SFSam Frydman

Sam Frydman

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sam Frydman has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • The Effects of Boundary Conditions in the Testing of Geotechnical Models

    by Shay Nachum, Peter Adesina, Shahpar Shoghi, Sam Frydman, Mark Talesnick

    The effects of boundary conditions, most importantly sidewall friction, on the outcome and subsequent interpretation and analysis of physical models in geotechnics are seldom given the attention required. Sidewall friction has significant influence on stress conditions within a specimen or model, and as such will affect the distribution of strain within the soil mass. A set of tests with fine grained uniform sand was performed in which sidewall friction and sidewall fixities were controlled and measured as loads were applied to the soil mass. As the specimen was loaded, shear stresses at the boundary of the test box, over the height of the specimen, were measured. Analysis of the test data reveals that during the loading stage of the experiment the development of shear stress is uniform and well understood. During unloading, the situation was shown to be more complex; sidewall shear is nonuniform over the sidewall height and changes sign as unloading progresses. The experimental data and analysis illustrate that by applying friction reduction measures, the effects of sidewall friction are significantly reduced. It is suggested that friction reduction measures are almost mandatory in two-dimensional physical model and element testing where the model thickness is typically very small. This could also be true in axisymmetric conditions, as illustrated by results from model cone penetration testing.

  • Open Access

    The laterally confined consolidation of initially compacted and wetted swelling clay

    by Shay Nachum, Sam Frydman, Mark Talesnick

    This paper describes the laterally confined consolidation of an Israeli clay following compaction and swelling on wetting, including the measurement of lateral stresses. The results of the tests are compared to those obtained during consolidation of the clay from an initially slurried condition. In comparing the compression and expansion indices relative to vertical, lateral and mean stress, it was found that they varied, depending on the initial, preparation conditions; the values approached the slurried values with decreasing initial dry density. During unloading, the expansion indices were found to be independent of initial conditions, and essentially the same as those of the slurried soil. The coefficient of lateral earth pressure at rest during loading, K0, of the compacted and then wetted specimens was found to be reasonably constant regardless of initial soil conditions, but significantly higher than the value of the slurried soil. However, during unloading, the relationship between the normalized coefficients of lateral earth pressure at rest, K0'/K0, and the overconsolidation ratio, OCR, was found to be essentially the same as that obtained for the slurried soil.


  • K0determination using improved experimental technique

    by Mark Talesnick, Shay Nachum, Sam Frydman

    Lateral soil pressures under at-rest conditions are commonly estimated as K0times vertical normal pressure, where K0is obtained from generally accepted empirical formulae, related to the soil's friction angle and the stress history. Results of a programme of laterally, rigidly confined, vertical compression and unloading tests on sand and clay are presented, in which two significant experimental techniques were employed: (a) lateral pressures were measured using null pressure gauges, preventing gauge diaphragm deflection; (b) side-wall friction was measured, and minimised using special friction reduction measures. Comparative tests in which one or both of these measures were not employed indicate the significant errors induced in both the vertical and the horizontal pressures used for K0determination. The bank of experimental data, which formed the basis for the commonly accepted empirical formulae, did not take account of these issues, and they are shown to be inconsistent with values measured in the present study.


  • A New Apparatus for Studying Laterally Restrained Swell of Compacted Clay with Lateral Pressure Measurement

    by Shay Nachum, Mark Talesnick, Sam Frydman

    Wetting of compacted clays, and their subsequent swelling, often results in damage to structures and infrastructures. In some cases, for example, if the clay is adjacent to a structure such as a retaining wall, pile, or pipeline, lateral swell is restrained, resulting in heave in the vertical direction and development of swelling pressure laterally. Standard procedures for testing the swell of clays on wetting are limited to the definition of a vertical pressure-swell relationship. This paper presents an investigation of the laterally restrained swell of a highly plastic compacted clay in a new rectangular test cell designed to provide additional and more reliable test information. Lateral soil pressure is measured using null pressure gauges flush with the cell walls. Cell sidewall friction is evaluated by measuring the load applied to the specimen top and the load reaching its base, and it is minimized by incorporating friction reduction measures. It was found that pressure-swell curves, based on vertical pressure, horizontal pressure, and mean pressure, all plot as straight lines on a semi-log basis. Although inundation of the test specimen is standard practice for swelling tests, this procedure represents an extreme wetting condition in the field. The study demonstrates that swell is affected by the characteristics of the hydraulic head responsible for wetting the soil; wetting by suction alone, or by combination of suction and gravity head, result in different degrees of swell.


  • A simplified approach for studying the influence of vertical accelerations on seismic response of slopes

    by Sam Frydman

    A simplified approach is presented for estimating permanent displacements in slopes as a result of both vertical and horizontal seismic accelerations. A study of 52 earthquake records showed that the time difference between maximum horizontal and vertical accelerations varied between 0 and 10.3 s. The approach is illustrated for an earth dam embankment by analysing the effects of five of the above earthquake records. The approach combines a pseudo-static slope stability analysis for estimation of the critical (or yield) horizontal-vertical acceleration combinations, and a Newmark type displacement analysis. Guidelines are presented for conservative choice of soil strength parameters of saturated clays for use in the stability analysis. While permanent displacements of up to 40 cm were predicted without considering the vertical acceleration component, no additional displacement above 3.5 cm resulted when this component was included. The predicted additional displacement was consistently less than 10%, and in 50% of the analyses, vertical acceleration led to smaller predicted displacements. The simple approach may be applied in analysis for any slope using real earthquake records. Using existing, empirical expressions for permanent displacement, based only on horizontal accelerations, the effect of the vertical accelerations may be conservatively estimated by increasing the displacement by 10%.


  • Soil Pressure and Pipe Deformation Measurements for Characterizing Flexible Pipe–Soil Systems under Shallow Cover

    by Mark. L. Talesnick, Sam Frydman

    A field test was performed to study the response of an 800 mm internal diameter, hybrid (plastic/metal) structured wall pipe during installation and varied traffic loading. Synchronized measurements were made of radial soil pressures adjacent to the pipe and pipe deflection, allowing representation of the pressure–deflection relationship of the soil–pipe system. Soil pressures were measured using null pressure measurement cells that avoid the effects of membrane deflection, soil stiffness, and stress history. It is concluded that the critical point in the lifetime of a flexible, shallow buried pipe is when the trench has been backfilled and compacted to the subgrade surface. At this point, the final pavement/asphalt layers have yet to be installed, yet very large loads may be traversing above the pipe section. Once the final pavement layers are constructed, the pressures reaching the pipe crown will become smaller, as will the respective deflections. As a result of the simultaneous and continuous measurement of soil pressure adjacent to the pipe and pipe deflections during the field test, a scheme has been suggested for approximate prediction of flexible pipe deflection in response to traffic loading.


  • Behavior of a Composite Plastic Structured-Wall Pipe under Varied Field Installation Conditions

    by Mark. L. Talesnick, Sam Frydman

    The performance of a structured-walled, hybrid plastic-steel pipe, installed under standard and substandard conditions, was monitored in field tests. Sections of steel-reinforced, high-density polyethylene resin pipe, with inner diameter of 1.02 m and outer diameter of 1.12 m were installed at two test sites. In the first, the standard installation site, the pipe section was placed in a 2.0-m-deep, 2.1-m-wide trench, following subgrade compaction, on a compacted sand bedding layer. The trench was backfilled with layers of compacted sand and crushed stone to form a base to 0.8 m above the crown. In the second site, neither trench base nor bedding and fill materials were compacted. The trench consisted of a central section 2 m wide, and end sections 1.5 m wide; one-half of the length was backfilled with in situ, clay clods and the other with sand, both overlain by a layer of compacted base course to 0.5 m above the crown. Pipe deformations, monitored during installation and trafficking, and dynamic ...