D. M. Saruwage
Research Subjects
D. M. Saruwage has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- D. A. Upeka Chathurangani
College of Chemical Sciences, Institute of Chemistry Ceylon, Rajagiriya, Sri Jayawardenepura Kotte 10107, Sri Lanka
1 shared publication - Dinusha N. Udukala
Department of Chemistry, Kansas State University, Manhattan, KS 66506, USA
1 shared publication - Medha Jaimini Gunaratna
Department of Chemistry, Faculty of Science, University of Kelaniya, Kelaniya 11600, Sri Lanka
1 shared publication - Mohamed M. Farhath1 shared publication
- Thillainathan Jaseetharan
Postgraduate Institute of Science, University of Peradeniya, Peradeniya, Sri Lanka
1 shared publication
Latest Publications
- Open Access
- 24 April 2026
- Published by Elsevier in SSRN Electronic Journal
Optimizing the size of Bi2S3 Quantum dots for efficient Quantum dot/Natural dye co-sensitized solar cells
Low-cost co-sensitized solar cells were fabricated using natural dye and Bismuth trisulfide (Bi₂S₃) quantum dots. The pigment extracted from the bark of Dialium ovoideum, used as the natural dye sensitizer. Bi2S3 quantum dots were chosen as co-sensitizers because of their non-toxic nature and suitable band gap for light harvesting. The configuration of the fabricated DSSC is FTO/TiO2/Dye/(I-/I-3)/Pt and iodide/triiodide (I-/I-3) redox couple used as the electrolyte. The DSSCs achieved an efficiency of 0.593 %, an open-circuit voltage (Voc) of 414.7 mV, and a short-circuit current density (Jsc) of 0.242 mA cm-2under 100 mW cm-2 illumination with an AM 1.5 spectral filter for a 0.25 cm2 active area. Configuration of the co-sensitized cell is FTO/TiO2/QD/Dye/(I-/I-3)/Pt. This resulted in an efficiency of 0.726% and a short-circuit current density of 1.378 mA cm-2. Overall, this study contributes to the development of cost-effective and environmentally friendly photovoltaic cells.
- 24 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessOptimizing the size of Bi2S3 Quantum dots for efficient Quantum dot/Natural dye co-sensitized solar cells
Low-cost co-sensitized solar cells were fabricated using natural dye and Bismuth trisulfide (Bi₂S₃) quantum dots. The pigment extracted from the bark of Dialium ovoideum, used as the natural dye sensitizer. Bi2S3 quantum dots were chosen as co-sensitizers because of their non-toxic nature and suitable band gap for light harvesting. The configuration of the fabricated DSSC is FTO/TiO2/Dye/(I-/I-3)/Pt and iodide/triiodide (I-/I-3) redox couple used as the electrolyte. The DSSCs achieved an efficiency of 0.593 %, an open-circuit voltage (Voc) of 414.7 mV, and a short-circuit current density (Jsc) of 0.242 mA cm-2under 100 mW cm-2 illumination with an AM 1.5 spectral filter for a 0.25 cm2 active area. Configuration of the co-sensitized cell is FTO/TiO2/QD/Dye/(I-/I-3)/Pt. This resulted in an efficiency of 0.726% and a short-circuit current density of 1.378 mA cm-2. Overall, this study contributes to the development of cost-effective and environmentally friendly photovoltaic cells.