Sushant Padhye
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sushant Padhye has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Evgeny Mikheev
University of Cincinnati
2 shared publications - Bharat Jalan
University of Minnesota Twin Cities
1 shared publication Carter Wade
Department of Physics, Miami University 1 , Oxford, Ohio 45056
1 shared publicationDavid Goldhaber-Gordon
Stanford University
1 shared publication- Dickson Boahen
University of Cincinnati
1 shared publication - Eshanvi Rao
University of Cincinnati
1 shared publication
Latest Publications
- 2 October 2026
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 10 (10)
Suppression of superconductivity and electrostatic side gate tuning in high mobility SrTiO 3 surface electron gas
- 2 October 2026
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 10 (10)
Suppression of superconductivity and electrostatic side gate tuning in high mobility SrTiO 3 surface electron gas
- 30 July 2026
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 8 (3)
A thickness-dependence study on structure, oxidation, and critical temperature scaling of α -Ta(111) thin films for qubit application
We present a multi-technique characterization of sputter-grown α-Ta thin films on Al2O3 (001), spanning thicknesses from 2 to 250 nm. Our goal is a multi-faceted understanding of three structurally distinct regions whose properties can impact qubit performance: the substrate-film interface, the bulk Ta layer, and the self-limiting native oxide. Films were deposited at 100 W, 32 mTorr, and 650 °C using a 33 mm target via direct current sputter epitaxy. X-ray diffraction shows mono-oriented α-Ta(111) growth with lattice spacing in agreement with bulk Ta (0.331 nm). X-ray reflectometry and atomic force microscopy reveal smooth surfaces with an average roughness of 0.62 ± 0.22 nm. Films nucleate as small islands whose terrace width increases linearly with thickness up to approximately 150 nm, then saturates. Reflectometry identifies a 0.88 ± 0.14 nm pseudomorphic Ta layer at the substrate interface and a self-limiting amorphous oxide of 2.25 ± 0.20 nm at the film surface, both independent of film thickness beyond 4 nm. Electronic transport measurements using the Van der Pauw method show a smooth evolution of the superconducting critical temperature with thickness, increasing from 2.9 K for 7.5 nm films to 4.2 K for 269.2 nm films, consistent with universal thickness scaling in superconductors. Density functional theory calculations examine oxidation of the α-Ta(111) surface. Increasing oxygen content progressively disrupts crystallinity, and when the Ta:O ratio exceeds 1:1, an amorphous TaO phase forms. The simulated oxide density agrees well with reflectometry, and the calculated structural variation of the amorphous oxide (0.8 nm) matches the measured variation.
- 30 July 2026
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 8 (3)
A thickness-dependence study on structure, oxidation, and critical temperature scaling of α -Ta(111) thin films for qubit application
We present a multi-technique characterization of sputter-grown α-Ta thin films on Al2O3 (001), spanning thicknesses from 2 to 250 nm. Our goal is a multi-faceted understanding of three structurally distinct regions whose properties can impact qubit performance: the substrate-film interface, the bulk Ta layer, and the self-limiting native oxide. Films were deposited at 100 W, 32 mTorr, and 650 °C using a 33 mm target via direct current sputter epitaxy. X-ray diffraction shows mono-oriented α-Ta(111) growth with lattice spacing in agreement with bulk Ta (0.331 nm). X-ray reflectometry and atomic force microscopy reveal smooth surfaces with an average roughness of 0.62 ± 0.22 nm. Films nucleate as small islands whose terrace width increases linearly with thickness up to approximately 150 nm, then saturates. Reflectometry identifies a 0.88 ± 0.14 nm pseudomorphic Ta layer at the substrate interface and a self-limiting amorphous oxide of 2.25 ± 0.20 nm at the film surface, both independent of film thickness beyond 4 nm. Electronic transport measurements using the Van der Pauw method show a smooth evolution of the superconducting critical temperature with thickness, increasing from 2.9 K for 7.5 nm films to 4.2 K for 269.2 nm films, consistent with universal thickness scaling in superconductors. Density functional theory calculations examine oxidation of the α-Ta(111) surface. Increasing oxygen content progressively disrupts crystallinity, and when the Ta:O ratio exceeds 1:1, an amorphous TaO phase forms. The simulated oxide density agrees well with reflectometry, and the calculated structural variation of the amorphous oxide (0.8 nm) matches the measured variation.
- 11 May 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (18)
Superconducting dome in ionic liquid gated homoepitaxial strontium titanate thin films
- 11 May 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (18)
Superconducting dome in ionic liquid gated homoepitaxial strontium titanate thin films