Kwangseok Choi
Research Subjects
Kwangseok Choi has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Wookyung Kim
2 shared publications- Yuki Osada2 shared publications
Minhyeok Lee
1 shared publication- Mizuki Shoyama
Electrical Safety Research Group, JNIOSH, Tokyo, Japan
1 shared publication Ryosuke Inoue
1 shared publicationTakeshi Matsunaga
1 shared publication
Latest Publications
- Open Access
- 4 October 2026
- Published by Elsevier in Advanced Powder Technology
- Vol. 37 (11)
Effect of pipe-end geometry on powder charging and electrostatic discharge in a silo
- 4 October 2026
- Published by Elsevier in Advanced Powder Technology
- Vol. 37 (11)
Open AccessEffect of pipe-end geometry on powder charging and electrostatic discharge in a silo
- 26 September 2026
- Published by Elsevier in Advanced Powder Technology
- Vol. 37 (11)
Electrostatic discharges from workwear worn by a worker near a highly charged Type-A flexible intermediate bulk container
- 26 September 2026
- Published by Elsevier in Advanced Powder Technology
- Vol. 37 (11)
Electrostatic discharges from workwear worn by a worker near a highly charged Type-A flexible intermediate bulk container
- Open Access
- 16 August 2026
- Published by Elsevier in SSRN Electronic Journal
Minimum Explosible Concentration of Aluminum Powder in O2–CO2 Atmospheres
This study investigated the minimum explosible concentration (MEC) of aluminum powder in O2–CO2 atmospheres using a modified 1.2 L Hartmann explosion tube based on Japanese Industrial Standards. Aluminum powder with a median particle diameter of 22.17 μm was tested at O2 concentrations from 5 to 50 vol%, and the results were compared with those obtained in O₂–N₂ atmospheres. The MEC of the Al–O2–CO2 mixtures decreased with increasing O2 concentration. Under oxygen-lean conditions, explosions were observed even at lower O2 concentrations than those reported for O2–N2 mixtures, indicating that CO2 cannot be treated as an inert diluent for aluminum dust. When the MEC was expressed in terms of equivalence ratio by considering CO2 as an oxidizer, the Al–O2–CO2 mixtures exhibited higher explosibility than the corresponding Al–O2–N2 mixtures. Equilibrium and one-dimensional flame calculations suggested that CO2-mediated reactions promote the formation of AlO and help sustain heat release and a broadened reaction zone under oxygen-deficient conditions. These findings indicate that CO2 can enhance the explosibility of aluminum dust under oxygen-lean atmospheres and should be considered in explosion risk assessment.
- 16 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMinimum Explosible Concentration of Aluminum Powder in O2–CO2 Atmospheres
This study investigated the minimum explosible concentration (MEC) of aluminum powder in O2–CO2 atmospheres using a modified 1.2 L Hartmann explosion tube based on Japanese Industrial Standards. Aluminum powder with a median particle diameter of 22.17 μm was tested at O2 concentrations from 5 to 50 vol%, and the results were compared with those obtained in O₂–N₂ atmospheres. The MEC of the Al–O2–CO2 mixtures decreased with increasing O2 concentration. Under oxygen-lean conditions, explosions were observed even at lower O2 concentrations than those reported for O2–N2 mixtures, indicating that CO2 cannot be treated as an inert diluent for aluminum dust. When the MEC was expressed in terms of equivalence ratio by considering CO2 as an oxidizer, the Al–O2–CO2 mixtures exhibited higher explosibility than the corresponding Al–O2–N2 mixtures. Equilibrium and one-dimensional flame calculations suggested that CO2-mediated reactions promote the formation of AlO and help sustain heat release and a broadened reaction zone under oxygen-deficient conditions. These findings indicate that CO2 can enhance the explosibility of aluminum dust under oxygen-lean atmospheres and should be considered in explosion risk assessment.
- Open Access
- 1 July 2026
- Published by Elsevier in SSRN Electronic Journal
Effect of Energy Stored in Capacitors on Pressure of Weak Shock Waves Induced by Polarity-Reversing Spark Discharges Between Needle-to-Needle Electrodes and Approximate Formulas for the Pressure
The effects of capacitor charging energy on the Mach number and overpressure characteristics of weak shock waves induced by positive- and negative-polarity spark discharges between needle-to-needle electrodes were experimentally investigated. The spark discharges were generated in compliance with the European Standard and the International Electrotechnical Commission standard for the minimum ignition energy of dust explosions. The results revealed that weak shock waves with Mach number greater than 1 were generated at charging energies greater than or equal to 30 mJ for both polarities. The overpressure waveforms exhibited similar characteristics at each charging energy for both polarities because the discharge energies responsible for shock wave generation, calculated from the voltage and current waveforms, were comparable and because the voltage and current waveforms themselves were similar during the polarity-reversing discharges. The Mach number and peak overpressure increased with increasing charging energy because the discharge energy released also increased. An experimental formula for the peak overpressure as a function of energy density was developed for the conditions of this study, and the absolute error between the calculated and measured values was within 5.00%. Furthermore, approximate formulas that ensure dimensional consistency with the pressure were developed by considering the maximum of the time derivative of the discharge energy. The absolute error of the approximate formulas was less than 2.00%. These results indicate that the proposed formulas are effective for predicting weak shock wave pressures generated by polarity-reversing spark discharges between electrodes with opposing needles.
- 1 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEffect of Energy Stored in Capacitors on Pressure of Weak Shock Waves Induced by Polarity-Reversing Spark Discharges Between Needle-to-Needle Electrodes and Approximate Formulas for the Pressure
The effects of capacitor charging energy on the Mach number and overpressure characteristics of weak shock waves induced by positive- and negative-polarity spark discharges between needle-to-needle electrodes were experimentally investigated. The spark discharges were generated in compliance with the European Standard and the International Electrotechnical Commission standard for the minimum ignition energy of dust explosions. The results revealed that weak shock waves with Mach number greater than 1 were generated at charging energies greater than or equal to 30 mJ for both polarities. The overpressure waveforms exhibited similar characteristics at each charging energy for both polarities because the discharge energies responsible for shock wave generation, calculated from the voltage and current waveforms, were comparable and because the voltage and current waveforms themselves were similar during the polarity-reversing discharges. The Mach number and peak overpressure increased with increasing charging energy because the discharge energy released also increased. An experimental formula for the peak overpressure as a function of energy density was developed for the conditions of this study, and the absolute error between the calculated and measured values was within 5.00%. Furthermore, approximate formulas that ensure dimensional consistency with the pressure were developed by considering the maximum of the time derivative of the discharge energy. The absolute error of the approximate formulas was less than 2.00%. These results indicate that the proposed formulas are effective for predicting weak shock wave pressures generated by polarity-reversing spark discharges between electrodes with opposing needles.