VGVeronique S. Gevaerts

Veronique S. Gevaerts

*This is an algorithmically generated author record based on publicly available information.

Veronique S. Gevaerts has a total of 71 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Chemical and Electronic Properties of Low‐Temperature ALD‐NiO x and Its Application in Perovskite and Tandem Solar Cells

    by Vincent Dufoulon, Aleksandra Bojar, Solene Béchu, Javid Hajhemati, Nitin Mallik, Mathieu Frégnaux, Jose Álvarez, Nathanaelle Schneider, Jean‐Paul Kleider, Yinghuan Kuang, et al.

    Atomic layer deposition (ALD) is a versatile approach for depositing nickel oxide (NiO x ) hole‐selective layers in perovskite solar cells (PSCs), particularly for integration into multijunction devices where low processing temperatures are required. However, deposition temperature can strongly influence the chemical and electronic properties of NiO x films and their interfaces, affecting device performance. Here, we investigate ALD‐NiO x layers deposited at temperatures ranging from 75 to 250 °C and correlate their properties with photovoltaic performance. X‐ray photoelectron spectroscopy reveals an increase in stoichiometric NiO content from 76% to 96% with increasing deposition temperature, while only minor variations in work function are observed. PSCs fabricated using these ALD‐NiO x layers show only marginal performance improvements above 150 °C, with efficiency gains below 1% absolute, mainly due to changes in fill factor and short‐circuit current. As an application‐oriented demonstration, ALD‐NiO x deposited at 100 °C was implemented in a monolithic CIGS/perovskite tandem device, yielding a power conversion efficiency above 23%, with an open‐circuit voltage of 1651 mV and a fill factor of 76%. This result demonstrates the compatibility of the investigated low‐temperature ALD process with the fabrication of temperature‐sensitive multijunction device architectures.

  • Photoluminescence Mapping of Mobile and Fixed Defects in Halide Perovskite Films

    by Sarah C. Gillespie, Jérôme Gautier, Linde M. van de Ven, Agustin O. Alvarez, Bruno Ehrler, L.J. Geerligs, Veronique S. Gevaerts, Gianluca Coletti, Erik C. Garnett


  • Open Access

    Resolving mobile halide diffusion in perovskite films with frequency-domain photoluminescence

    by Sarah C. Gillespie, Agustin O. Alvarez, Bruno Ehrler, Veronique S. Gevaerts, L. J. Geerligs, Gianluca Coletti, Erik C. Garnett

    Intensity-modulated photoluminescence spectroscopy (IMPLS) is a frequency-domain, fully optical technique that probes ionic processes in halide perovskites.

  • Open Access

    Excitation Intervals Enhance Performance in Perovskite Solar Cells

    by Sarah C. Gillespie, Jarla Thiesbrummel, Veronique S. Gevaerts, L. J. Geerligs, Jeroen J. de Boer, Gianluca Coletti, Erik C. Garnett

    Halide perovskites face intrinsic stability challenges primarily due to light- and bias-induced ion migration. To mitigate ion-mediated degradation on operationally relevant time scales, this work investigates how introducing brief periodic intervals of light and darkness (LD cycling) can stabilize the average efficiency of perovskite films and devices. Systematic photoluminescence (PL) studies reveal that dark intervals on the order of seconds significantly suppress nonradiative recombination and slow degradation. The extent of PL enhancement depends on the duration of the dark time, the material composition, and critically, the sample's age. Remarkably, LD cycling increases PL by more than 7-fold even in aged samples that would otherwise undergo photodarkening under continuous illumination. Moreover, the PL kinetics under LD cycling mirror the corresponding open-circuit voltage dynamics in full solar cells, showing that local emission changes provide a direct measure of device-level behavior. Device measurements similarly show that LD cycling enhances the power conversion efficiency compared to continuous illumination and mitigates deterioration over extended operation. This strategy highlights a potential pathway to dynamically preserve or even improve perovskite performance in future optoelectronic applications.


  • Open Access

    Intensity-Modulated Photoluminescence Spectroscopy for Revealing Ionic Processes in Halide Perovskites

    by Sarah C. Gillespie, Agustin O. Alvarez, Jarla Thiesbrummel, Veronique S. Gevaerts, L.J. Geerligs, Bruno Ehrler, Gianluca Coletti, Erik C. Garnett

    Mobile ions limit halide perovskite device performance, yet quantifying ionic properties remains challenging. Frequency-domain electrical techniques are restricted to operational devices, and the resulting signals are often dominated by interfacial recombination which obscures ionic contributions. Here, we introduce intensity-modulated photoluminescence spectroscopy (IMPLS) as a fully optical alternative, where the amplitude and phase of the photoluminescence intensity is measured as a function of excitation modulation frequency. IMPLS is demonstrated on a Cs0.07(FA0.83MA0.17)0.93Pb­(I0.83Br0.17)3 film. Fitting the data with an optical equivalent circuit model reveals two characteristic lifetimes: τchar = 2.1 ms and 77 s, likely corresponding to defect formation and ionic diffusion, respectively. The diffusion feature is consistent with intensity-modulated photocurrent/photovoltage spectroscopy (IMPS/IMVS) measurements on corresponding full devices. Importantly, IMPLS enables contact-free characterization of slow processes for all perovskite sample types, including films and devices, significantly expanding the techniques available for understanding mobile ions in these materials.


  • Mapping the Partial Shading Degradation in a Monolithically Integrated Perovskite Module

    by Remi Aninat, Klaas Bakker, Jonathan Henzel, Valerio Zardetto, Ilker Dogan, Veronique Gevaerts, Sjoerd Veenstra, Mirjam Theelen

    Among reliability studies on perovskite photovoltaics (PV) cells and modules, partial shading degradation is a crucial and under‐investigated topic. In the present work, we use a combination of mapping electroluminescence (EL), photoluminescence (PL), and illuminated lock‐in thermography (ILIT) to gain insight into the reverse bias degradation mechanisms induced by partial shading on a monolithically interconnected module. Spatial inhomogeneities across the cell length are shown to play an important role in the degradation. A perovskite module was subjected to partial shading, causing, in the lower region of the shaded cells, a PL signal intensity increase and EL decrease. We suggest the formation of a barrier at one of the perovskite/transport layer interfaces, preventing both carrier extraction in PL and carrier injection in EL. A simple model for the current flow in the presence of the barrier can satisfactorily explain the EL, PL, and ILIT behavior and point to some possible propagation mechanisms. In summary, we show that studying partial shading degradation at module level draws a more complex and realistic picture of the interplay between material and electrical parameters than cell‐level studies. We also demonstrate that luminescent and thermal imaging techniques can be combined to draw meaningful conclusions on the degradation mechanisms, their formation, and propagation.


  • Raman spectroscopy and hyper-spectral imaging for quality control of CIGS solar cells

    by Martin De Biasio, Johanna Zikulnig, Wolfgang Muehleisen, Veronique Gevaerts, Marcel Simor, Florian Gruber, Philipp Wollmann, Wulf Grählert, Thomas Arnold

    Copper indium gallium selenide (CIGS) thin film photovoltaic devices are in the early stages of large-scale commercialization. Their high performance, uniformity, reliability, and a low carbon footprint make them an attractive alternative to standard silicon solar cells. Due to the complex processing required and the associated manufacturing costs, reliable in-line quality control technology is needed. By identifying defective cells early in production, faulty batches can be excluded from further processing, saving resources and costs. We show that micro-Raman spectroscopy (RS) and hyper-spectral imaging (HSI) are powerful tools for quality control and process improvement. Distinctive features in the Raman spectra allow the estimation of the copper to gallium plus indium (CGI) ratio, which is an important criterion for the cell’s efficiency. With HSI in the visible and near infrared range (VNIR) and the near-infrared spectral range (NIR) in combination with machine learning techniques, the layer thickness and CGI ratio are accurately predicted.

  • Open Access

    Monolithic Two-Terminal Perovskite/CIS Tandem Solar Cells with Efficiency Approaching 25%

    by Marco A. Ruiz-Preciado, Fabrizio Gota, Paul Fassl, Ihteaz M. Hossain, Roja Singh, Felix Laufer, Fabian Schackmar, Thomas Feeney, Ahmed Farag, Isabel Allegro, et al.

    Monolithic two-terminal (2T) perovskite/CuInSe2 (CIS) tandem solar cells (TSCs) combine the promise of an efficient tandem photovoltaic (PV) technology with the simplicity of an all-thin-film device architecture that is compatible with flexible and lightweight PV. In this work, we present the first-ever 2T perovskite/CIS TSC with a power conversion efficiency (PCE) approaching 25% (23.5% certified, area 0.5 cm2). The relatively planar surface profile and narrow band gap (∼1.03 eV) of our CIS bottom cell allow us to exploit the optoelectronic properties and photostability of a low-Br-containing perovskite top cell as revealed by advanced characterization techniques. Current matching was attained by proper tuning of the thickness and bandgap of the perovskite, along with the optimization of an antireflective coating for improved light in-coupling. Our study sets the baseline for fabricating efficient perovskite/CIS TSCs, paving the way for future developments that might push the efficiencies to over 30%.


  • Positron Annihilation Studies on the Damp Heat Degradation of ZnO:Al Transparent Conductive Oxide Layers for CIGS Solar Cells

    by Wenqin Shi, Mirjam Theelen, Veronique Gevaerts, Andrea Illiberi, Nicolas Barreau, Maik Butterling, Henk Schut, Werner Egger, Marcel Dickmann, Christoph Hugenschmidt, et al.