BMBakhtiyor Mardonov

Bakhtiyor Mardonov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bakhtiyor Mardonov has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Multi-Scale Characterization of Industrial Steel Slags Using XRF and SEM–EDS Phase Mapping

    by Okhunjon Sayfidinov, Susheng Tan, Bakhtiyor Mardonov, Makhliyo Sayfidinova, Baibhaw Kumar

    Steel slags are major by-products of steelmaking, and their variable composition complicates recycling and valorization strategies. This study investigates four representative slag samples obtained from different production pathways at an industrial steel plant in Uzbekistan, using a combined multi-scale characterization approach. Bulk elemental composition was determined using X-ray fluorescence (XRF), while microstructural and phase-level analysis was carried out using scanning electron microscopy with energy-dispersive spectroscopy (SEM–EDS), including both point analysis and automated phase mapping. The XRF results revealed two distinct compositional groups, with one slag dominated by Mn–Si–O chemistry and three slags characterized by high Ca content. SEM–EDS phase mapping further resolved these differences at the microscale, identifying manganese silicate and oxide phases in the Mn-rich slag, Ca–F–O dominant phases in two slags associated with fluorite flux addition, and a more heterogeneous Ca-based system with localized enrichments of Mn, Zn, and Cu in the fourth sample. The combined results demonstrate that slag composition strongly reflects steel grade and fluxing practice. The integration of XRF and SEM–EDS provides a robust framework for linking bulk chemistry with phase distribution, improving slag classification and supporting informed decisions for reuse and environmental management.


  • Open Access

    Экспериментальное исследование твердости наплавленной поверхности при различных способах термофрикционного фрезерования

    by Е.б. Иманбаев, К.т. Шеров, Б.т. Мардонов, Л.н. Махмудов, М.т. Усербаев, И.с. Куанов

    The article presents the results of a study aimed at solving the problem of ensuring the hardness of the deposited surfaces after machining. The authors propose two methods of thermofriction milling as mechanical processing such as traditional thermofriction milling and thermofriction milling with pulsed cooling. To conduct experimental studies, the authors determined the planning of the experiment was carried out and the required number of experiments. For processing, special samples were prepared with a deposited layer of surfacing material, which is used in the production of Electric Locomotive Kurastyru Zauyty LLP (Nur-Sultan, Kazakhstan). The results of experimental studies have shown that both methods of thermofriction milling provide an increase in the hardness of the deposited surface. The article investigates the influence of milling modes on the hardness of the machined surface. The optimal values of milling modes have been established, which provide an increase in the initial hardness of the machined surface.