CZChanghui Zhang

Changhui Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Changhui Zhang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Blast Resistance of RC Slabs Strengthened with Concrete-Based Protective Layers Under Contact Explosion

    by Meili Meng, Shubo Dai, Jinlei Zheng, Ran Song, Kelei Cao, Changhui Zhang

    This study investigates the blast-protective performance of RC slab strengthened on the blast face with various concrete protective layers under contact-detonation loading. The research focuses on analyzing shock wave propagation characteristics, peak pressures at measurement points, energy absorption capacities of the protective layers, the development of damage, and the governing failure mechanisms of the RC slab. The protective layers used for structural reinforcement include Steel Fiber-Reinforced Cellular Concrete (SFR-CC), Asphalt Concrete (AC), Rubberized Concrete (RBC), and Foamed Concrete (FC). Among these, the maximum support rotation angle of the structure strengthened with the SFR-CC concrete layer (T-1) is 0.20°, indicating significantly less damage and deformation compared to other protective schemes. Based on the damage coefficient calculated from the remaining sectional moment of inertia of the protected RC slabs, the destruction grades of the structures at different concrete protective schemes were classified. Among these, the SFR-CC layer exhibits the most effective attenuation of shock wave peak pressure. Additionally, the maximum support rotation angle of the structure strengthened with the SFR-CC concrete layer is 0.20°, indicating significantly less damage and deformation compared to other protective schemes. Damage grades were assigned according to a coefficient derived from the residual sectional moment of inertia of the protected RC slabs. The SFR-CC configuration (T-1) gives the lowest damage index, 0.178, approximately 64.5% below that of the NC scheme, and is classified as slight damage. In contrast to the severe damage sustained by the protected RC slabs strengthened with the NC concrete scheme, those strengthened with the AC, RBC, and FC protective layer schemes exhibit only a moderate damage grade. Empirical formulas predicting the damage index of protected structures under the combined effects of varying blast charges and concrete layer thicknesses were further developed for rapid damage assessment.

  • Open Access

    Probability Distribution and Recommended Value for the Crack Spacing Reduction Coefficient of Steel Fiber in SFRC Beams

    by Yunchao Huang, Jiachen Sun, Danying Gao, Shangke Li, Changhui Zhang, Huanhuan Yan, Kangbo Qiao

    The effect of steel fiber on the maximum crack width of steel fiber reinforced concrete (SFRC) members under normal service conditions was studied through tests on a series of 19 flexural beams, and the applicability of the crack spacing reduction coefficient of steel fiber in SFRC beams from Modified Rilem model that using for calculating maximum crack width was discussed, of which the reduction coefficient value was used to determine the influence of steel fibers on the crack width. Results show that the maximum crack width of the RC beam under bending conditions clearly decreased with the addition of fibers, and the reduction coefficient value of the crack width of the SFRC beam is greater when compared with that specified in the Modified Rilem model. The effect of steel fiber on reducing crack width was overrated, while the reduction coefficient proposed in the Modified Rilem model was used to calculate the maximum crack width. The probability of the reduction coefficient was analyzed based on experimental data collected from the relevant literature, and the reduction coefficients for different steel fiber types with various guarantee rates were obtained. Finally, the suggestion for the value of the reduction coefficient in the Modified Rilem model was proposed to be 1.19, which could be referred to for the code revision.