Effect of Source Mispositioning on the Repeatability of 4D Vertical Seismic Profiling Acquired with Distributed Acoustic Sensors
Open Access
Abstract
Vertical seismic profiling (VSP) with distributed acoustic sensing (DAS) is an increasingly popular evolving technique for reservoir monitoring. DAS technology enables permanent fibre installations in wells and simultaneous seismic data recording along an entire borehole. Deploying the receivers closer to the reservoir allows for better detectability of smaller signals. A high level of repeatability is essential for the robust time-lapse monitoring of geological reservoirs. One of the prominent factors of repeatability degradation is a shift between source/receiver locations (mispositioning) during baseline and monitor surveys. While the mispositioning effect has been extensively studied for surface 4D seismic, the number of such studies for VSP is quite limited. To study the effects of source mispositioning on time-lapse data repeatability, we performed two VSP experiments at two on-shore sites with vibroseis. The first study was carried out at the Otway International Test Centre during Stage 3 of the Otway project and showed that the effect of source mispositioning on repeatability is negligible in comparison with the effect of temporal variations of the near-surface conditions. To avoid these limitations, we conducted a same-day controlled experiment at the Curtin University site. This second experiment showed that the effect of source mispositioning on repeatability is controlled by the degree of lateral variations of the near-surface conditions. Unlike in marine seismic measurements, lateral variations of near-surface properties can be strong and rapid and can degrade the repeatability for shifts of the source of a few meters. The greater the mispositioning, the higher the chance of such significant variations. When the near-surface conditions are laterally homogeneous, the effect of typical source mispositioning is small, and in all practical monitoring applications its contribution to non-repeatability is negligible.Keywords
Funding Information
- CO2CRC Ltd.
- Australian National Low Emissions Coal Research and Development
- Low Emission Technology Australia (LETA)
- Australian Government
- Curtin Reservoir Geophysics Consortium
This publication has 25 references indexed in Scilit:
- Surface orbital vibrator (SOV) and fiber-optic DAS: Field demonstration of economical, continuous-land seismic time-lapse monitoring from the Australian CO2CRC Otway site2016
- Use of early arrivals for 4D analysis and processing of buried receiver data on land2015
- Using a Fibre Optic Cable as Distributed Acoustic Sensor for Vertical Seismic Profiling at the Ketzin CO2 Storage Site2015
- Suitability of vibrators for time-lapse monitoring in the Middle East2012
- Seismic Monitoring Combining Nodes and Streamer Data on Dalia field2011
- 4D seismic monitoring of CO2 sequestrationThe Leading Edge, 2010
- Applicability of Zero-offset and Offset VSP for Time-lapse monitoring – CO2CRC Otway Project Case Study2010
- A proven method for acquiring highly repeatable towed streamer seismic dataGeophysics, 2003
- Seismic repeatability, normalized rms, and predictabilityThe Leading Edge, 2002
- Repeatability issues of 3-D VSP dataGeophysics, 1999