Yi Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yi Zhang has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Hanqing Xu
Chemical Defense Institute, Academy of Military Sciences, Beijing 102205, China
2 shared publications Hao Chen
State Key Laboratory of Chemistry for NBC Hazards Protection, Beijing 102205, China
2 shared publicationsLiang Zhou
State Key Laboratory of Chemistry for NBC Hazards Protection, Beijing 102205, China
2 shared publicationsWenlian Peng
State Key Laboratory of Chemistry for NBC Hazards Protection, Beijing 102205, China
2 shared publicationsXinggao Zhang
State Key Laboratory of Chemistry for NBC Hazards Protection, Beijing 102205, China
2 shared publications- Zhihua Zhuang
Chemical Defense Institute, Academy of Military Sciences, Beijing 102205, China
2 shared publications
Latest Publications
- Open Access
Spheroidization Behavior of TiZrNbTa Refractory High-Entropy Alloy Powder During Radio Frequency Plasma Processing
Spherical TiZrNbTa refractory high-entropy alloy powders with uniform composition and good flowability are essential feedstock for powder-based additive manufacturing; however, irregular powders produced by the hydrogenation-dehydrogenation route generally require further shaping treatment. Radio frequency (RF) plasma spheroidization of TiZrNbTa refractory high-entropy alloy powders prepared by hydrogenation-dehydrogenation (HDH) was investigated at a fixed power of 12 kW. Fine (10–40 μm) and coarse (40–70 μm) powders were compared at 5.0 g/min, followed by feed-rate tests (2.5–7.5 g/min) on the coarse fraction. At 5.0 g/min, the spheroidization degrees of the fine and coarse powders were 45.33% and 50.88%, respectively. The fine powder exhibited satellite particles and a broadened particle-size distribution, whereas the coarse powder retained some irregular particles. Decreasing the coarse-powder feed rate from 7.5 to 2.5 g/min increased the spheroidization degree from 45.71% to 94.55%, with median particle size (D50) reaching 56.84 μm and a narrower particle-size distribution. The powders retained predominantly body-centered cubic (BCC) diffraction signatures, while dendritic substructures and local Ta/Zr segregation varied with processing conditions. Testing showed that untreated coarse HDH powder did not flow unaided through a Hall funnel, whereas the 5.0 g/min spheroidized product flowed in 18.7 s/50 g; after spheroidization, its loose bulk density increased from 4.68 to 5.47 g/cm3. These results clarify the effects of particle size and powder feed rate on spheroidization behavior within the investigated conditions.
Open AccessSpheroidization Behavior of TiZrNbTa Refractory High-Entropy Alloy Powder During Radio Frequency Plasma Processing
Spherical TiZrNbTa refractory high-entropy alloy powders with uniform composition and good flowability are essential feedstock for powder-based additive manufacturing; however, irregular powders produced by the hydrogenation-dehydrogenation route generally require further shaping treatment. Radio frequency (RF) plasma spheroidization of TiZrNbTa refractory high-entropy alloy powders prepared by hydrogenation-dehydrogenation (HDH) was investigated at a fixed power of 12 kW. Fine (10–40 μm) and coarse (40–70 μm) powders were compared at 5.0 g/min, followed by feed-rate tests (2.5–7.5 g/min) on the coarse fraction. At 5.0 g/min, the spheroidization degrees of the fine and coarse powders were 45.33% and 50.88%, respectively. The fine powder exhibited satellite particles and a broadened particle-size distribution, whereas the coarse powder retained some irregular particles. Decreasing the coarse-powder feed rate from 7.5 to 2.5 g/min increased the spheroidization degree from 45.71% to 94.55%, with median particle size (D50) reaching 56.84 μm and a narrower particle-size distribution. The powders retained predominantly body-centered cubic (BCC) diffraction signatures, while dendritic substructures and local Ta/Zr segregation varied with processing conditions. Testing showed that untreated coarse HDH powder did not flow unaided through a Hall funnel, whereas the 5.0 g/min spheroidized product flowed in 18.7 s/50 g; after spheroidization, its loose bulk density increased from 4.68 to 5.47 g/cm3. These results clarify the effects of particle size and powder feed rate on spheroidization behavior within the investigated conditions.
- 14 September 2026
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 28 (35) , 5068-5080
Molecular dynamics study of NTO acidity suppression via NTO/ANPyO co-crystallization
A co-crystal of NTO/ANPyO is studied via MD simulations and DFT, to verify if co-crystallisation shortens the N4–H4 bond in NTO and calculates the p K a , showing a weakening of its acidity. Co-crystal formation, stability at different molar ratios, mechanical, and detonation properties are evaluated.
- 14 September 2026
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 28 (35) , 5068-5080
Molecular dynamics study of NTO acidity suppression via NTO/ANPyO co-crystallization
A co-crystal of NTO/ANPyO is studied via MD simulations and DFT, to verify if co-crystallisation shortens the N4–H4 bond in NTO and calculates the p K a , showing a weakening of its acidity. Co-crystal formation, stability at different molar ratios, mechanical, and detonation properties are evaluated.
- 25 June 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (26) , 18865-18879
Molecular Dynamics Simulation of NTO/TNPyO Co-Crystals for Targeted Acidity Regulation of NTO
3-Nitro-1,2,4-triazol-5-one (NTO) exhibits acid corrosion due to facile proton dissociation at the N4 site (pKa = 3.76), limiting practical applications. To mitigate this, we cocrystallized NTO with 2,4,6-trinitropyridine 1-oxide (TNPyO) using MATERIALS STUDIO 2023 software across stoichiometric ratios from 4:1 to 1:4. Supercell models for NTO/TNPyO were constructed. We employed the density functional theory and molecular dynamics methods to simulate the possibility of the existence of the cocrystal and analyze the intermolecular forces and variation in N4–H4 bond length in NTO. The stability, mechanical properties, and other characteristics of cocrystals were predicted. The study focused on reinforcing intermolecular hydrogen bonding to stabilize the N4–H4 group, raising the proton dissociation energy barrier, and inhibiting H+ release. This strategy resulted in a 2.8-unit pKa increase for the cocrystal compared to that of pure NTO, thereby attenuating NTO acidity. The detonation performance and products for pure NTO, TNPyO, and the cocrystal system were predicted with EXPLO-5 software. The results demonstrate interactions between NTO and TNPyO molecules, indicating cocrystal formation potential with an optimal 2:1 molar ratio, where the cocrystal shortens the N4–H4 bond length to enhance stability, prevents proton ionization, and suppresses acidity primarily through hydrogen bonding (validated statistically), electrostatic interactions, dispersion, and van der Waals forces; they have the potential to become novel noncorrosive, insensitive energetic materials that maintain low sensitivity and excellent mechanical and detonation properties.
- 25 June 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (26) , 18865-18879
Molecular Dynamics Simulation of NTO/TNPyO Co-Crystals for Targeted Acidity Regulation of NTO
3-Nitro-1,2,4-triazol-5-one (NTO) exhibits acid corrosion due to facile proton dissociation at the N4 site (pKa = 3.76), limiting practical applications. To mitigate this, we cocrystallized NTO with 2,4,6-trinitropyridine 1-oxide (TNPyO) using MATERIALS STUDIO 2023 software across stoichiometric ratios from 4:1 to 1:4. Supercell models for NTO/TNPyO were constructed. We employed the density functional theory and molecular dynamics methods to simulate the possibility of the existence of the cocrystal and analyze the intermolecular forces and variation in N4–H4 bond length in NTO. The stability, mechanical properties, and other characteristics of cocrystals were predicted. The study focused on reinforcing intermolecular hydrogen bonding to stabilize the N4–H4 group, raising the proton dissociation energy barrier, and inhibiting H+ release. This strategy resulted in a 2.8-unit pKa increase for the cocrystal compared to that of pure NTO, thereby attenuating NTO acidity. The detonation performance and products for pure NTO, TNPyO, and the cocrystal system were predicted with EXPLO-5 software. The results demonstrate interactions between NTO and TNPyO molecules, indicating cocrystal formation potential with an optimal 2:1 molar ratio, where the cocrystal shortens the N4–H4 bond length to enhance stability, prevents proton ionization, and suppresses acidity primarily through hydrogen bonding (validated statistically), electrostatic interactions, dispersion, and van der Waals forces; they have the potential to become novel noncorrosive, insensitive energetic materials that maintain low sensitivity and excellent mechanical and detonation properties.