Dan Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dan Zhao has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Hao Chen
School of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin China
2 shared publications Wei Zhao
Faculty of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin Heilongjiang People's Republic of China
2 shared publications- Ji Ruixiang
Faculty of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin Heilongjiang People's Republic of China
1 shared publication Jiaqi Liu
School of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin China
1 shared publication- Jiaqi Liu
Faculty of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin Heilongjiang People's Republic of China
1 shared publication Ling Weng
School of Materials Science and Chemical Engineering Harbin University of Science and Technology Harbin China
1 shared publication
Latest Publications
- 14 July 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (38)
Effect of Mg Content on the Corona Resistance and Dielectric Properties of Si‐B‐Mg/ PI Composites
To enhance the corona resistance and dielectric properties of polyimide (PI), this study designed and fabricated Si‐B‐Mg/PI nanocomposites. The relative magnesium content was investigated for its effect on the electrical insulation properties of the Si‐B‐Mg/PI nanocomposite. A composite with a specific doping level of 27.5 wt% Si‐B‐Mg/PI was prepared by adjusting the Mg addition ratio. The composite material underwent performance testing and microstructural characterization, including corona discharge lifetime, dielectric properties, volume resistivity, conductive current, and breakdown field strength. The influence of Mg content on the insulating properties of the Si‐B‐Mg/PI composite was systematically analyzed. Experimental results indicate that when the molar ratio of Si‐B‐Mg composite oxides is 12:3:0.8, the composite exhibits minimal dielectric loss and the longest corona resistance lifetime. At 155°C, 60 kV/mm, and 50 Hz, this lifetime reaches 510.4 min‐2.67 times that of the pure PI film. At 155°C, 60 kV/mm, and 10 kHz, it reached 140 min, representing a 11.67‐fold increase over the pure PI film. The incorporation of magnesium effectively enhances the corona resistance lifetime and reduces dielectric loss in Si‐B‐Mg/PI composite materials.
- 14 July 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (38)
Effect of Mg Content on the Corona Resistance and Dielectric Properties of Si‐B‐Mg/ PI Composites
To enhance the corona resistance and dielectric properties of polyimide (PI), this study designed and fabricated Si‐B‐Mg/PI nanocomposites. The relative magnesium content was investigated for its effect on the electrical insulation properties of the Si‐B‐Mg/PI nanocomposite. A composite with a specific doping level of 27.5 wt% Si‐B‐Mg/PI was prepared by adjusting the Mg addition ratio. The composite material underwent performance testing and microstructural characterization, including corona discharge lifetime, dielectric properties, volume resistivity, conductive current, and breakdown field strength. The influence of Mg content on the insulating properties of the Si‐B‐Mg/PI composite was systematically analyzed. Experimental results indicate that when the molar ratio of Si‐B‐Mg composite oxides is 12:3:0.8, the composite exhibits minimal dielectric loss and the longest corona resistance lifetime. At 155°C, 60 kV/mm, and 50 Hz, this lifetime reaches 510.4 min‐2.67 times that of the pure PI film. At 155°C, 60 kV/mm, and 10 kHz, it reached 140 min, representing a 11.67‐fold increase over the pure PI film. The incorporation of magnesium effectively enhances the corona resistance lifetime and reduces dielectric loss in Si‐B‐Mg/PI composite materials.
- 8 April 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (23) , e70760
Study on the Corona Resistance of Si–B–Mg/ FPI Nanocomposites
This study prepared silicon–boron–magnesium composite oxides (molar ratio Si:B:Mg = 12:3:0.5) using phenyl triethoxysilane, tributyl borate, and ethoxylated magnesium as raw materials. Subsequently, trifluoromethyl groups were introduced into the polyimide backbone using 4,4′‐(hexafluoroisopropylidene)bisphthalic anhydride (6FDA) as a comonomer at a molar ratio of n (PMDA): n (6FDA) = 2:8. Si–B–Mg/FPI ternary composite films with varying doping concentrations were prepared via in situ polymerization. The effects of doping concentration on the composite films' corona resistance and dielectric properties were investigated. Results indicate that the incorporation of Si–B–Mg composite oxides significantly enhances corona resistance. Specifically, the FPI‐32 sample (32 wt% doping) exhibited a corona endurance time of 474.72 min under conditions of 50 Hz, 155°C, and 60 kV mm −1 , representing a 1.26‐fold increase over pure PI. Moreover, both the dielectric constant and dielectric loss of the composite material remained at low levels. These data indicate that the incorporation of Si–B–Mg composite oxides can enhance the corona resistance and dielectric properties of fluorinated polyimides.
- 8 April 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (23) , e70760
Study on the Corona Resistance of Si–B–Mg/ FPI Nanocomposites
This study prepared silicon–boron–magnesium composite oxides (molar ratio Si:B:Mg = 12:3:0.5) using phenyl triethoxysilane, tributyl borate, and ethoxylated magnesium as raw materials. Subsequently, trifluoromethyl groups were introduced into the polyimide backbone using 4,4′‐(hexafluoroisopropylidene)bisphthalic anhydride (6FDA) as a comonomer at a molar ratio of n (PMDA): n (6FDA) = 2:8. Si–B–Mg/FPI ternary composite films with varying doping concentrations were prepared via in situ polymerization. The effects of doping concentration on the composite films' corona resistance and dielectric properties were investigated. Results indicate that the incorporation of Si–B–Mg composite oxides significantly enhances corona resistance. Specifically, the FPI‐32 sample (32 wt% doping) exhibited a corona endurance time of 474.72 min under conditions of 50 Hz, 155°C, and 60 kV mm −1 , representing a 1.26‐fold increase over pure PI. Moreover, both the dielectric constant and dielectric loss of the composite material remained at low levels. These data indicate that the incorporation of Si–B–Mg composite oxides can enhance the corona resistance and dielectric properties of fluorinated polyimides.