Qiangqiang Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Qiangqiang Li has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Yongqiang Guo
School of Civil Engineering and Mechanics, Lanzhou University, and Key Laboratory of Mechanics on Disaster and Environment in Western China, Ministry of Education, Lanzhou 730000, China
3 shared publications - Yajun Wang
College of Civil Engineering and Mechanics, and Key Laboratory of Mechanics of Disaster and Environment in Western China, The Ministry of Education, Lanzhou University, Lanzhou, China
2 shared publications - Haibo Zhang
College of Resources and Environment, Shanxi Agricultural University, Jinzhong 030801, China
1 shared publication Jingya Wang
College of Urban and Rural Construction, Shanxi Agricultural University, Taigu, 030801, Shanxi, China
1 shared publication- Jingya Wang
Institute of Geophysics, China Earthquake Administration, Beijing, China
1 shared publication - Wei Chen
College of Urban and Rural Construction, Shanxi Agricultural University, Jinzhong 030801, China
1 shared publication
Latest Publications
- Open Access
- 18 April 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Bandgap characteristics and optimization of two-dimensional phononic metamaterials with functionally graded rings
This paper systematically investigates the influence of the thickness and power-law exponent of functionally graded rings (FGR) on the bandgap characteristics of two-dimensional (2D) phononic metamaterials (PMs). Based on the plane wave expansion method (PWEM), a spatial variation model for the material parameters of FGR is established, the dispersion relations of elastic waves in 2D PMs are derived, and the evolution of the first bandgap is analyzed. The results indicate that an increase in the thickness of FGR shifts both the upper and lower boundary of the bandgap upward, while the bandgap width initially increases and then decreases, reaching a maximum at a specific thickness. Variations in the power-law exponent significantly affect the width and center frequency of the bandgap, demonstrating a notable nonlinear regulatory effect. On this basis, the single-objective optimization of the bandgap width was achieved by the genetic algorithm combining with PWEM, while the multi-objective optimization of both bandgap width and center frequency was realized using the non-dominated sorting genetic algorithm (NSGA-II) in conjunction with PWEM. The Pareto optimal front indicates that there is a favorable competitive relationship between the bandgap width and the center frequency, and the optimal parameters are not limited to the boundary values.
- 18 April 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessBandgap characteristics and optimization of two-dimensional phononic metamaterials with functionally graded rings
This paper systematically investigates the influence of the thickness and power-law exponent of functionally graded rings (FGR) on the bandgap characteristics of two-dimensional (2D) phononic metamaterials (PMs). Based on the plane wave expansion method (PWEM), a spatial variation model for the material parameters of FGR is established, the dispersion relations of elastic waves in 2D PMs are derived, and the evolution of the first bandgap is analyzed. The results indicate that an increase in the thickness of FGR shifts both the upper and lower boundary of the bandgap upward, while the bandgap width initially increases and then decreases, reaching a maximum at a specific thickness. Variations in the power-law exponent significantly affect the width and center frequency of the bandgap, demonstrating a notable nonlinear regulatory effect. On this basis, the single-objective optimization of the bandgap width was achieved by the genetic algorithm combining with PWEM, while the multi-objective optimization of both bandgap width and center frequency was realized using the non-dominated sorting genetic algorithm (NSGA-II) in conjunction with PWEM. The Pareto optimal front indicates that there is a favorable competitive relationship between the bandgap width and the center frequency, and the optimal parameters are not limited to the boundary values.
- Open Access
Analysis of Floquet Waves in Periodic Multilayered Isotropic Media with the Method of Reverberation-Ray Matrix
The in-plane elastic waves in periodically multilayered isotropic structures, which are decoupled from the out-of-plane waves, are represented mainly by the frequency–wavenumber spectra and occasionally by the frequency–phase velocity spectra as well as being studied predominantly for periodic bi-layered media along and perpendicular to the thickness direction in the existing research. This paper investigates their comprehensive dispersion characteristics along arbitrary in-plane directions and in entire (low and high) frequency ranges, including the frequency–wavelength, wavenumber–phase velocity, wavelength–phase velocity spectra, the dispersion surfaces and the slowness curves with fixed frequencies, as well as the frequency–wavenumber and frequency–phase velocity spectra. Specially, the dispersion surfaces and the slowness curves completely reflect the propagation characteristics of in-plane waves along all directions. First, the method of reverberation-ray matrix (MRRM) combined with the Floquet theorem is extended to derive the dispersion equation of in-plane elastic waves in general periodic multilayered isotropic structures by means of the elastodynamic theory of isotropic materials and the state space formalism of layers. The correctness of the derivation and the numerical stability of the method in both low and high frequency ranges, particularly its superiority over the method of the transfer matrix (MTM) within the ranges near the cutoff frequencies, are verified by several numerical examples. From these demonstrations for periodic octal- and bi-layered media, the comprehensive dispersion curves are provided and their general characteristics are summarized. It is found that although the frequencies associated with the dimensionless wavenumber along thickness ( is an integer) are always the demarcation between pass and stop bands in the case of perpendicular incident wave, but this is not always exist in the case of the oblique incident wave due to the coupling between the two modes of in-plane elastic waves. The slowness curves with fixed frequencies of Floquet waves in periodically multilayered isotropic structures, as compared to their counterpart of body waves in infinite isotropic media obtained from the Christoffel equation now have periodicity along the thickness direction, which is consistent to the configuration of the structures. The slowness curves associated with higher frequencies have a smaller minimum positive period and have more propagation modes due to the cutoff properties of these additional modes.Open AccessAnalysis of Floquet Waves in Periodic Multilayered Isotropic Media with the Method of Reverberation-Ray Matrix
The in-plane elastic waves in periodically multilayered isotropic structures, which are decoupled from the out-of-plane waves, are represented mainly by the frequency–wavenumber spectra and occasionally by the frequency–phase velocity spectra as well as being studied predominantly for periodic bi-layered media along and perpendicular to the thickness direction in the existing research. This paper investigates their comprehensive dispersion characteristics along arbitrary in-plane directions and in entire (low and high) frequency ranges, including the frequency–wavelength, wavenumber–phase velocity, wavelength–phase velocity spectra, the dispersion surfaces and the slowness curves with fixed frequencies, as well as the frequency–wavenumber and frequency–phase velocity spectra. Specially, the dispersion surfaces and the slowness curves completely reflect the propagation characteristics of in-plane waves along all directions. First, the method of reverberation-ray matrix (MRRM) combined with the Floquet theorem is extended to derive the dispersion equation of in-plane elastic waves in general periodic multilayered isotropic structures by means of the elastodynamic theory of isotropic materials and the state space formalism of layers. The correctness of the derivation and the numerical stability of the method in both low and high frequency ranges, particularly its superiority over the method of the transfer matrix (MTM) within the ranges near the cutoff frequencies, are verified by several numerical examples. From these demonstrations for periodic octal- and bi-layered media, the comprehensive dispersion curves are provided and their general characteristics are summarized. It is found that although the frequencies associated with the dimensionless wavenumber along thickness ( is an integer) are always the demarcation between pass and stop bands in the case of perpendicular incident wave, but this is not always exist in the case of the oblique incident wave due to the coupling between the two modes of in-plane elastic waves. The slowness curves with fixed frequencies of Floquet waves in periodically multilayered isotropic structures, as compared to their counterpart of body waves in infinite isotropic media obtained from the Christoffel equation now have periodicity along the thickness direction, which is consistent to the configuration of the structures. The slowness curves associated with higher frequencies have a smaller minimum positive period and have more propagation modes due to the cutoff properties of these additional modes. - Open Access
Band Tunability of Coupled Elastic Waves along Thickness in Laminated Anisotropic Piezoelectric Phononic Crystals
Although the passively adjusting and actively tuning of pure longitudinal (primary (P-)) and pure transverse (secondary or shear (S-)) waves band structures in periodically laminated piezoelectric composites have been studied, the actively tuning of coupled elastic waves (such as P-SV, P-SH, SV-SH, and P-SV-SH waves), particularly as the coupling of wave modes is attributed to the material anisotropy, in these phononic crystals remains an untouched topic. This paper presents the analytical matrix method for solving the dispersion characteristics of coupled elastic waves along the thickness direction in periodically multilayered piezoelectric composites consisting of arbitrarily anisotropic materials and applied by four kinds of electrical boundaries. By switching among these four electrical boundaries—the electric-open, the external capacitance, the electric-short, and the external feedback control—and by altering the capacitance/gain coefficient in cases of the external capacitance/feedback-voltage boundaries, the tunability of the band properties of the coupled elastic waves along layering thickness in the concerned phononic multilayered crystals are investigated. First, the state space formalism is introduced to describe the three-dimensional elastodynamics of arbitrarily anisotropic elastic and piezoelectric layers. Second, based on the traveling wave solutions to the state vectors of all constituent layers in the unit cell, the transfer matrix method is used to derive the dispersion equation of characteristic coupled elastic waves in the whole periodically laminated anisotropic piezoelectric composites. Finally, the numerical examples are provided to demonstrate the dispersion properties of the coupled elastic waves, with their dependence on the anisotropy of piezoelectric constituent layers being emphasized. The influences of the electrical boundaries and the electrode thickness on the band structures of various kinds of coupled elastic waves are also studied through numerical examples. One main finding is that the frequencies corresponding to (with the dimensionless characteristic wavenumber) are not always the demarcation between pass-bands and stop-bands for coupled elastic waves, although they are definitely the demarcation for pure P- and S-waves. The other main finding is that the coupled elastic waves are more sensitive to, if they are affected by, the electrical boundaries than the pure P- and S-wave modes, so that higher tunability efficiency should be achieved if coupled elastic waves instead of pure waves are exploited.Open AccessBand Tunability of Coupled Elastic Waves along Thickness in Laminated Anisotropic Piezoelectric Phononic Crystals
Although the passively adjusting and actively tuning of pure longitudinal (primary (P-)) and pure transverse (secondary or shear (S-)) waves band structures in periodically laminated piezoelectric composites have been studied, the actively tuning of coupled elastic waves (such as P-SV, P-SH, SV-SH, and P-SV-SH waves), particularly as the coupling of wave modes is attributed to the material anisotropy, in these phononic crystals remains an untouched topic. This paper presents the analytical matrix method for solving the dispersion characteristics of coupled elastic waves along the thickness direction in periodically multilayered piezoelectric composites consisting of arbitrarily anisotropic materials and applied by four kinds of electrical boundaries. By switching among these four electrical boundaries—the electric-open, the external capacitance, the electric-short, and the external feedback control—and by altering the capacitance/gain coefficient in cases of the external capacitance/feedback-voltage boundaries, the tunability of the band properties of the coupled elastic waves along layering thickness in the concerned phononic multilayered crystals are investigated. First, the state space formalism is introduced to describe the three-dimensional elastodynamics of arbitrarily anisotropic elastic and piezoelectric layers. Second, based on the traveling wave solutions to the state vectors of all constituent layers in the unit cell, the transfer matrix method is used to derive the dispersion equation of characteristic coupled elastic waves in the whole periodically laminated anisotropic piezoelectric composites. Finally, the numerical examples are provided to demonstrate the dispersion properties of the coupled elastic waves, with their dependence on the anisotropy of piezoelectric constituent layers being emphasized. The influences of the electrical boundaries and the electrode thickness on the band structures of various kinds of coupled elastic waves are also studied through numerical examples. One main finding is that the frequencies corresponding to (with the dimensionless characteristic wavenumber) are not always the demarcation between pass-bands and stop-bands for coupled elastic waves, although they are definitely the demarcation for pure P- and S-waves. The other main finding is that the coupled elastic waves are more sensitive to, if they are affected by, the electrical boundaries than the pure P- and S-wave modes, so that higher tunability efficiency should be achieved if coupled elastic waves instead of pure waves are exploited. - Open Access
Band Structures Analysis of Elastic Waves Propagating along Thickness Direction in Periodically Laminated Piezoelectric Composites
Existing studies on elastic waves in periodically laminated piezoelectric structures mainly concerned the passive band properties, since the electrical boundaries in the considered structures cannot vary. This paper investigates the tuning of band properties of uncoupled primary and shear (P- and S-) waves along the thickness direction by actively varying the electrical field in periodically multilayered piezoelectric structures consisting of orthotropic materials. The alteration of the electrical field is realized in the multilayered unit cell here by either applying or switching four kinds of electrical boundary conditions, including the electric-open, applied electric capacitance, electric-short, and applied feedback voltage, to the constituent piezoelectric layer via the constituent electrode layers covering both its surfaces. First, the state space formalism is introduced to obtain the partial wave solution of any constituent orthotropic layer in the unit cell. Second, the traditional transfer matrix method is adopted to derive the dispersion equation of general, periodically laminated piezoelectric composites with unit cells consisting of an arbitrary number of piezoelectric layers with various boundaries and of elastic layers. Third, numerical examples are provided to verify the proposed analysis method, and to study the influences of electrode thickness as well as four electrical boundaries on the band structures. All the frequency-related dispersion curves are also illustrated by numerical examples to summarize the general dispersion characteristics of uncoupled P- and S-waves in periodically laminated piezoelectric composites. The main finding is that the innovative dispersion characteristic resulting from the negative capacitance may also be achieved via feedback control.
Open AccessBand Structures Analysis of Elastic Waves Propagating along Thickness Direction in Periodically Laminated Piezoelectric Composites
Existing studies on elastic waves in periodically laminated piezoelectric structures mainly concerned the passive band properties, since the electrical boundaries in the considered structures cannot vary. This paper investigates the tuning of band properties of uncoupled primary and shear (P- and S-) waves along the thickness direction by actively varying the electrical field in periodically multilayered piezoelectric structures consisting of orthotropic materials. The alteration of the electrical field is realized in the multilayered unit cell here by either applying or switching four kinds of electrical boundary conditions, including the electric-open, applied electric capacitance, electric-short, and applied feedback voltage, to the constituent piezoelectric layer via the constituent electrode layers covering both its surfaces. First, the state space formalism is introduced to obtain the partial wave solution of any constituent orthotropic layer in the unit cell. Second, the traditional transfer matrix method is adopted to derive the dispersion equation of general, periodically laminated piezoelectric composites with unit cells consisting of an arbitrary number of piezoelectric layers with various boundaries and of elastic layers. Third, numerical examples are provided to verify the proposed analysis method, and to study the influences of electrode thickness as well as four electrical boundaries on the band structures. All the frequency-related dispersion curves are also illustrated by numerical examples to summarize the general dispersion characteristics of uncoupled P- and S-waves in periodically laminated piezoelectric composites. The main finding is that the innovative dispersion characteristic resulting from the negative capacitance may also be achieved via feedback control.