Effect of Printing Parameters and Heat Treatments on Microstructure Development of LPBF Manufactured Inconel 718 Alloy
- 2 October 2024
- journal article
- research article
- Published by ASTM International in Materials Performance and Characterization
- Vol. 13 (1) , 246-262
Abstract
Processing parameters of the laser powder bed fusion (LPBF) technique strongly govern achieved performances and manufacturing defects of printed alloys. In this work, it was aimed to study the effects of LPBF printing parameters and subsequent heat treatments on resulted microstructure characteristics and tensile properties of Inconel 718 alloy. Inconel samples were fabricated using three different energy densities. Then, microstructure features such as Lave phase, primary dendrite arm spacing, and internal residual stresses as microstrains of both as-built and heat-treated specimens were determined. It was found that in the range of used energy densities, alterations of phase fractions and average sizes of the Laves phase were insignificant. Decreased energy density led to microstructures with smaller primary dendrite arm spacing and thus principally contributed to enhanced yield and tensile strengths of as-printed samples, whereas increased porosity greatly deteriorated elongation. Moreover, their flow stress curves could be significantly increased by direct aging; however, typical cellular and columnar substructures occurring during the LPBF printing remained. Homogenization treatment could entirely eliminate such substructures and otherwise caused different formations of delta phase when it was performed prior to a delta process.Keywords
Funding Information
- King Mongkut’s University of Technology Thonburi (Grant No. 7/2563)
- King Mongkut’s University of Technology Thonburi (Grant No. 7/2563)
This publication has 31 references indexed in Scilit:
- Effect of Heat Treatment on the Microstructure and Properties of Inconel 718 Alloy Fabricated by Selective Laser MeltingJournal of Materials Engineering and Performance, 2021
- Effect of heat treatment on microstructural evolution and hardness homogeneity in laser powder bed fusion of alloy 718Additive Manufacturing, 2020
- The effect of laser power on the microstructure and wear performance of IN718 superalloy fabricated by laser additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2020
- Effect of build location on microstructural characteristics and corrosion behavior of EB-PBF built Alloy 718The International Journal of Advanced Manufacturing Technology, 2020
- Influence of laser processing parameters on porosity in Inconel 718 during additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2019
- Analytical evaluation of defect generation for selective laser melting of metalsThe International Journal of Advanced Manufacturing Technology, 2019
- Solution Treatment Study of Inconel 718 Produced by SLM Additive Technique in View of the Oxidation ResistanceAdvanced Engineering Materials, 2018
- An Investigation of Process Parameter Modifications on Additively Manufactured Inconel 718 PartsJournal of Materials Engineering and Performance, 2018
- Effect of residual stress on the stress corrosion cracking in boiling magnesium chloride solution of austenite stainless steelMaterials and Corrosion, 2018
- Effect of Cooling Rate on the Microstructure of Laser-Remelted INCONEL 718 CoatingMetallurgical and Materials Transactions A, 2013