Darina Dobreva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Darina Dobreva has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Ismail Mehmedov
Department of Mechanics and Machine Elements, Technical University of Varna, 9000 Varna, Bulgaria
1 shared publication - Momchil Tachev
Department of Industrial Design, Technical University of Varna, 9000 Varna, Bulgaria
1 shared publication - Zoya Tsoneva
Department of Mechanics and Machine Elements, Technical University of Varna, 9000 Varna, Bulgaria
1 shared publication
Latest Publications
- Open Access
- 28 August 2026
- Published by MDPI AG in Engineering Proceedings
- Vol. 154 (1) , 9
Dynamics of Airflow in the Separation Process and Their Effect on Quantitative Parameters
The study focuses on the influence of airflow on the separation of the three primary materials under investigation: sand, sawdust, and ash. These materials were selected to facilitate a comparative analysis between two distinct airflows. The primary objective of the research is to increase the separation yield while maintaining the original design of the 2A mechanical cyclone model. The model utilized in this study was designed using SolidWorks 2025 and fabricated via a Raise3D Pro2 3D printer (Raise3D Technologies, Inc. 2019, Nantong, China, Е2). The purpose of the experiment is to determine how variations in flow affect the separation of fine particulate matter under 3 μm.
- 28 August 2026
- Published by MDPI AG in Engineering Proceedings
- Vol. 154 (1) , 9
Open AccessDynamics of Airflow in the Separation Process and Their Effect on Quantitative Parameters
The study focuses on the influence of airflow on the separation of the three primary materials under investigation: sand, sawdust, and ash. These materials were selected to facilitate a comparative analysis between two distinct airflows. The primary objective of the research is to increase the separation yield while maintaining the original design of the 2A mechanical cyclone model. The model utilized in this study was designed using SolidWorks 2025 and fabricated via a Raise3D Pro2 3D printer (Raise3D Technologies, Inc. 2019, Nantong, China, Е2). The purpose of the experiment is to determine how variations in flow affect the separation of fine particulate matter under 3 μm.