GKGleb Kotelnikov

Gleb Kotelnikov

*This is an algorithmically generated author record based on publicly available information.

Gleb Kotelnikov has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Evaluation of the most common laser-induced structures on aluminum surfaces for nucleate boiling intensification

    by D. V. Feoktistov, K. N. Gulkin, Gleb Kotelnikov, Kristina Paushkina, Andrey Pleshko, Anastasiya Nikolaeva, Ekaterina Laga, M. M. Popov, Dauren Muzaparov, Olzhas Talipov, et al.

    The evaluation has been performed on the efficiency of laser surface treatment of aluminum alloy as a passive method for enhancing the heat transfer coefficient and critical heat flux under water pool boiling conditions. This enhancement is achieved through the formation of specific surface structures and textures, as well as through the wettability modification from a hydrophilic to a superhydrophilic state. Ten series of samples were fabricated. In the first group, structures in the form of craters, multiscale topography with developed roughness, and micropillars were created on five samples. The obtained structures have enhanced corrosion and scale resistance and provided a 20‐fold increase in heat removal during single‐droplet evaporation. In the second group, microfinned structures considered most promising for boiling heat transfer enhancement were created. The differences among the microfinned structures concerned the characteristics of the top faces, the microfin height, and the width of the inter‐fin spaces (channel width). The structural characteristics and roughness parameters were determined by scanning and confocal microscopy. Wettability and capillary wicking of the surfaces were evaluated. Pool boiling experiments were conducted with distilled degassed water at atmospheric pressure, with recording of thermal characteristics, nucleation site density, bubble detachment frequency, and mean bubble diameter using high‐speed video imaging. A non‐monotonic relationship was established between the increase in roughness, the improvement in wettability, and the boiling performance. For surfaces with homogeneous developed roughness and micropillars, an increase in the heat transfer coefficient (HTC) in the pre‐crisis region (up to 74%) was recorded, but a decrease in the critical heat flux (CHF) by 12 – 41% compared to a polished surface was observed, which contradicts the classical models of Kandlikar and Rohsenow. It is shown that this is caused by excessive intensification of vapor formation, leading to premature bubble coalescence and the formation of vapor agglomerates. Microfinned structures provide a simultaneous enhancement of both HTC and CHF. The best performance was achieved for the following configuration: microfin height of 350 μm, pitch of 400 μm, channel width of 210 μm, and superhydrophilic roughness on the top faces. The CHF was increased by a factor of 1.57 (up to 175.0 W/cm²), and the HTC at the crisis point was increased by a factor of 3.14 (up to 17.9 W/(cm²·K)) compared to the polished sample. An empirical criterion is proposed (based on the values of bubble detachment frequency and nucleation site density at q ≈ 20 W/cm²), that allows predicting the efficiency of laser-induced structures and roughness for CHF enhancement. Good agreement of the obtained results with percolation theory is established. It is shown that an increase in surface area and capillary wicking alone do not guarantee CHF enhancement; the decisive factor is the presence of an ordered directional structure that ensures a balanced removal of vapor and supply of the working fluid.

  • Hydrophobization of metal surfaces by laser treatment and subsequent heat treatment of hydrocarbon liquids

    by D.V. Feoktistov, E.G. Orlova, G.E. Kotelnikov, K.K. Paushkina, A.O. Pleshko, O.V. Semyonov, D.O. Glushkov, A.V. Buglak