MKMarcell Péter Kiss

Marcell Péter Kiss

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marcell Péter Kiss has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Tribology Application of Unpreloaded Mechanical Seal in Presence of MGS-1 Regolith

    by Marcell Péter Kiss, Gabor Zsolt Kalacska, Róbert Keresztes

    This study investigates the tribological performance of a dry-running mechanical face seal composed of a graphite rotating ring and a silicon carbide stationary ring under zero spring preload (SP0, 0 MPa), both in clean conditions and in the presence of Martian regolith simulant (MGS-1, particle size < 80 µm). Without preload, the contact between the seal faces relied solely on the intrinsic flatness of the components and the minimal assembly force. Under clean operation, the frictional torque exhibited an initial transient phase followed by a stable regime at approximately 0.017 Nm, indicating a low and steady frictional state characteristic of graphite–SiC pairs. After around 17 hours, the torque slightly increased to ~0.021 Nm, suggesting gradual surface adaptation or mild wear, yet maintaining stable operation throughout the 24-hour test. When exposed to the fine MGS-1 regolith, the torque increased markedly to ~0.070 Nm initially and gradually decreased to ~0.064 Nm, reflecting a polishing effect of entrained particles under minimal contact pressure. Scanning electron microscopy confirmed negligible damage on the SiC surface and only shallow grooves and embedded particles on the graphite ring, evidencing mild three-body abrasion. These results demonstrate that, although zero preload reduces sealing pressure and potential sealing integrity, it enables highly stable and low-energy operation with minimal wear when particulate ingress is limited. The findings suggest that under Martian-like dusty conditions, a near-zero preload configuration may provide a favorable balance between friction stability and material preservation in low-pressure sealing applications.

  • Open Access

    Tribological performance of mechanical face seals for Martian applications

    by Péter Marcell Kiss, Gábor Kalácska, Róbert Zsolt Keresztes, Zoltán Károly

    This study examines the tribological performance of dry-running mechanical face seals composed of a graphite rotating ring and a silicon carbide stationary ring under varying contact pressure conditions from 0.23 to 0.83 MPa), both in clean operation and in the presence of a Martian regolith simulant (MGS-1, PR < 80 μm). Three preload levels were applied: zero preload (SP0), nominal preload (SP1), and double preload (SP2), based on a calibrated spring characteristic and contact area analysis. Under clean conditions, increasing preload elevated frictional torque from ~ 0.017 Nm (SP0) to ~ 0.030 Nm (SP1) and ~ 0.070 Nm (SP2), indicating a direct correlation between contact pressure and interfacial shear. When MGS-1 regolith simulant was introduced, torque increased significantly in all configurations, reaching ~ 0.064 Nm (SP0MGS-1), ~ 0.082 Nm (SP1MGS-1), and ~ 0.095 Nm (SP2MGS-1). Real-time monitoring of torque and axial force enabled the calculation of dynamic friction forces and coefficients of friction, which revealed that contact pressure strongly influenced wear mechanisms: higher contact pressure enhanced interface conformity but accelerated abrasive degradation, while lower contact pressure reduced wear at the expense of sealing pressure. Scanning electron microscopy (SEM) confirmed the presence of abrasive grooves and embedded particles exclusively on the graphite ring, with no perceivable damage on the SiC counterface. The results demonstrate that nominal contact pressure (SP1) provides the most favorable balance between friction stability, wear resistance, and sealing reliability, offering valuable insights for the design of mechanical seals in particulate-laden environments such as Martian surface operations.