Yuan Fang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yuan Fang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Xuefeng Guo
Key Laboratory of National Forestry and Grassland Administration on Bamboo & Rattan Science and Technology, International Center for Bamboo & Rattan, Beijing 100102, China
4 shared publications - Wenting Song
Key Laboratory of National Forestry and Grassland Administration on Bamboo & Rattan Science and Technology, International Center for Bamboo & Rattan, Beijing 100102, China
3 shared publications - Chunjuan Zhang
Key Laboratory of National Forestry and Grassland Administration on Bamboo & Rattan Science and Technology, International Center for Bamboo & Rattan, Beijing 100102, China
1 shared publication - Ting Yuan
Key Laboratory of National Forestry and Grassland Administration on Bamboo & Rattan Science and Technology, International Center for Bamboo & Rattan, Beijing 100102, China
1 shared publication
Latest Publications
- Open Access
- 25 October 2026
- Published by MDPI AG in Fermentation
- Vol. 12 (11) , 495
Polyhydroxyalkanoate Production from Bamboo Residues: Saccharification, Fermentation and Process Feasibility
Bamboo residues are a potential sugar source for polyhydroxyalkanoate (PHA) production, yet their suitability depends on the coupling of saccharification, microbial conversion and polymer recovery. This critical narrative review examined bamboo composition and pretreatment, direct PHA experiments and comparative evidence from other lignocellulosic feeds. It focused on enzymatic sugar hydrolysates, with lignin-rich pretreatment liquor considered separately. Bamboo studies demonstrated substantial tissue-dependent variation and production of concentrated glucose–xylose streams. Four related Halomonas studies established PHA production from selected bamboo-derived feeds, mainly in liquor-based, mixed-carbon or split-vessel configurations. Their results supported further sugar-hydrolysate development but did not validate a recovery-inclusive process across heterogeneous residues. Comparative experiments identified strain-specific pentose uptake, matrix tolerance and nutrient-dependent polymer accumulation as major selection criteria. Carbohydrate retention, conditioning losses and feeding strategy were more informative than maximum residual-solid digestibility alone. Recovery methods and selective cultivation introduced additional resource and product-quality trade-offs, while agricultural valorization of the separated liquor remained conditional. The central development need is to connect representative residue batches to sugar consumption, sustained PHA production and recovered material of specified quality. Economic and environmental assessments should use these linked measurements rather than isolated conversion maxima.
- 25 October 2026
- Published by MDPI AG in Fermentation
- Vol. 12 (11) , 495
Open AccessPolyhydroxyalkanoate Production from Bamboo Residues: Saccharification, Fermentation and Process Feasibility
Bamboo residues are a potential sugar source for polyhydroxyalkanoate (PHA) production, yet their suitability depends on the coupling of saccharification, microbial conversion and polymer recovery. This critical narrative review examined bamboo composition and pretreatment, direct PHA experiments and comparative evidence from other lignocellulosic feeds. It focused on enzymatic sugar hydrolysates, with lignin-rich pretreatment liquor considered separately. Bamboo studies demonstrated substantial tissue-dependent variation and production of concentrated glucose–xylose streams. Four related Halomonas studies established PHA production from selected bamboo-derived feeds, mainly in liquor-based, mixed-carbon or split-vessel configurations. Their results supported further sugar-hydrolysate development but did not validate a recovery-inclusive process across heterogeneous residues. Comparative experiments identified strain-specific pentose uptake, matrix tolerance and nutrient-dependent polymer accumulation as major selection criteria. Carbohydrate retention, conditioning losses and feeding strategy were more informative than maximum residual-solid digestibility alone. Recovery methods and selective cultivation introduced additional resource and product-quality trade-offs, while agricultural valorization of the separated liquor remained conditional. The central development need is to connect representative residue batches to sugar consumption, sustained PHA production and recovered material of specified quality. Economic and environmental assessments should use these linked measurements rather than isolated conversion maxima.
- Open Access
- 24 August 2026
- Published by MDPI AG in Fermentation
- Vol. 12 (9) , 397
Fermentative Production of Poly(β-L-malic Acid) from Renewable Feedstocks: Process Advances and Bamboo Shoot Shell Hydrolysate as an Emerging Case Study
Poly(β-L-malic acid) (PMLA) is a water-soluble, biodegradable aliphatic polyester whose pendant carboxyl groups support chemical functionalization for biomedical, packaging, and materials applications. Microbial fermentation can use pure sugars and biomass-derived carbon sources under mild conditions, but industrial translation remains constrained by feedstock cost and variability, strain performance, oxygen and pH control, pretreatment-derived inhibitors, and downstream recovery. This review therefore focuses on the fermentative production of PMLA from refined and renewable carbon sources, the microorganisms and metabolic routes involved, and the process variables that govern titer, yield, productivity, molecular weight, and purification. Agricultural and forestry feedstocks are compared according to their actual carbohydrate class and processing requirements. Bamboo shoot shell hydrolysate is treated as an emerging case study rather than an established production platform: one accepted shake-flask study directly demonstrated PMLA production by Aureobasidium pullulans NRRL Y-2311-1, but controlled bioreactor validation, reproducibility, techno-economic analysis, and application-specific product qualification remain to be further investigated. The review also examines autohydrolysis, low-molecular-weight PMLA for biomedical use, furan inhibition, membrane and ion-exchange purification, and the limits of current economic comparisons. This evidence-based framing identifies where bamboo-processing residues may contribute to renewable PMLA production while distinguishing laboratory feasibility from industrial readiness.
- 24 August 2026
- Published by MDPI AG in Fermentation
- Vol. 12 (9) , 397
Open AccessFermentative Production of Poly(β-L-malic Acid) from Renewable Feedstocks: Process Advances and Bamboo Shoot Shell Hydrolysate as an Emerging Case Study
Poly(β-L-malic acid) (PMLA) is a water-soluble, biodegradable aliphatic polyester whose pendant carboxyl groups support chemical functionalization for biomedical, packaging, and materials applications. Microbial fermentation can use pure sugars and biomass-derived carbon sources under mild conditions, but industrial translation remains constrained by feedstock cost and variability, strain performance, oxygen and pH control, pretreatment-derived inhibitors, and downstream recovery. This review therefore focuses on the fermentative production of PMLA from refined and renewable carbon sources, the microorganisms and metabolic routes involved, and the process variables that govern titer, yield, productivity, molecular weight, and purification. Agricultural and forestry feedstocks are compared according to their actual carbohydrate class and processing requirements. Bamboo shoot shell hydrolysate is treated as an emerging case study rather than an established production platform: one accepted shake-flask study directly demonstrated PMLA production by Aureobasidium pullulans NRRL Y-2311-1, but controlled bioreactor validation, reproducibility, techno-economic analysis, and application-specific product qualification remain to be further investigated. The review also examines autohydrolysis, low-molecular-weight PMLA for biomedical use, furan inhibition, membrane and ion-exchange purification, and the limits of current economic comparisons. This evidence-based framing identifies where bamboo-processing residues may contribute to renewable PMLA production while distinguishing laboratory feasibility from industrial readiness.
- Open Access
Characterization and Tentative Annotation of Flavonoid Glycosides in a Flavonoid-Enriched Fraction from Bambusa textilis Leaves by UHPLC-ESI-Q-TOF-MS/MS
Bamboo leaves contain structurally diverse flavonoid glycosides; whereas, compound-level information for Bambusa textilis remains limited. In this study, a flavonoid-enriched 40% ethanol fraction prepared from B. textilis leaves by petroleum-ether partitioning and AB-8 resin adsorption was analyzed by ultra-high-performance liquid chromatography coupled with electrospray ionization quadrupole time-of-flight tandem mass spectrometry (UHPLC-ESI-Q-TOF-MS/MS) in negative-ion mode. Retention times and MS/MS spectra were compared with seven in-house reference standards, while the remaining constituents were annotated from accurate-mass measurements, diagnostic product ions, fragmentation behavior, and data from the literature. According to Metabolomics Standards Initiative criteria, seven compounds were assigned at Level 1 and twenty-four were reported as Level 3 annotations because their exact positional structures were not confirmed by additional standards or NMR. Thirty-one flavonoid-related constituents were annotated in the analyzed fraction, encompassing six glycoside classes; most annotations, by count, were apigenin- or luteolin-derived. These annotations add compound-level information for the analyzed B. textilis fraction and allow qualitative comparison with other bamboo flavonoid profiles. Because the sample was selectively enriched, the results do not describe the complete leaf metabolome or compound concentrations. Additional standards or NMR analysis are needed to confirm the glycosylation positions of tentatively annotated compounds.
Open AccessCharacterization and Tentative Annotation of Flavonoid Glycosides in a Flavonoid-Enriched Fraction from Bambusa textilis Leaves by UHPLC-ESI-Q-TOF-MS/MS
Bamboo leaves contain structurally diverse flavonoid glycosides; whereas, compound-level information for Bambusa textilis remains limited. In this study, a flavonoid-enriched 40% ethanol fraction prepared from B. textilis leaves by petroleum-ether partitioning and AB-8 resin adsorption was analyzed by ultra-high-performance liquid chromatography coupled with electrospray ionization quadrupole time-of-flight tandem mass spectrometry (UHPLC-ESI-Q-TOF-MS/MS) in negative-ion mode. Retention times and MS/MS spectra were compared with seven in-house reference standards, while the remaining constituents were annotated from accurate-mass measurements, diagnostic product ions, fragmentation behavior, and data from the literature. According to Metabolomics Standards Initiative criteria, seven compounds were assigned at Level 1 and twenty-four were reported as Level 3 annotations because their exact positional structures were not confirmed by additional standards or NMR. Thirty-one flavonoid-related constituents were annotated in the analyzed fraction, encompassing six glycoside classes; most annotations, by count, were apigenin- or luteolin-derived. These annotations add compound-level information for the analyzed B. textilis fraction and allow qualitative comparison with other bamboo flavonoid profiles. Because the sample was selectively enriched, the results do not describe the complete leaf metabolome or compound concentrations. Additional standards or NMR analysis are needed to confirm the glycosylation positions of tentatively annotated compounds.
- Open Access
- 24 July 2026
- Published by MDPI AG in Separations
- Vol. 13 (8) , 209
Optimization of the Purification Process for C-Glycosyl Flavones from Phyllostachys edulis Leaves
A preparative purification process was developed for the enrichment of four C-glycosyl flavones from leaves of Phyllostachys edulis (Carrière) J.Houz., namely orientin, isoorientin, vitexin, and isovitexin. The crude P. edulis leaf extract was used as the feed material, and HPLC was employed for quantitative analysis. Macroporous resins and polyamide resins were compared in terms of their adsorption and desorption performance toward the target compounds. The results showed that D101 macroporous resin provided the best overall process suitability among the tested resins. The optimal purification conditions were an initial sample concentration of 10 mg·mL−1, a resin-to-sample loading ratio of 5:1 (g·g−1), a sample-loading flow rate of 4 BV·h−1, impurity removal with 15% ethanol, elution with 60% ethanol, an elution volume of 3 BV, and a 60% ethanol elution flow rate of 3 BV·h−1. After D101 resin purification, the yield of the four C-glycosyl flavones was 11.712 mg·g−1 relative to the crude extract, and their combined content in the D101-purified flavonoid-enriched powder reached 68.359 mg·g−1. Further purification using polyamide resin with a particle-size range of 0.15–0.25 mm and 40% ethanol resulted in the recovery of 16.128 mg·g−1 of the four C-glycosyl flavones relative to the D101-purified feed material, while their combined content in the polyamide-purified flavonoid-enriched powder reached 76.939 mg·g−1. This process provides a basis for the preparative separation and utilization of C-glycosyl flavones from P. edulis leaves.
- 24 July 2026
- Published by MDPI AG in Separations
- Vol. 13 (8) , 209
Open AccessOptimization of the Purification Process for C-Glycosyl Flavones from Phyllostachys edulis Leaves
A preparative purification process was developed for the enrichment of four C-glycosyl flavones from leaves of Phyllostachys edulis (Carrière) J.Houz., namely orientin, isoorientin, vitexin, and isovitexin. The crude P. edulis leaf extract was used as the feed material, and HPLC was employed for quantitative analysis. Macroporous resins and polyamide resins were compared in terms of their adsorption and desorption performance toward the target compounds. The results showed that D101 macroporous resin provided the best overall process suitability among the tested resins. The optimal purification conditions were an initial sample concentration of 10 mg·mL−1, a resin-to-sample loading ratio of 5:1 (g·g−1), a sample-loading flow rate of 4 BV·h−1, impurity removal with 15% ethanol, elution with 60% ethanol, an elution volume of 3 BV, and a 60% ethanol elution flow rate of 3 BV·h−1. After D101 resin purification, the yield of the four C-glycosyl flavones was 11.712 mg·g−1 relative to the crude extract, and their combined content in the D101-purified flavonoid-enriched powder reached 68.359 mg·g−1. Further purification using polyamide resin with a particle-size range of 0.15–0.25 mm and 40% ethanol resulted in the recovery of 16.128 mg·g−1 of the four C-glycosyl flavones relative to the D101-purified feed material, while their combined content in the polyamide-purified flavonoid-enriched powder reached 76.939 mg·g−1. This process provides a basis for the preparative separation and utilization of C-glycosyl flavones from P. edulis leaves.