ARA. Ravi

A. Ravi

*This is an algorithmically generated author record based on publicly available information.

A. Ravi has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Optimizing Smart Grid System through Renewable Energy Sources and PID Controller Using Artificial Rabbits Optimized Neural Network

    by N.V. Selvam, A. Ravi, A. Justin Diraviam, R. Rajagopal

    The sporadic nature of today’s stochastic grid system and the influx of hybrid renewable resources make it susceptible to significant voltage changes. In smart microgrid networks, these variances are the main source of power quality problems. To address these issues, this manuscript proposes an effective approach that enhances the performance of the smart grid by utilizing Renewable Energy Sources (RES) in conjunction with a PID controller. The RES are Wind Turbine (WT), Photovoltaic (PV) and Battery. The primary objective of this work is to minimize the Integral Squared Error (ISE) and improve system performance. The Proposed approach uses an Artificial Rabbits Optimized Neural Network (ARONN) to predict the gain parameters of the PID controller and minimize error. The proposed ARONN method is implemented and validated using the MATLAB Simulink environment. The simulation outcomes show better performance and robustness of the proposed ARONN approach against existing approaches such as the Seagull Optimization Algorithm (SOA), Flying Foxes Optimization (FFO) and Radial Basis Functional Neural Network (RBFNN). The simulation results indicate that the proposed ARONN-based strategy achieves a settling time of 0.02[Formula: see text]s with minimal overshoot of 3% and undershoot of 2.7%, demonstrating superior system stability and responsiveness compared to existing approaches. In terms of efficiency, the proposed method reaches 95%, highlighting its enhanced performance over FFO, SOA and RBFNN.


  • Open Access

    High-Efficiency Converter with Voltage Doubling Capability for Solar Energy Applications Using Improved Optimization and Controller Shameema Sulthana J, Ravi A, Aandal R, Department of Electrical and Electronics Engineering, Francis Xavier Engineering College, Tamil Nadu, India

    by Ravi A, Shameema Sulthana J, Aandal R

    This research introduces and verifies a new type of DC to DC converter for harnessing solar photovoltaic power. The converter utilizes a parallel LC circuit powered by a generic buck converter, generating an AC link voltage that is rectified by a double rectifier to achieve voltage doubling. The system demonstrates significant voltage gain, producing an output voltage of up to 201 V from an 18 V input across a 100 Ohm resistive load, resulting in an output power of approximately 400 W and a conversion efficiency of around 85%. Additionally, the converter has been tested for charging electric vehicle batteries, with charging currents varying between 0.5 A and 2 A based on solar irradiance levels, showcasing its versatility. Additionally, the converter integrates a Proportional Integral Derivative-Second Derivative with Proportional Derivative (PIDD2-PD) controller for the purpose of optimising snow geese optimisation (ISGO) and implementing Maximum Power Point Tracking (MPPT). The typical input current, under ideal circumstances, is about 26 A. The suggested system, which has the inherent capacity to be used in systems connected to energy conversion and storage facilities, agrees well with the theoretical simulation findings of the small-signal ac models of the converters, the computer simulation, and the experimental validation.