Rômulo Marçal Gandia

The performance of grain storage silos is strongly influenced by discharge flow patterns, hopper geometry, and material properties such as moisture content and impurity levels. However, the combined effects of these factors on flow behavior, discharge rate, and segregation are not yet fully understood. This study experimentally investigated the integrated effects of moisture content, prismatic hopper geometry (hopper angle β), and impurity addition on flow behavior, segregation, and mass flow rate in reduced-scale silos. Experiments were conducted using three prismatic silos with hopper angles of β = 15°, 33°, and 45°, filled with maize at moisture contents of 13.6%, 20.2%, and 26.0% (wet basis), under both clean conditions and with the addition of 10% impurities (fraction passing through a 5 mm sieve). The discharge rate was determined by direct mass–time measurements, flow patterns were inferred from video analysis, and segregation was quantified based on the mass fraction of impurities in samples collected during discharge. The results indicate that moisture content was the most influential factor, reducing the discharge rate by up to 22.8% when increasing from 20.2% to 26.0% w.b. (p < 0.05). Hopper geometry also had a significant effect, with performance differences among configurations becoming more pronounced under high-moisture conditions. The addition of 10% impurities increased the discharge rate under all tested conditions, with gains of up to 29.0% at 26.0% w.b. and β = 15°. Segregation intensified with increasing moisture content, leading to a progressive accumulation of impurities toward the end of discharge. The stick–slip phenomenon was observed under a critical condition (26.0% w.b., β = 15°, with impurities), resulting in a 23.0% reduction in the average discharge rate compared to the equivalent stable condition. These findings demonstrate that granular flow behavior in silos is governed by the interaction between moisture, hopper geometry, and material composition. The results also suggest that operational strategies such as pre-cleaning should be evaluated in conjunction with expected moisture conditions, as pre-cleaning may adversely affect flow performance under high-moisture scenarios.

The performance of grain storage silos is strongly influenced by discharge flow patterns, hopper geometry, and material properties such as moisture content and impurity levels. However, the combined effects of these factors on flow behavior, discharge rate, and segregation are not yet fully understood. This study experimentally investigated the integrated effects of moisture content, prismatic hopper geometry (hopper angle β), and impurity addition on flow behavior, segregation, and mass flow rate in reduced-scale silos. Experiments were conducted using three prismatic silos with hopper angles of β = 15°, 33°, and 45°, filled with maize at moisture contents of 13.6%, 20.2%, and 26.0% (wet basis), under both clean conditions and with the addition of 10% impurities (fraction passing through a 5 mm sieve). The discharge rate was determined by direct mass–time measurements, flow patterns were inferred from video analysis, and segregation was quantified based on the mass fraction of impurities in samples collected during discharge. The results indicate that moisture content was the most influential factor, reducing the discharge rate by up to 22.8% when increasing from 20.2% to 26.0% w.b. (p < 0.05). Hopper geometry also had a significant effect, with performance differences among configurations becoming more pronounced under high-moisture conditions. The addition of 10% impurities increased the discharge rate under all tested conditions, with gains of up to 29.0% at 26.0% w.b. and β = 15°. Segregation intensified with increasing moisture content, leading to a progressive accumulation of impurities toward the end of discharge. The stick‑slip phenomenon was observed under a critical condition (26.0% w.b., β = 15°, with impurities), resulting in a 23.0% reduction in average discharge rate compared to the equivalent stable condition. These findings demonstrate that granular flow behavior in silos is governed by the interaction between moisture, hopper geometry, and material composition. The results also suggest that operational strategies such as pre-cleaning should be evaluated in conjunction with expected moisture conditions, as pre‑cleaning may adversely affect flow performance under high‑moisture scenarios.