The Effect of Pass Number on the Wear Properties of AA5754-SiC Surface Composites Produced by Friction Stir Processing
- 30 June 2026
- journal article
- Published by Celal Bayar University Journal of Science in Celal Bayar Üniversitesi Fen Bilimleri Dergisi
- Vol. 22 (2) , 372-382
Abstract
In this study, AA5754 matrix SiC-reinforced surface composites were produced using the friction stir technique to improve their microstructural properties, wear resistance, and surface hardness. The effect of the number of passes on these properties was also investigated. Homogeneous particle distribution could not be achieved with single-pass production. Production with two and three passes using the friction stir technique was successfully achieved. The surface hardness of these SiC-reinforced surface composites showed an increase of 16% and 22%, respectively, compared to the AA5754 aluminum alloy. The wear resistance of the AA5754 aluminum alloy increased by 34.2% and 45.9%, respectively, with the production of SiC-reinforced surface composites in two and three passes.Keywords
This publication has 41 references indexed in Scilit:
- Running-in Period During Sliding Wear of Austenitic SteelsTribology Letters, 2024
- Adjusting for Running-in: Extension of the Archard Wear EquationTribology Letters, 2022
- Aluminium based in-situ composite fabrication through friction stir processing: A reviewJournal of Alloys and Compounds, 2017
- Surface composites by friction stir processing: A reviewJournal of Materials Processing Technology, 2015
- Fabrication of Al5083/B4C surface composite by friction stir processing and its tribological characterizationJournal of Materials Research and Technology, 2015
- Hardness recovery mechanism in the heat-affected zone during long-term natural aging and its influence on the mechanical properties and fracture behavior of friction stir welded 2024Al–T351 jointsActa Materialia, 2014
- Surface modification of aluminium by friction stir processingJournal of Materials Processing Technology, 2011
- Friction Stir Processing Technology: A ReviewMetallurgical and Materials Transactions A, 2008
- Third-bodies in tribologyWear, 1990
- The effect of oxide particles supplied at the interface before sliding on the severe-mild wear transitionWear, 1988