Jiahao Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jiahao Chen has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Tian Liang
Tsinghua University
2 shared publicationsYu Cao
Tsung-Dao Lee Institute, Shanghai Jiao Tong University 2 , Shanghai 201210
2 shared publications- Yuanze Li
State Key Laboratory of Low Dimensional Quantum Physics, Department of Physics, Tsinghua University, Beijing, People’s Republic of China
2 shared publications Hong Du
Shanghai Jiao Tong University
1 shared publication- Hong Du
Shanghai Jiao Tong University
1 shared publication - Jin Xie
ShanghaiTech University
1 shared publication
Latest Publications
- 1 September 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (9)
Design and implementation of a high-precision angle-resolved thermoelectric measurement apparatus
This work reports the development of a homemade thermoelectric measurement apparatus designed for in situ angle-resolved transport studies under cryogenic temperatures and high magnetic fields. The system employs a chip resistor as a heater to establish a stable longitudinal temperature gradient (ΔT), where ΔT denotes the temperature difference across the sample, while a Type-E thermocouple is integrated for temperature-difference monitoring. A key feature of this design is the integration of the measurement assembly onto a Physical Property Measurement System rotator probe, enabling precise stepwise modulation of the magnetic-field orientation relative to the sample’s crystallographic axes under high-vacuum conditions. The apparatus achieves a low noise floor, resolving Seebeck and Nernst signals with fluctuations confined to approximately ±10 nV/K, and its accuracy and the associated sources of measurement error are characterized using a Constantan reference sample. The setup is further demonstrated through angle-dependent measurements on ZrTe5 and BiSbTeSe2 (BSTS2) single crystals, highlighting the applicability of this methodology for investigating thermoelectric transport properties of topological and functional materials.
- 1 September 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (9)
Design and implementation of a high-precision angle-resolved thermoelectric measurement apparatus
This work reports the development of a homemade thermoelectric measurement apparatus designed for in situ angle-resolved transport studies under cryogenic temperatures and high magnetic fields. The system employs a chip resistor as a heater to establish a stable longitudinal temperature gradient (ΔT), where ΔT denotes the temperature difference across the sample, while a Type-E thermocouple is integrated for temperature-difference monitoring. A key feature of this design is the integration of the measurement assembly onto a Physical Property Measurement System rotator probe, enabling precise stepwise modulation of the magnetic-field orientation relative to the sample’s crystallographic axes under high-vacuum conditions. The apparatus achieves a low noise floor, resolving Seebeck and Nernst signals with fluctuations confined to approximately ±10 nV/K, and its accuracy and the associated sources of measurement error are characterized using a Constantan reference sample. The setup is further demonstrated through angle-dependent measurements on ZrTe5 and BiSbTeSe2 (BSTS2) single crystals, highlighting the applicability of this methodology for investigating thermoelectric transport properties of topological and functional materials.
- 17 June 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 137 (7) , 076602
Topological surface charge detection via active capacitive compensation: A pathway to the 4D quantum Hall effect
The topological magnetoelectric effect (TME) in three-dimensional topological insulators (TIs), described by ΔP=(e^{2}/2h)N_{Ch}^{(2)}ΔB, serves as a condensed-matter realization of the four-dimensional quantum Hall effect (4D QHE). In dual-gate axion insulator devices, the TME-induced polarization yields a current I_{TME}∝(C_{total}/C_{S})Q_{4D-QHE}, where the signal is suppressed by the capacitance ratio C_{total}/C_{S}. Here we propose an active compensation scheme that introduces a tunable negative capacitance C_{comp}≈-C_{gate} into the gate line, effectively canceling the gate dielectric capacitance and driving C_{total}/C_{S}→1. We validate the method using a quantum anomalous Hall (QAH) device, which shares the same surface-state physics as the axion insulator but permits direct charge measurement via a single gate, recovering over 95% of the quantized charge signal from an initially half-attenuated state. This compensation method provides a robust means of resolving minute TME signals, offering a pathway toward direct measurements of the 4D QHE.
- 17 June 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 137 (7) , 076602
Topological surface charge detection via active capacitive compensation: A pathway to the 4D quantum Hall effect
The topological magnetoelectric effect (TME) in three-dimensional topological insulators (TIs), described by ΔP=(e^{2}/2h)N_{Ch}^{(2)}ΔB, serves as a condensed-matter realization of the four-dimensional quantum Hall effect (4D QHE). In dual-gate axion insulator devices, the TME-induced polarization yields a current I_{TME}∝(C_{total}/C_{S})Q_{4D-QHE}, where the signal is suppressed by the capacitance ratio C_{total}/C_{S}. Here we propose an active compensation scheme that introduces a tunable negative capacitance C_{comp}≈-C_{gate} into the gate line, effectively canceling the gate dielectric capacitance and driving C_{total}/C_{S}→1. We validate the method using a quantum anomalous Hall (QAH) device, which shares the same surface-state physics as the axion insulator but permits direct charge measurement via a single gate, recovering over 95% of the quantized charge signal from an initially half-attenuated state. This compensation method provides a robust means of resolving minute TME signals, offering a pathway toward direct measurements of the 4D QHE.
- Open Access
- 9 June 2026
- Published by American Physical Society (APS) in APS Open Science
- Vol. 1
Investigating the relationship between the Weyl semimetal phase and the three-dimensional quantum Hall phase in ZrTe 5
The material ZrTe 5 exhibits distinct topological phases, including a Weyl semimetal (WSM) phase, characterized by a chiral anomaly and in-plane Hall effect, and a three-dimensional quantum Hall (3D QH) phase. The relationship between these phases remains poorly understood. This work systematically explores their connection in ZrTe 5 through rotatable, pressure-dependent measurements. At ambient pressure, both phases are observed; the WSM phase requires strong spontaneous electronic polarization, while the 3D QH phase appears when polarization is fully suppressed, with the characteristic resistivity peak temperature T p ∼ 90 K . Under applied pressure, ferroelectric polarization diminishes, weakening the WSM phase and its associated nontrivial Hall signals. Concurrently, T p rises dramatically from 2 K at ambient pressure to 70 K at 2.2 GPa, approaching the expected regime for the 3D QH phase. These findings clarify the conditions underlying the WSM and 3D QH phases and suggest that exploring the 3D QH phase at even higher pressures is a promising direction for future research.
- 9 June 2026
- Published by American Physical Society (APS) in APS Open Science
- Vol. 1
Open AccessInvestigating the relationship between the Weyl semimetal phase and the three-dimensional quantum Hall phase in ZrTe 5
The material ZrTe 5 exhibits distinct topological phases, including a Weyl semimetal (WSM) phase, characterized by a chiral anomaly and in-plane Hall effect, and a three-dimensional quantum Hall (3D QH) phase. The relationship between these phases remains poorly understood. This work systematically explores their connection in ZrTe 5 through rotatable, pressure-dependent measurements. At ambient pressure, both phases are observed; the WSM phase requires strong spontaneous electronic polarization, while the 3D QH phase appears when polarization is fully suppressed, with the characteristic resistivity peak temperature T p ∼ 90 K . Under applied pressure, ferroelectric polarization diminishes, weakening the WSM phase and its associated nontrivial Hall signals. Concurrently, T p rises dramatically from 2 K at ambient pressure to 70 K at 2.2 GPa, approaching the expected regime for the 3D QH phase. These findings clarify the conditions underlying the WSM and 3D QH phases and suggest that exploring the 3D QH phase at even higher pressures is a promising direction for future research.