Олег Франко
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Олег Франко has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Vladimir N. Leitsin
Балтийский федеральный университет имени Иммануила Канта
1 shared publication
Latest Publications
- Open Access
- 11 July 2026
- Published by Far Eastern Federal University in ВЕСТНИК ИНЖЕНЕРНОЙ ШКОЛЫ ДВФУ
- No. 2(67),p. 15-22
Модификация мелкозернистого бетона добавкой суспензии, полученной в процессе прецизионной резки на пластины m-Si
Рассмотрено влияние отходов процесса прецизионной резки в виде добавки кремнийсодержащей суспензии (КС) на физико-механические свойства мелкозернистого бетона. Добавление суспензии в состав цементной смеси проводилось в концентрации 1,5 и 2% от массы цемента. Полученные результаты показывают положительную динамику набора прочности образцов и подтверждают возможность оптимизации концентрации КС при производстве бетонных сооружений. The influence of waste from the precision cutting process in the form of additives of a silica-containing suspension (SCS) on the physico-mechanical properties of fine-grained concrete is considered. The addition of the suspension to the cement mixture was carried out at a concentration of 1,5 and 2% by weight of cement. The results obtained show a positive trend in the strength gain of the samples and confirm the possibility of optimizing the concentration of SCS in the production of concrete structures.
- 11 July 2026
- Published by Far Eastern Federal University in ВЕСТНИК ИНЖЕНЕРНОЙ ШКОЛЫ ДВФУ
- No. 2(67),p. 15-22
Open AccessМодификация мелкозернистого бетона добавкой суспензии, полученной в процессе прецизионной резки на пластины m-Si
Рассмотрено влияние отходов процесса прецизионной резки в виде добавки кремнийсодержащей суспензии (КС) на физико-механические свойства мелкозернистого бетона. Добавление суспензии в состав цементной смеси проводилось в концентрации 1,5 и 2% от массы цемента. Полученные результаты показывают положительную динамику набора прочности образцов и подтверждают возможность оптимизации концентрации КС при производстве бетонных сооружений. The influence of waste from the precision cutting process in the form of additives of a silica-containing suspension (SCS) on the physico-mechanical properties of fine-grained concrete is considered. The addition of the suspension to the cement mixture was carried out at a concentration of 1,5 and 2% by weight of cement. The results obtained show a positive trend in the strength gain of the samples and confirm the possibility of optimizing the concentration of SCS in the production of concrete structures.