Investigating the Effect of Mold Flux on Heat Transfer and Shell Formation in High‐Mn and High‐Al Steel Using a Mold Simulator
- 29 July 2026
- journal article
- research article
- Published by Wiley in Steel Research International
Abstract
The interfacial heat transfer and initial shell formation behavior of a conventional CaO–SiO 2 ‐based mold flux (Flux A) and a low‐reactivity CaO–Al 2 O 3 ‐based mold flux (Flux B) were investigated using a mold simulator for 20Mn23AlV steel. Flux B exhibited a higher melting temperature range of 873.6–1258.7 °C than Flux A (803.3–1201.2 °C), while maintaining a lower viscosity of 0.08 Pa s at 1300 °C, indicating superior high‐temperature rheological performance. Mold surface temperatures and heat fluxes in the mold simulator tests were analyzed through a 2D‐inverse heat conduction program combined with fast Fourier transformation analysis. Below the meniscus, Flux B generated larger high‐frequency temperature amplitudes but smaller standard deviations, demonstrating a more synchronized and spatially uniform thermal response. Correspondingly, the high‐frequency heat flux amplitudes near the meniscus were reduced compared with Flux A, revealing an enhanced buffering effect on transient heat transfer. These results indicate that the optimized CaO–Al 2 O 3 ‐based flux exhibits improved rheological behavior, leading to a more uniform slag film, more stable heat transfer near the meniscus, and more consistent initial shell growth. The findings provide insights into the role of low‐reactivity mold fluxes and offer guidance for flux optimization in the continuous casting of 20Mn23AlV steels.Keywords
Funding Information
- National Natural Science Foundation of China (52574393)
- National Natural Science Foundation of China (52374348)
- National Natural Science Foundation of China (U1760202)
This publication has 12 references indexed in Scilit:
- Mold Simulator Study of Initial Solidification Phenomenon at Meniscus Area for Continuous Casting Peritectic SteelSteel Research International, 2025
- Dynamic Wetting Characteristics and Quantitative Analysis of Reaction Behavior between CaO–Al2O3‐Based Mold Flux and Fe–Mn–Al–C Low‐Density SteelSteel Research International, 2025
- Improvement of strength-ductility balance of Fe-Mn-Al-C-based austenitic steel via tuning rolling strainVacuum, 2025
- Characterization and Assessment of Mold Flux for Continuous Casting of Liquid Steel Using an Inverse Mold SimulatorSteel Research International, 2021
- Challenges in the Mold Flux Design: Development of F‐Free Fluxes and Fluxes for Casting of High‐Al SteelSteel Research International, 2021
- Influence of Interfacial Thermal Resistance on Initial Solidification and Heat Transfer in Continuous Casting Mold of SteelSteel Research International, 2021
- Microstructure influence on creep properties of heat-resistant austenitic alloys with high aluminum contentMaterials Science and Engineering: A, 2020
- Computational study on various properties of CaO-Al2O3-SiO2 mold fluxCeramics International, 2019
- The origin of the brittleness of high aluminum pearlite and the method for improving ductilityScripta Materialia, 2016
- Effects of CaO/Al2O3ratio on crystallisation behaviour of CaO–Al2O3based mould fluxes for high aluminium TRIP steelIronmaking & Steelmaking: Processes, Products and Applications, 2013