BFB. Frandeen

B. Frandeen

*This is an algorithmically generated author record based on publicly available information.

B. Frandeen has a total of 57 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Measurements for fusion power to demonstrate Q fus > 1 on SPARC (invited)

    by P. Raj, I. Abramovic, J. L. Ball, D. J. Battaglia, J. Carmichael, A. Celora, M. Dalla Rosa, N. G. Duarte, E. Fox-Widdows, B. Frandeen, et al.

    The SPARC tokamak’s primary goal in the first operational campaign is achieving net fusion energy gain (Qfus> 1), targeting a fusion power (Pfus) of 8–30 MW in deuterium–tritium (DT) plasma. For an optimally accurate and widely accepted demonstration of breakeven, the SPARC team is preparing for three independent methodologies to measure Pfus. The first method relies on neutron flux monitors and a neutron activation system, which together offer high time-resolution data using ionization chambers and dosimetry foils for absolute yield measurements. These are calibrated via an in situ DT neutron generator and detailed neutronics models. The second method employs collimated neutron diagnostics. A core-viewing magnetic-proton recoil spectrometer analyzes the neutron energy spectrum, while a poloidal profiler uses scintillator and diamond detectors to derive the DT neutron emissivity profile. Together, these diagnostics allow for a precise reconstruction of Pfus from core emissions. The third method calculates Pfus by volume-integrating the fusion reactivity using data from an array of kinetic profile diagnostics. Key inputs include temperature profiles from x-ray spectroscopy and electron–cyclotron emission measurements, plasma/electron density from Thomson-scattering, interferometry and edge-reflectometry, and fuel ion and impurity levels (Zeff) from optical and vacuum-UV spectroscopy. Neutral gas diagnostics and optical spectroscopy provide the critical fuel ion concentrations, which are also needed for corrections for the non-DT neutron contributions. By integrating these complementary techniques, SPARC ensures a robust and verified demonstration of Qfus > 1 in its first campaign.


  • Open Access

    Design of a diamond-based in-vessel soft x-ray camera system for the SPARC tokamak

    by S. Normile, D. Vezinet, B. Frandeen, C. Perks, F. Bombarda, G. Verona-Rinati, J. E. Rice

    Soft x-ray tomography has been used in tokamaks for decades to interrogate a wide variety of phenomena; however, the standard silicon diodes coupled with beryllium filters will not be able to survive the high heat and neutron fluxes present in burning plasma devices like SPARC. Presented here is the design for a set of soft x-ray tomography cameras that use chemical vapor deposition (CVD) single-crystal diamonds and graphene filters for photodetection. Four of these cameras will be placed in the port plugs of SPARC with a large enough view of the poloidal cross section to enable tomographic inversion and sufficient time resolution to resolve the dynamics of low-m and -n magnetohydrodynamic modes. CVD diamonds have been used successfully for the detection of both vacuum ultraviolet and soft x-ray photons at the Frascati Tokamak Upgrade and have demonstrated the ability to maintain greater than 50% of their initial responsivity at a neutron fluence of 1016 cm−2. The neutron dose in SPARC will exceed this limit, providing a demonstration of how CVD diamonds fail in place while adding value to the early operation of a new tokamak. Numerical simulations indicate that graphene spectral filters will filter nearly as effectively as traditional beryllium ones and are able to resist significantly higher heat fluxes due to graphene’s unique thermal properties. Simulated plasma emissivity profiles have been used to optimize both the camera placement and detector properties.

  • Hard-x-ray diamond sensors for in-flight runaway electron detection on SPARC

    by D. Vezinet, S. Normile, B. Frandeen, C. Perks, G. Verona-Rinati, C. Verona, M. Angelone, F. Bombarda, D. D’AMico, J. Hatch, et al.

    This paper presents the design of a pair of in-vessel x-ray cameras for SPARC. These cameras have mirrored tangential toroidal views and aim to measure the anisotropic thin-target bremsstrahlung emitted by runaway electrons interacting with the background plasma in the 10–30 keV range. This diagnostic is planned as one of the safeguards against off-normal current ramp-up scenarios, in particular during early SPARC operation. The motivations behind this diagnostic are presented, and the design is detailed with an emphasis on constraints specific to SPARC.