Yu Wang
Research Subjects
Yu Wang has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Kiju Lee
Department of Engineering Technology and Industrial Distribution, Texas A&M University, College Station, TX 77840, USA
3 shared publications - Morgan Brian Farnell
Department of Poultry Science, Texas A&M AgriLife Research, College Station, TX 77843, USA
3 shared publications - Ziteng Xu
Department of Poultry Science, Texas A&M University, College Station, TX 77843, USA
3 shared publications - Ziyuan Zhao
Department of Poultry Science, Texas A&M University, College Station, TX 77843, USA
3 shared publications - Giridhar Athrey
Texas A&M University
2 shared publications - Gregory J. Archer
Department of Geology, University of Maryland, College Park, MD 20742, USA
2 shared publications
Latest Publications
- Open Access
- 27 August 2026
- Published by Elsevier in SSRN Electronic Journal
Deep learning-guided evaluation of broiler preference for a novel non-perforated grooved flooring system
Flooring design plays a critical role in broiler welfare, hygiene, and productionefficiency. To address the limitations of conventional litter and perforated flooring systems, a non-perforated grooved floor combined with robotic cleaning has been developed.However, it remains unclear whether groove width influences broiler occupancybehavior and, consequently, the engineering design of the flooring system. This studydeveloped a computer vision framework to quantify broiler spatial distribution andevaluate whether groove width influences floor preference throughout a six-weekproduction cycle. Eighty day-old male broilers (Yield Plus × Ross 708) were reared in a6 ft × 18 ft floor pen with voluntary access to 3 semicircular groove widths (one-quarter,three-eighths, and one-half inch). Broiler occupancy was quantified from overheadRGB videos using a YOLO11-based detection framework and analyzed using a dailyoccupancy rate over both the full pen and an edge-removed region to account foredge-huddling behaviors. A detector trained on images spanning across all growthstages outperformed age-specific models, indicating the advantage of incorporatingmorphological diversity throughout the production cycle. Feeder and drinker occupancymoderately predicted bird distribution within the edge-removed region (R2 = 0.592) butnot the full pen (R2 = 0.037), where perimeter congregation dominated. Broilersexhibited no significant preference among the three groove widths (p > 0.05), and thislack of preference remained consistent throughout the production cycle. These findingsindicate that groove width can be selected primarily according to engineeringconsiderations, such as higher feces holding capacity and cleaning efficiency, withoutadversely affecting broiler occupancy. The proposed computer vision frameworkprovides an automated and scalable approach for evaluating livestock housing designsand supports the development of robotic-cleanable poultry production systems.
- 27 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDeep learning-guided evaluation of broiler preference for a novel non-perforated grooved flooring system
Flooring design plays a critical role in broiler welfare, hygiene, and productionefficiency. To address the limitations of conventional litter and perforated flooring systems, a non-perforated grooved floor combined with robotic cleaning has been developed.However, it remains unclear whether groove width influences broiler occupancybehavior and, consequently, the engineering design of the flooring system. This studydeveloped a computer vision framework to quantify broiler spatial distribution andevaluate whether groove width influences floor preference throughout a six-weekproduction cycle. Eighty day-old male broilers (Yield Plus × Ross 708) were reared in a6 ft × 18 ft floor pen with voluntary access to 3 semicircular groove widths (one-quarter,three-eighths, and one-half inch). Broiler occupancy was quantified from overheadRGB videos using a YOLO11-based detection framework and analyzed using a dailyoccupancy rate over both the full pen and an edge-removed region to account foredge-huddling behaviors. A detector trained on images spanning across all growthstages outperformed age-specific models, indicating the advantage of incorporatingmorphological diversity throughout the production cycle. Feeder and drinker occupancymoderately predicted bird distribution within the edge-removed region (R2 = 0.592) butnot the full pen (R2 = 0.037), where perimeter congregation dominated. Broilersexhibited no significant preference among the three groove widths (p > 0.05), and thislack of preference remained consistent throughout the production cycle. These findingsindicate that groove width can be selected primarily according to engineeringconsiderations, such as higher feces holding capacity and cleaning efficiency, withoutadversely affecting broiler occupancy. The proposed computer vision frameworkprovides an automated and scalable approach for evaluating livestock housing designsand supports the development of robotic-cleanable poultry production systems.
- Open Access
- 12 August 2026
- Published by Elsevier in Smart Agricultural Technology
- Vol. 15
Investigation of poultry feces removal rate and vision-based feces weight estimation on grooved-floor panels
- 12 August 2026
- Published by Elsevier in Smart Agricultural Technology
- Vol. 15
Open AccessInvestigation of poultry feces removal rate and vision-based feces weight estimation on grooved-floor panels
- Open Access
- 6 July 2026
- Published by Elsevier in SSRN Electronic Journal
Investigation of poultry feces removal rate and vision-based feces weight estimation on grooved-floor panels
Efficient feces and litter management remains a critical challenge in modern poultry production systems. Traditional deep-litter systems present several challenges, including high labor requirements, hygiene concerns, and welfare issues associated with wet litter. These issues may be alleviated by using a semicircular grooved-floor design that separates birds from accumulated feces, allowing feces to be mechanically removed from the production area through robotic operation. This pilot study aimed to evaluate the daily feces removal efficiency of a robotic cleaning prototype and develop a computer-vision algorithm to estimate fecal volume for potential health monitoring applications. Grooved floor panels were placed underneath battery cages to collect fecal samples from laying hens. A mobile system equipped with rotatory brushes was developed to remove feces. A LiDAR camera was used to scan the floor surface before and after feces removal. Experimental trials showed that the mobile system removed 88.24 ± 2.37% of accumulated feces at 24-hour collection intervals. The feces removal rates were similar (P > 0.05) under different stocking densities and cleaning intervals. In addition, fecal volume showed a strong correlation with fecal weight (R2 = 0.97, MAPE = 3.04%). Both fecal volume and weight had significant differences (P < 0.05) between the different stocking densities and collection durations. These findings demonstrate the feasibility of robotic feces removal from grooved-floor surfaces and indicate that 3D-derived fecal volume may provide insights into birds’ health status such as assessing the temporospatial density in grooved floor system or estimating number of live birds in caged system.
- 6 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessInvestigation of poultry feces removal rate and vision-based feces weight estimation on grooved-floor panels
Efficient feces and litter management remains a critical challenge in modern poultry production systems. Traditional deep-litter systems present several challenges, including high labor requirements, hygiene concerns, and welfare issues associated with wet litter. These issues may be alleviated by using a semicircular grooved-floor design that separates birds from accumulated feces, allowing feces to be mechanically removed from the production area through robotic operation. This pilot study aimed to evaluate the daily feces removal efficiency of a robotic cleaning prototype and develop a computer-vision algorithm to estimate fecal volume for potential health monitoring applications. Grooved floor panels were placed underneath battery cages to collect fecal samples from laying hens. A mobile system equipped with rotatory brushes was developed to remove feces. A LiDAR camera was used to scan the floor surface before and after feces removal. Experimental trials showed that the mobile system removed 88.24 ± 2.37% of accumulated feces at 24-hour collection intervals. The feces removal rates were similar (P > 0.05) under different stocking densities and cleaning intervals. In addition, fecal volume showed a strong correlation with fecal weight (R2 = 0.97, MAPE = 3.04%). Both fecal volume and weight had significant differences (P < 0.05) between the different stocking densities and collection durations. These findings demonstrate the feasibility of robotic feces removal from grooved-floor surfaces and indicate that 3D-derived fecal volume may provide insights into birds’ health status such as assessing the temporospatial density in grooved floor system or estimating number of live birds in caged system.