Two step porosification of biomimetic thin-film hydroxyapatite/alpha-tri calcium phosphate coatings by pulsed electron beam irradiation
Open Access
- 28 September 2018
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 14530
Abstract
Here we show a new and effective methodology for rapid/controllable porosification of thin-film ceramics, which may be applied in medical devices/electronics and membrane nano-filtration. Dense hydroxyapatite applied to Ti6Al4V by plasma-assisted PVD was electron-beam irradiated to induce flash melting/boiling. Deposited coatings contained amorphous and nano-crystalline/stoichiometric hydroxyapatite (~35 nm). Irradiation (voltages 13–29 kV) led to ablation (up to 45% mass loss) and average/maximum pore areas from (0.07–1.66)/(0.69–92.53) μm2, mimicking the human cortical bone. Vitrification above 1150 °C formed (~62–30 nm) crystallites of α-Tri Calcium Phosphate. Unique porosification resulted from irradiation-induced sub-surface boiling and limited thermal conductivity of hydroxyapatite, causing material to expand/explode through the more quickly solidified top surface. Commercially applicable, roughened Ti6Al4V exacerbated the heating and boiling explosion phenomenon in certain regions, producing an array of pore sizes. Scaffold-like morphologies were generated by interconnection of micron/sub-micron porosity, showing great potential for facile generation of a biomimetic surface treatment for osseointegration.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/K029592/1, EP/K029592/1)
This publication has 48 references indexed in Scilit:
- The Current and Future Therapies of Bone Regeneration to Repair Bone DefectsInternational Journal of Dentistry, 2012
- Minimizing damage during FIB sample preparation of soft materialsJournal of Microscopy, 2011
- Normal Bone Anatomy and PhysiologyClinical Journal of the American Society of Nephrology, 2008
- Biomaterials in orthopaedicsJournal of The Royal Society Interface, 2008
- Surface treatments of titanium dental implants for rapid osseointegrationDental Materials, 2007
- A new polishing method of metal mold with large-area electron beam irradiationJournal of Materials Processing Technology, 2007
- Preparation and characterization of RF magnetron sputtered calcium pyrophosphate coatingsJournal of Biomedical Materials Research Part A, 2005
- Hydrolysis and phase transition of alpha-tricalcium phosphateBiomaterials, 1997
- Influence of discharge power level on the properties of hydroxyapatite films deposited on Ti6A14V with RF magnetron sputteringJournal of Biomedical Materials Research, 1995
- Structure, solubility and bond strength of thin calcium phosphate coatings produced by ion beam sputter depositionBiomaterials, 1992