Installation Error Calibration Method for Redundant MEMS-IMU MWD
Open Access
- 28 March 2025
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 16 (4) , 391
Abstract
For Measurement While Drilling (MWD), the redundant Micro-Electro-Mechanical Systems Inertial Measurement Unit (MEMS-IMU) navigation system significantly enhances the reliability and accuracy of drill string attitude measurements. Such an enhancement enables precise control of the wellbore trajectory and enhances the overall quality of drilling operations. But installation errors of the redundant MEMS-IMUs still degrade the accuracy of drill string attitude measurements. It is essential to calibrate these errors to ensure measurement precision. Currently, the commonly used calibration method involves mounting the carrier on a horizontal plane and performing calibration through rotation. However, when the carrier rotates on the horizontal plane, the gravity acceleration component sensed by the horizontal axis of the IMU accelerometer in the carrier is very small, which leads to a low signal-to-noise ratio, so that the measured matrix obtained by the solution is dominated by noise. As a result, the accuracy of the installation is insufficient, and, finally, the effectiveness of the installation error compensation is reduced. In order to solve this problem, this study proposes a 45°-inclined six-position calibration method based on the selected hexagonal prism redundant structure for redundant MEMS-IMUs in MWD. Firstly, the compensation matrices and accelerometer measurement errors were analyzed, and the new calibration method was proposed; the carrier of the IMUs should be installed at an inclined position of 45°. Then, six measuring points were identified for the proposed calibration approach. Finally, simulation and laboratory experiments were conducted to verify the effectiveness of the proposed method. The simulation results showed that the proposed method reduced installation errors by 40.4% compared with conventional methods. The experiments’ results demonstrated reductions of 83% and 68% in absolute measurement errors for the x and y axes, respectively. As a result, sensor accuracy after compensation improved by over 25% compared with traditional methods. The calibration method proposed by this study effectively improves the accuracy of redundant systems, providing a new approach for the precise measurement of downhole trajectories.Keywords
Funding Information
- Deep Earth Probe and Mineral Resources Exploration-National Science and Technology Major Project (2024ZD1003100, U22A20184)
- National Natural Science Foundation of China (2024ZD1003100, U22A20184)
This publication has 13 references indexed in Scilit:
- Research on active cooling technology of measuring instrument while drilling based on insulation tube in high temperature wellAlexandria Engineering Journal, 2024
- Redundant Configuration Method of MEMS Sensors for Bottom Hole Assembly Attitude MeasurementMicromachines, 2024
- Nonparametric identification of a MEMS resonator actuated by levitation forcesInternational Journal of Non-Linear Mechanics, 2023
- MIMU Optimal Redundant Structure and Signal Fusion Algorithm Based on a Non-Orthogonal MEMS Inertial Sensor ArrayMicromachines, 2023
- Installation error calibration for MEMS angular measurement system in hypersonic wind tunnelChinese Journal of Aeronautics, 2022
- Estimate the Pitch and Heading Mounting Angles of the IMU for Land Vehicular GNSS/INS Integrated SystemIEEE Transactions on Intelligent Transportation Systems, 2020
- An Algorithm for the In-Field Calibration of a MEMS IMUIEEE Sensors Journal, 2017
- An eight-position self-calibration method for a dual-axis rotational Inertial Navigation SystemSensors and Actuators A: Physical, 2015
- Analysis and calibration of the mounting errors between inertial measurement unit and turntable in dual-axis rotational inertial navigation systemMeasurement Science and Technology, 2013
- A Low-Cost, Redundant Inertial Measurement Unit for Unmanned Air VehiclesThe International Journal of Robotics Research, 2000