Penggen Ouyang
Research Subjects
Penggen Ouyang has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Fengjun Chen
School of Robot Engineering, Wenzhou University of Technology, Wenzhou, China
1 shared publication - Jian Liu
School of Robot Engineering, Wenzhou University of Technology, Wenzhou 325000, China
1 shared publication - Jinzhong Wu
School of Intelligent Engineering, Shaoxing University, Shaoxing 312000, China
1 shared publication - Meiling Du
School of Robot Engineering, Wenzhou University of Technology, Wenzhou 325000, China
1 shared publication - Sheng Gong
Hefei Accuracy Intelligent Equipment Co., Ltd., Hefei 230094, China
1 shared publication - Shuai Huang
College of Mechanical and Vehicle Engineering, Hunan University, Changsha, CHINA
1 shared publication
Latest Publications
- Open Access
- 1 June 2026
- Published by MDPI AG in Micromachines
- Vol. 17 (6) , 686
Optimization and Predictive Modeling of SiC Wafer Dicing Using a Thin Diamond Grinding Wheel via RSM and NSGA-II
To investigate how the process parameters of ultra-thin diamond grinding wheel dicing affect the dicing quality of silicon carbide (SiC) wafers, single-factor experiments were designed. This study examined the influence of key process parameters, including spindle speed, feed rate, and first dicing depth, on the maximum chip width on the front side W1 and the maximum chip width on the back side W2, thereby determining their optimal parameter ranges. Subsequently, a quadratic polynomial prediction model was established using response surface analysis to analyze the interactive effects among the grinding wheel dicing process parameters. Finally, the prediction model was optimized using the genetic algorithm NSGA-II, and the optimal parameter combination for the two response variables was determined: a spindle speed of 31,960 r/min, a feed rate of 2.0019 mm/s, and a first dicing depth of 197.51 μm, yielding an average W1 of 4.8852 μm and W2 of 18.5360 μm. The relative errors between the predicted and average experimental values are 2.83% for W1 and 4.43% for W2. Both errors are below 5%, confirming the validity of the model. Therefore, the model serves as a practical reference for planning subsequent dicing processes using ultra-thin diamond grinding wheels.
- 1 June 2026
- Published by MDPI AG in Micromachines
- Vol. 17 (6) , 686
Open AccessOptimization and Predictive Modeling of SiC Wafer Dicing Using a Thin Diamond Grinding Wheel via RSM and NSGA-II
To investigate how the process parameters of ultra-thin diamond grinding wheel dicing affect the dicing quality of silicon carbide (SiC) wafers, single-factor experiments were designed. This study examined the influence of key process parameters, including spindle speed, feed rate, and first dicing depth, on the maximum chip width on the front side W1 and the maximum chip width on the back side W2, thereby determining their optimal parameter ranges. Subsequently, a quadratic polynomial prediction model was established using response surface analysis to analyze the interactive effects among the grinding wheel dicing process parameters. Finally, the prediction model was optimized using the genetic algorithm NSGA-II, and the optimal parameter combination for the two response variables was determined: a spindle speed of 31,960 r/min, a feed rate of 2.0019 mm/s, and a first dicing depth of 197.51 μm, yielding an average W1 of 4.8852 μm and W2 of 18.5360 μm. The relative errors between the predicted and average experimental values are 2.83% for W1 and 4.43% for W2. Both errors are below 5%, confirming the validity of the model. Therefore, the model serves as a practical reference for planning subsequent dicing processes using ultra-thin diamond grinding wheels.