Lucas Moura Barbosa Eiras
Lucas Moura Barbosa Eiras has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Carlos Maurício Fontes Vieira
Universidade Estadual do Norte Fluminense Darcy Ribeiro, Brasil
1 shared publication - Felipe Perissé Duarte Lopes
Universidade Estadual do Norte Fluminense Darcy Ribeiro
1 shared publication - Neide Pena Coto
Full Professor, Maxillofacial Surgery, Prostheses Traumatology Department, School of Dentistry, University of São Paulo (USP), São Paulo, SP, Brazil
1 shared publication - Noan Tonini Simonassi
Advanced Materials Laboratory, State University of the North of Rio de Janeiro Darcy Ribeiro—UENF, Av Alberto Lamego, 2000, Campos dos Goytacazes 28013-602, RJ, Brazil
1 shared publication - Patrick Martins Barbosa Brito1 shared publication
- Thayna Pereira Rangel
State University of the Northern Rio de Janeiro—UENF Campos dos Goytacazes RJ Brazil
1 shared publication
Latest Publications
- Open Access
- 3 July 2026
- Published by Lecturas: Educacion Fisica y Deportes in Lecturas: Educación Física y Deportes
- Vol. 31 (338) , 130-148
Activity-Based Costing for 3D printing Mouthguard: a test comparing FDM, SLA with thermoforming
Objective: To evaluate the operational cost feasibility and comparative economic performance per unit of producing a mouthguard for the patient using 3D printing (3DP) and compared to conventional methods. Materials and methods: The costs and energy consumption of each method were analyzed, including thermoplastic fabrication and the 3D printers FDM and SLA, using activity-based costing (ABC) to identify and calculate the necessary resources. Results: Thermoplastic fabrication exhibited the lowest cost due to the short operation time, while SLA stood out for its energy efficiency and precision, enabling large-scale production and reducing errors, albeit at a higher initial cost. Conclusion: 3D printing, particularly with FDM, has proven to be a promising and precise alternative, with the potential to replace the conventional method in the long term, offering greater customization, quality, and safety in the development of personalized mouthguards for Sports Dentistry.
- 3 July 2026
- Published by Lecturas: Educacion Fisica y Deportes in Lecturas: Educación Física y Deportes
- Vol. 31 (338) , 130-148
Open AccessActivity-Based Costing for 3D printing Mouthguard: a test comparing FDM, SLA with thermoforming
Objective: To evaluate the operational cost feasibility and comparative economic performance per unit of producing a mouthguard for the patient using 3D printing (3DP) and compared to conventional methods. Materials and methods: The costs and energy consumption of each method were analyzed, including thermoplastic fabrication and the 3D printers FDM and SLA, using activity-based costing (ABC) to identify and calculate the necessary resources. Results: Thermoplastic fabrication exhibited the lowest cost due to the short operation time, while SLA stood out for its energy efficiency and precision, enabling large-scale production and reducing errors, albeit at a higher initial cost. Conclusion: 3D printing, particularly with FDM, has proven to be a promising and precise alternative, with the potential to replace the conventional method in the long term, offering greater customization, quality, and safety in the development of personalized mouthguards for Sports Dentistry.