body abrasives and accelerating surface damage. These findings highlight that hybrid ceramic bearings are more susceptible to lubrication failure than all-steel bearings. Under heavy loads and poor lubrication, residual compressive stress plays a key role in governing the tribological behavior of carbides on carburized surfaces.
- 5 April 2026
- Published by MDPI AG in Lubricants
- Vol. 14 (4) , 157
Open AccessFriction and Wear Behavior of Carburized Steels Against Ceramic Balls Under Starved Lubrication
Starved lubrication poses a critical challenge to hybrid ceramic bearings operating under severe conditions. This study investigates the tribological behavior of carburized 20CrMo steel sliding against Al2O3 ceramic balls and GCr15 steel balls under dry sliding, with oil-lubricated tests as a reference. Under oil lubrication, the 20CrMo/Al2O3 pair exhibits superior wear resistance, attributed to the high hardness of the ceramic counterpart. Under dry sliding, however, this pair shows a slightly lower friction coefficient but a wear rate approximately three times that of the 20CrMo/GCr15 pair. This counterintuitive behavior stems from two mechanisms: lower contact stress and friction-induced work hardening in the GCr15 pair, which together suppress wear. Further analysis reveals that secondary carbides in the carburized layer detach under repeated high shear stress, acting as hard third-body abrasives and accelerating surface damage. These findings highlight that hybrid ceramic bearings are more susceptible to lubrication failure than all-steel bearings. Under heavy loads and poor lubrication, residual compressive stress plays a key role in governing the tribological behavior of carbides on carburized surfaces.