Janis A. Andersons
Janis A. Andersons has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Salomé Sanchez
1 shared publication- Salomé Sanchez
University of Twente
1 shared publication - Tom H. J. Vaneker
University of Twente
1 shared publication Tom Vaneker
1 shared publication
Latest Publications
- Open Access
- 9 June 2026
- Published by Elsevier in Additive Manufacturing Letters
- Vol. 18
Wave-inspired path-planning strategy for support-free horizontal overhangs in FDM
- 9 June 2026
- Published by Elsevier in Additive Manufacturing Letters
- Vol. 18
Open AccessWave-inspired path-planning strategy for support-free horizontal overhangs in FDM
- Open Access
- 6 May 2026
- Published by Elsevier in SSRN Electronic Journal
Wave-Inspired Path-Planning Strategy for Support-Free Horizontal Overhangs in FDM
A novel path-planning strategy is presented that enables the support-free 3D printing of cantilevered horizontal overhangs in FDM, by procedurally modeling toolpaths according to wave propagation theory. Such horizontal overhangs are widely regarded as impossible on conventional 3-axis FDM systems without the use of sacrificial support material, except for limited cases or with significant material sagging. This strategy allows for continuous paths that naturally navigate complex geometry through a diffraction-like behavior, thereby overcoming geometric constraints and sagging present in prior approaches. To validate the method, mono-layer overhangs of varying geometric difficulty were printed and compared against arc-based toolpaths. Surface deviation measurements show that wave paths exhibit significantly reduced sagging and improved coverage, with fewer gaps at higher difficulty. A multi-layer demonstrator sample was printed, confirming that subsequent layers can be deposited reliably onto wave-path mono-layer overhangs. These results demonstrate that horizontal overhangs can be achieved on standard 3-axis FDM systems for arbitrary shapes, without support structures or sagging, which significantly reduces material waste and eliminates support removal as a post-processing step. These findings also challenge conventional assumptions about overhang limitations and printability constraints.
- 6 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessWave-Inspired Path-Planning Strategy for Support-Free Horizontal Overhangs in FDM
A novel path-planning strategy is presented that enables the support-free 3D printing of cantilevered horizontal overhangs in FDM, by procedurally modeling toolpaths according to wave propagation theory. Such horizontal overhangs are widely regarded as impossible on conventional 3-axis FDM systems without the use of sacrificial support material, except for limited cases or with significant material sagging. This strategy allows for continuous paths that naturally navigate complex geometry through a diffraction-like behavior, thereby overcoming geometric constraints and sagging present in prior approaches. To validate the method, mono-layer overhangs of varying geometric difficulty were printed and compared against arc-based toolpaths. Surface deviation measurements show that wave paths exhibit significantly reduced sagging and improved coverage, with fewer gaps at higher difficulty. A multi-layer demonstrator sample was printed, confirming that subsequent layers can be deposited reliably onto wave-path mono-layer overhangs. These results demonstrate that horizontal overhangs can be achieved on standard 3-axis FDM systems for arbitrary shapes, without support structures or sagging, which significantly reduces material waste and eliminates support removal as a post-processing step. These findings also challenge conventional assumptions about overhang limitations and printability constraints.