Dara Nyknahad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dara Nyknahad has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Li Wang
Department of Civil and Environmental Engineering , University of Nevada , Las Vegas, 4505 Maryland Parkway, Box 454015, Las Vegas , NV , 89154-4015 , USA
2 shared publications- Nader Ghafoori
University of Nevada
2 shared publications Bharat B. Madan
Old Dominion University
1 shared publicationDoina Bein
California State University, Fullerton
1 shared publicationH Diawara
1 shared publicationHiro Ito
1 shared publication
Latest Publications
- 29 March 2016
- Published by Springer Nature in Advances in Intelligent Systems and Computing
- p. 677-687
Algorithmic Approaches for a Dependable Smart Grid
- 29 March 2016
- Published by Springer Nature in Advances in Intelligent Systems and Computing
- p. 677-687
Algorithmic Approaches for a Dependable Smart Grid
- 1 April 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 53, 473-478
Evaluation of Online Power-Down Algorithms
Power-down mechanisms are well known and are widely used to save energy, these mechanisms are encountered on an everyday basis. We consider a device which has states OFF, ON, and a fixed number of intermediate states. The state of the device can be switched at any time. In the OFF state the device consumes zero energy and in ON state it works at its full power consumption. The intermediate states consume only some fraction of energy proportional to the usage time but switching back to the ON state has different constant setup cost depending on the current state. We give results regarding power consumption to satisfy service request based on online competitive analysis. Competitive ratios, which show the effectiveness of the algorithms compared to the optimal solution, are calculated for systems with up to six states. For two state on-off systems, a decrease and reset algorithm is analyzed experimentally. It is shown that this algorithm has favorable performance for request sequences with high slackness degree.
- 1 April 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 53, 473-478
Evaluation of Online Power-Down Algorithms
Power-down mechanisms are well known and are widely used to save energy, these mechanisms are encountered on an everyday basis. We consider a device which has states OFF, ON, and a fixed number of intermediate states. The state of the device can be switched at any time. In the OFF state the device consumes zero energy and in ON state it works at its full power consumption. The intermediate states consume only some fraction of energy proportional to the usage time but switching back to the ON state has different constant setup cost depending on the current state. We give results regarding power consumption to satisfy service request based on online competitive analysis. Competitive ratios, which show the effectiveness of the algorithms compared to the optimal solution, are calculated for systems with up to six states. For two state on-off systems, a decrease and reset algorithm is analyzed experimentally. It is shown that this algorithm has favorable performance for request sequences with high slackness degree.
- 1 February 2013
- Published by Taylor & Francis in International Journal of Pavement Engineering
- Vol. 14 (2) , 176-189
Use of pulverised and fluidised combustion coal ash in secondary road construction
The research presented herein was undertaken to examine the viability of pulverised coal combustion (PCC) fly ash and fluidised bed combustion (FBC) spent bed, as a primary cementitious material and a secondary fine aggregate, respectively, for production of mixtures suitable for low-volume county and other secondary roads. To achieve the stated objective, the mechanical properties of a number of previously identified optimum PCC/FBC composites were studied in the laboratory and field. The characteristics such as unconfined uniaxial compressive strength, splitting tensile strength, modulus of elasticity and Poisson's ratio, absorption, resistance to freezing and thawing, and length change were investigated. Results conclude that the engineering properties of the PCC/FBC composites exceed those of the conventional mixes used in secondary roads. The field results reaffirm that the engineering characteristics of the laboratory mixtures can be easily attained in field. The suggested thickness design requirements are conservative when the 90-day strength of the PCC/FBC composites is considered.
- 1 February 2013
- Published by Taylor & Francis in International Journal of Pavement Engineering
- Vol. 14 (2) , 176-189
Use of pulverised and fluidised combustion coal ash in secondary road construction
The research presented herein was undertaken to examine the viability of pulverised coal combustion (PCC) fly ash and fluidised bed combustion (FBC) spent bed, as a primary cementitious material and a secondary fine aggregate, respectively, for production of mixtures suitable for low-volume county and other secondary roads. To achieve the stated objective, the mechanical properties of a number of previously identified optimum PCC/FBC composites were studied in the laboratory and field. The characteristics such as unconfined uniaxial compressive strength, splitting tensile strength, modulus of elasticity and Poisson's ratio, absorption, resistance to freezing and thawing, and length change were investigated. Results conclude that the engineering properties of the PCC/FBC composites exceed those of the conventional mixes used in secondary roads. The field results reaffirm that the engineering characteristics of the laboratory mixtures can be easily attained in field. The suggested thickness design requirements are conservative when the 90-day strength of the PCC/FBC composites is considered.
- 1 August 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 138 (8) , 998-1005
Thickness Design of PCC/FBC Composites for Secondary/County Roads
Tests were conducted in the laboratory and field to determine the extent to which fluidized bed combustion (FBC) spent bed and pulverized coal combustion (PCC) fly ash, by products of the coal industry, can be used in low-volume county and secondary roads. Various proportions of prehydrated FBC spent bed (as a secondary aggregate and an agent to activate pozzolan oxides), PCC fly ash (as a primary cementitious binder), natural fine aggregate (as a primary filler), and a low dosage of Portland cement (as a secondary cementitious compound) were blended and compacted at their optimum moisture content to ascertain their suitability as base course materials. These tests and experiments were used to assess the performance of the selected PCC/FBC base course composites. On the basis of the results, thickness-design tables of PCC/FBC base courses were developed. Results indicate that the engineering properties of the PCC/FBC composites exceed those of the conventional mixes used in low-volume roads. The field results verified that the engineering characteristics of the laboratory mixtures can be easily duplicated in field.
- 1 August 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 138 (8) , 998-1005
Thickness Design of PCC/FBC Composites for Secondary/County Roads
Tests were conducted in the laboratory and field to determine the extent to which fluidized bed combustion (FBC) spent bed and pulverized coal combustion (PCC) fly ash, by products of the coal industry, can be used in low-volume county and secondary roads. Various proportions of prehydrated FBC spent bed (as a secondary aggregate and an agent to activate pozzolan oxides), PCC fly ash (as a primary cementitious binder), natural fine aggregate (as a primary filler), and a low dosage of Portland cement (as a secondary cementitious compound) were blended and compacted at their optimum moisture content to ascertain their suitability as base course materials. These tests and experiments were used to assess the performance of the selected PCC/FBC base course composites. On the basis of the results, thickness-design tables of PCC/FBC base courses were developed. Results indicate that the engineering properties of the PCC/FBC composites exceed those of the conventional mixes used in low-volume roads. The field results verified that the engineering characteristics of the laboratory mixtures can be easily duplicated in field.
- 28 September 2011
- Published by Taylor & Francis
- p. 233-236
Pumping influence on fresh properties of self-consolidating concrete
- 28 September 2011
- Published by Taylor & Francis
- p. 233-236
Pumping influence on fresh properties of self-consolidating concrete