Jhon Esteban Puerta Altamiranda
Research Subjects
Jhon Esteban Puerta Altamiranda has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Carlos Alejandro Zuluaga
Universidad Pontificia Bolivariana
1 shared publication - Hader Vladimir Martinez Tejada
Universidad Pontificia Bolivariana
1 shared publication - Luis Felipe Lalinde
Department of Mechanical Engineering, Faculty of Engineering, Universidad Pontificia Bolivariana, Medellin 050031, Colombia
1 shared publication - Luis Miguel Aristizábal
School of Engineering, Universidad Pontificia Bolivariana, Medellín 050031, Colombia
1 shared publication - Nicolas Ramirez Ortiz1 shared publication
Latest Publications
- Open Access
- 7 October 2026
- Published by Elsevier in SSRN Electronic Journal
Reactivation and Upgrading of a Legacy FFF 3D Printer Using an Open-Source Duet Framework with Integrated Load-Cell Extrusion Force Sensing
This work presents the reactivation and upgrading of a legacy CubeX Duo 3D printer, out of service for over ten years, into an open-source CoreXY Fused Filament Fabrication (FFF) platform controlled by a Duet 2 Maestro board. A reproducible methodology is demonstrated, covering system assessment, mechanical redesign, electronics integration, firmware configuration, and operational validation. Reusable components from the original device, including stepper motors, structural tubes, and linear shafts, are retained and integrated with newly designed printed and machined parts. A bending-beam load cell is integrated into the extruder assembly for real-time extrusion force measurement, enabling characterization of nozzle back-pressure, detection of extruder skip events, and determination of operational feed speed limits. Force data are acquired via an HX711 amplifier and transmitted wirelessly through an NRF24L01 module. Extrusion force characterization was performed across three temperatures (195, 200, and 210 °C) and feed speeds from 5 to 50 mm/s using Generic PLA, identifying stable and skip regimes through force signal morphology and fit quality (R2 < 0.92). All design files, firmware, and acquisition code are released under open-source licenses (CERN OHL v2).
- 7 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessReactivation and Upgrading of a Legacy FFF 3D Printer Using an Open-Source Duet Framework with Integrated Load-Cell Extrusion Force Sensing
This work presents the reactivation and upgrading of a legacy CubeX Duo 3D printer, out of service for over ten years, into an open-source CoreXY Fused Filament Fabrication (FFF) platform controlled by a Duet 2 Maestro board. A reproducible methodology is demonstrated, covering system assessment, mechanical redesign, electronics integration, firmware configuration, and operational validation. Reusable components from the original device, including stepper motors, structural tubes, and linear shafts, are retained and integrated with newly designed printed and machined parts. A bending-beam load cell is integrated into the extruder assembly for real-time extrusion force measurement, enabling characterization of nozzle back-pressure, detection of extruder skip events, and determination of operational feed speed limits. Force data are acquired via an HX711 amplifier and transmitted wirelessly through an NRF24L01 module. Extrusion force characterization was performed across three temperatures (195, 200, and 210 °C) and feed speeds from 5 to 50 mm/s using Generic PLA, identifying stable and skip regimes through force signal morphology and fit quality (R2 < 0.92). All design files, firmware, and acquisition code are released under open-source licenses (CERN OHL v2).