Václav Olšanský
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Václav Olšanský has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
David Chvátil
3 shared publicationsJan Šimon
2 shared publications- Marek Zmeškal
Research Centre Rez, Hlavni 130, Husinec-Rez, 250 68, Czech Republic
2 shared publications - Michael Němeček2 shared publications
- Zdeněk Matěj
Department of Computer Systems and Communications, Faculty of Informatics, Masaryk University, Brno, Czech Republic
2 shared publications - Alain Mery
CIMAP, CEA, CNRS, ENSICAEN, UNICAEN, Normandie Université, BP5133, 14050 Caen Cedex 04, France
1 shared publication
Latest Publications
- 19 September 2026
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 241
Integral measurements of (γ,n) reactions and 238U photofission in bremsstrahlung fields
- 19 September 2026
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 241
Integral measurements of (γ,n) reactions and 238U photofission in bremsstrahlung fields
- Open Access
- 5 June 2026
- Published by Elsevier in SSRN Electronic Journal
Integral measurements of (γ,n) reactions and 238U photofission in bremsstrahlung fields
Photonuclear activation and photofission reaction rates were measured in bremsstrahlung fields produced by the MT-25 microtron at primary electron energies of 14.25, 15.9, 17.8 and 19.55~MeV. A stack of activation detectors was used to study (γ,n) reactions on F, Ti, Mn, Ni, Co, Cu, Y, Nb, Tm, Au and U, the 169Tm(γ,2n) reaction, and 238U photofission. The photon field was calculated with Geant4 and independently checked with the deterministic code Radiant and with stilbene scintillation spectrometry. The measured reaction rates were compared with calculations based on ENDF/B-VIII.0, ENDF/B-VIII.1, IAEA/PD-2019, JENDL-5 and recent TENDL releases. Several (γ,n) reactions were reproduced within a few tens of percent, whereas larger discrepancies were found for threshold-sensitive channels, especially 46Ti(γ,n), 58Ni(γ,n) and 169Tm(γ,2n). The 238U(γ,n) and 238U(γ,f) reaction rates were generally underestimated by the evaluated data, and the measured fission-to-(γ,n) ratio increased from 0.34 to 0.50 over the investigated energy range. The results provide integral benchmark data for photonuclear cross-section libraries in the giant-dipole-resonance region.
- 5 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessIntegral measurements of (γ,n) reactions and 238U photofission in bremsstrahlung fields
Photonuclear activation and photofission reaction rates were measured in bremsstrahlung fields produced by the MT-25 microtron at primary electron energies of 14.25, 15.9, 17.8 and 19.55~MeV. A stack of activation detectors was used to study (γ,n) reactions on F, Ti, Mn, Ni, Co, Cu, Y, Nb, Tm, Au and U, the 169Tm(γ,2n) reaction, and 238U photofission. The photon field was calculated with Geant4 and independently checked with the deterministic code Radiant and with stilbene scintillation spectrometry. The measured reaction rates were compared with calculations based on ENDF/B-VIII.0, ENDF/B-VIII.1, IAEA/PD-2019, JENDL-5 and recent TENDL releases. Several (γ,n) reactions were reproduced within a few tens of percent, whereas larger discrepancies were found for threshold-sensitive channels, especially 46Ti(γ,n), 58Ni(γ,n) and 169Tm(γ,2n). The 238U(γ,n) and 238U(γ,f) reaction rates were generally underestimated by the evaluated data, and the measured fission-to-(γ,n) ratio increased from 0.34 to 0.50 over the investigated energy range. The results provide integral benchmark data for photonuclear cross-section libraries in the giant-dipole-resonance region.
- Open Access
- 10 May 2026
- Published by Wiley in Chemnanomat
- Vol. 12 (5)
Evaluation of Structural Vulnerabilities in DNA Origami Nanoplatforms Using Ionizing Radiation
DNA origami holds great promise as a platform for diverse nanostructure assemblies, but its long‐term stability remains a key challenge, especially in application‐specific environments. In this study, we used two types of ionizing radiation to controllably induce strand breaks in three distinct DNA origami shapes, simulating long‐term damage and identifying structural weak points. Damage was assessed using atomic force microscopy (AFM), agarose gel electrophoresis (AGE), and melting point analysis. AFM revealed that overall structural integrity was retained even after exposure to extremely high radiation doses. However, melting point measurements showed a reduction in thermal stability, indicating an increased number of strand breaks, supported by AGE analysis of denatured samples. Vulnerabilities were most pronounced at exposed edges and single‐stranded regions, which are more accessible to reactive species generated during water radiolysis. This approach offers a simple method to identify DNA origami weak points and probe long‐term stability of DNA nanostructures in a fast and controlled way. The results also provide benchmarks for theoretical models and guidelines for the design of robust DNA origami for various applications.
- 10 May 2026
- Published by Wiley in Chemnanomat
- Vol. 12 (5)
Open AccessEvaluation of Structural Vulnerabilities in DNA Origami Nanoplatforms Using Ionizing Radiation
DNA origami holds great promise as a platform for diverse nanostructure assemblies, but its long‐term stability remains a key challenge, especially in application‐specific environments. In this study, we used two types of ionizing radiation to controllably induce strand breaks in three distinct DNA origami shapes, simulating long‐term damage and identifying structural weak points. Damage was assessed using atomic force microscopy (AFM), agarose gel electrophoresis (AGE), and melting point analysis. AFM revealed that overall structural integrity was retained even after exposure to extremely high radiation doses. However, melting point measurements showed a reduction in thermal stability, indicating an increased number of strand breaks, supported by AGE analysis of denatured samples. Vulnerabilities were most pronounced at exposed edges and single‐stranded regions, which are more accessible to reactive species generated during water radiolysis. This approach offers a simple method to identify DNA origami weak points and probe long‐term stability of DNA nanostructures in a fast and controlled way. The results also provide benchmarks for theoretical models and guidelines for the design of robust DNA origami for various applications.