Logan S. Young
Research Subjects
Research Interests
Logan S. Young has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Amie M. G. Brady
U.S. Geological Survey, Ohio Water Science Center, Columbus, Ohio, USA
1 shared publication - Benjamin J. Michels1 shared publication
- Brittany R. Hanrahan
Soil Drainage Research Unit, USDA Agricultural Research Service
1 shared publication - Douglas B. Chambers
U.S. Geological Survey, Virginia-West Virginia Water Science Center, Charleston, USA
1 shared publication - Nadine D. Lepore1 shared publication
- Richie H. Dang1 shared publication
Latest Publications
- Open Access
- 15 April 2026
- Published by Elsevier in SSRN Electronic Journal
Potential bias in suspended sediment concentrations in environmental waters due to high dissolved solids
Suspended sediment in streams can significantly impact water quality and the management of natural water bodies. Suspended sediment analysis of samples that originated from carbonate terrains often have high concentrations of dissolved solids, which can impact suspended sediment concentration (SSC) analysis results due to off-gassing of carbon dioxide which can lead to mineral precipitation of dissolved solids. This study, conducted by the U.S. Geological Survey’s Kentucky Sediment Laboratory, aims to identify the effects of dissolved solids on suspended sediment analysis and suggests potential ways to mitigate the impacts on laboratory results. Study sites were identified as affected or non-affected sites based on comparison of SSC and turbidity relations; affected site samples had greater than expected SSC at low turbidity (potential bias). A holding-time investigation was done using samples collected from both affected and non-affected sites. The samples from affected sites had a greater increase in SSC over time compared to the samples from non-affected areas and controls. To counteract this effect and provide more accurate results, laboratories analyzing for suspended sediments can implement additional quality assurance procedures. For example, for samples with high specific conductance (an indication of high dissolved solids), samples can undergo extra rinsing with deionized water during analysis. By understanding the connection between geological setting, turbidity, and historic SSC readings, laboratories and project managers can discern whether a sample requires extra attention. Further experimentation could be done to determine the significance of dissolved solids, such as comparing analysis of SSC done immediately upon collection versus analysis done at the laboratory.
- 15 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessPotential bias in suspended sediment concentrations in environmental waters due to high dissolved solids
Suspended sediment in streams can significantly impact water quality and the management of natural water bodies. Suspended sediment analysis of samples that originated from carbonate terrains often have high concentrations of dissolved solids, which can impact suspended sediment concentration (SSC) analysis results due to off-gassing of carbon dioxide which can lead to mineral precipitation of dissolved solids. This study, conducted by the U.S. Geological Survey’s Kentucky Sediment Laboratory, aims to identify the effects of dissolved solids on suspended sediment analysis and suggests potential ways to mitigate the impacts on laboratory results. Study sites were identified as affected or non-affected sites based on comparison of SSC and turbidity relations; affected site samples had greater than expected SSC at low turbidity (potential bias). A holding-time investigation was done using samples collected from both affected and non-affected sites. The samples from affected sites had a greater increase in SSC over time compared to the samples from non-affected areas and controls. To counteract this effect and provide more accurate results, laboratories analyzing for suspended sediments can implement additional quality assurance procedures. For example, for samples with high specific conductance (an indication of high dissolved solids), samples can undergo extra rinsing with deionized water during analysis. By understanding the connection between geological setting, turbidity, and historic SSC readings, laboratories and project managers can discern whether a sample requires extra attention. Further experimentation could be done to determine the significance of dissolved solids, such as comparing analysis of SSC done immediately upon collection versus analysis done at the laboratory.