Kang Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kang Zhang has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Mingsheng Long
State Key Laboratory of Opto-Electronic Information Acquisition and Protection Technology, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, China
3 shared publications - Suofu Wang
School of Energy, Power and Safety, Anhui University of Applied Technology, Hefei 230011, China
3 shared publications - Yubing Tu
State Key Laboratory of Opto-Electronic Information Acquisition and Protection Technology, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, China
3 shared publications - Jianzhi Gao
School of Physics and Information Technology, Shaanxi Normal University, Xi’an, China
2 shared publications - Ruya Cong
State Key Laboratory of Opto-Electronic Information Acquisition and Protection Technology, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, China
2 shared publications - Tao Han
State Key Laboratory of Opto-Electronic Information Acquisition and Protection Technology, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, China
2 shared publications
Latest Publications
- Open Access
- 11 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (20) , 1289
High-Performance Uncooled Infrared Photodetection Based on van der Waals Metallic FePd2Te2 Nanoflakes
Uncooled infrared photodetectors that combine high sensitivity, low power consumption, and broad spectral coverage remain highly desirable. However, they are still hindered by the complex epitaxial processes and cooling requirements of mainstream semiconductor technologies. Here, we demonstrate a high-performance infrared photodetector based on FePd2Te2 nanoflakes, a van der Waals metallic material that enables efficient photothermal conversion. The device operates at room temperature under a bias of 0.1 V and exhibits a broadband photoresponse spanning from the visible to the long-wave infrared. Across the measured infrared range, a wavelength-independent responsivity (R) above 50 A/W, a noise equivalent power (NEP) below 2.83 × 10−16 W/Hz1/2, and a specific detectivity (D*) exceeding 3.86 × 1012 cm Hz1/2/W are achieved. The photoresponse appears to arise from the photobolometric effect, in which the temperature rise at the contact interface is considered to modulate the contact resistance and thereby amplify the photocurrent. These results establish FePd2Te2 as a promising platform for room-temperature, low-power, and highly sensitive infrared detection.
- 11 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (20) , 1289
Open AccessHigh-Performance Uncooled Infrared Photodetection Based on van der Waals Metallic FePd2Te2 Nanoflakes
Uncooled infrared photodetectors that combine high sensitivity, low power consumption, and broad spectral coverage remain highly desirable. However, they are still hindered by the complex epitaxial processes and cooling requirements of mainstream semiconductor technologies. Here, we demonstrate a high-performance infrared photodetector based on FePd2Te2 nanoflakes, a van der Waals metallic material that enables efficient photothermal conversion. The device operates at room temperature under a bias of 0.1 V and exhibits a broadband photoresponse spanning from the visible to the long-wave infrared. Across the measured infrared range, a wavelength-independent responsivity (R) above 50 A/W, a noise equivalent power (NEP) below 2.83 × 10−16 W/Hz1/2, and a specific detectivity (D*) exceeding 3.86 × 1012 cm Hz1/2/W are achieved. The photoresponse appears to arise from the photobolometric effect, in which the temperature rise at the contact interface is considered to modulate the contact resistance and thereby amplify the photocurrent. These results establish FePd2Te2 as a promising platform for room-temperature, low-power, and highly sensitive infrared detection.
- Open Access
- 2 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (19) , 1247
Reconfigurable Optoelectronic Logic Gates Enabled by a VSe2/MoTe2 van der Waals Heterojunction
Optoelectronic logic gates that integrate optical inputs with electrical outputs offer a promising route toward high-bandwidth, low-power in-sensor computing. However, most existing implementations require precise control over the excitation wavelength, optical power, or gate bias, which complicates device fabrication and system integration. Here, we demonstrate a reconfigurable optoelectronic logic device based on a VSe2/MoTe2 van der Waals heterojunction. The device exhibits a rectification ratio exceeding 103 in the dark and a pronounced photovoltaic response, including a light on/off ratio surpassing 107, a responsivity of 0.28 A/W, and external quantum efficiency of 54%, as well as a noise-equivalent power of 4.6 × 10−14 W/Hz1/2 and a specific detectivity of 2.1 × 1010 cm Hz1/2/W. By reconfiguring the source and drain electrodes and modulating the optical input, six fundamental Boolean logic operations—AND, IMP, NOR, NOT, OR, and NAND—are realized in the device. Notably, all six logic functions are obtained under fixed illumination and predefined bias, without requiring wavelength, power, or gate modulation. Switching between functions requires only a specific bias voltage and a change in the source/drain connection (for certain operations, OR and NAND, the input state is redefined). These results underscore the promise of two-dimensional material-based van der Waals heterojunctions for compact, low-power, and reconfigurable optoelectronic logic processing.
- 2 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (19) , 1247
Open AccessReconfigurable Optoelectronic Logic Gates Enabled by a VSe2/MoTe2 van der Waals Heterojunction
Optoelectronic logic gates that integrate optical inputs with electrical outputs offer a promising route toward high-bandwidth, low-power in-sensor computing. However, most existing implementations require precise control over the excitation wavelength, optical power, or gate bias, which complicates device fabrication and system integration. Here, we demonstrate a reconfigurable optoelectronic logic device based on a VSe2/MoTe2 van der Waals heterojunction. The device exhibits a rectification ratio exceeding 103 in the dark and a pronounced photovoltaic response, including a light on/off ratio surpassing 107, a responsivity of 0.28 A/W, and external quantum efficiency of 54%, as well as a noise-equivalent power of 4.6 × 10−14 W/Hz1/2 and a specific detectivity of 2.1 × 1010 cm Hz1/2/W. By reconfiguring the source and drain electrodes and modulating the optical input, six fundamental Boolean logic operations—AND, IMP, NOR, NOT, OR, and NAND—are realized in the device. Notably, all six logic functions are obtained under fixed illumination and predefined bias, without requiring wavelength, power, or gate modulation. Switching between functions requires only a specific bias voltage and a change in the source/drain connection (for certain operations, OR and NAND, the input state is redefined). These results underscore the promise of two-dimensional material-based van der Waals heterojunctions for compact, low-power, and reconfigurable optoelectronic logic processing.
- Open Access
- 29 September 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (19) , 1228
Ultra-Broadband Negative Photoconductivity in a Van der Waals Ferromagnetic Metal FePd2Te2
Negative photoconductivity (NPC) in low-dimensional materials has attracted considerable interest for its potential in novel optoelectronic devices. Here, we report an ultra-broadband NPC response in FePd2Te2, a van der Waals ferromagnet, spanning from visible to long-wavelength infrared at room temperature. The device achieves a responsivity of ~4.9 A/W and external quantum efficiency of ~240% at 2500 nm, with a noise-equivalent power (NEP) below 3.0 × 10−15 W/Hz1/2 and a specific detectivity (D*) exceeding 3.6 × 1011 cmHz1/2/W across the infrared range. Systematic measurements identify the photobolometric effect as the underlying mechanism, wherein wavelength-dependent absorption depths play a key role in shaping the photoresponse characteristics. These results establish FePd2Te2 as a promising platform for uncooled broadband infrared detection and highlight the potential of magnetic van der Waals materials for future optoelectronics.
- 29 September 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (19) , 1228
Open AccessUltra-Broadband Negative Photoconductivity in a Van der Waals Ferromagnetic Metal FePd2Te2
Negative photoconductivity (NPC) in low-dimensional materials has attracted considerable interest for its potential in novel optoelectronic devices. Here, we report an ultra-broadband NPC response in FePd2Te2, a van der Waals ferromagnet, spanning from visible to long-wavelength infrared at room temperature. The device achieves a responsivity of ~4.9 A/W and external quantum efficiency of ~240% at 2500 nm, with a noise-equivalent power (NEP) below 3.0 × 10−15 W/Hz1/2 and a specific detectivity (D*) exceeding 3.6 × 1011 cmHz1/2/W across the infrared range. Systematic measurements identify the photobolometric effect as the underlying mechanism, wherein wavelength-dependent absorption depths play a key role in shaping the photoresponse characteristics. These results establish FePd2Te2 as a promising platform for uncooled broadband infrared detection and highlight the potential of magnetic van der Waals materials for future optoelectronics.