Oil Circulation Rate in Ejector Cooling Cycles
- 3 April 2018
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In this study, the influence of compressor speed, ejector motive nozzle needle position and evaporator inlet metering valve opening on the oil circulation rates (OCRs) of an automotive R744 transcritical standard ejector cycle was experimentally investigated. Significantly higher OCR (~10%) was observed at the evaporator inlet of the ejector cycle than at the high pressure side. It has been observed that evaporator OCR was increased with increasing compressor speed. When the motive nozzle needle moved towards the nozzle throat, both compressor discharge flow rate and evaporator OCR were observed to be significantly lowered. As the evaporator inlet metering valve opening was adjusted, the compressor mass flow rate did not vary significantly while the evaporator mass flow rate decreased with decreasing metering valve opening. The evaporator OCR decreased from 6.5% to 2.2% as the metering valve opening varied from 86% to 27%.Keywords
This publication has 14 references indexed in Scilit:
- Quantification of flow and retention of oil in compressor discharge pipeInternational Journal of Refrigeration, 2017
- Experimental analysis of oil flooded R410A scroll compressorInternational Journal of Refrigeration, 2014
- Multi-ejector concept for R-744 supermarket refrigerationInternational Journal of Refrigeration, 2014
- Ejector enhanced vapor compression refrigeration and heat pump systems—A reviewRenewable and Sustainable Energy Reviews, 2012
- A review on two-phase ejector as an expansion device in vapor compression refrigeration cycleRenewable and Sustainable Energy Reviews, 2012
- Experimental and numerical investigation of the influence of the two-phase ejector geometry on the performance of the R744 heat pumpInternational Journal of Refrigeration, 2012
- Historical and present developments of ejector refrigeration systems with emphasis on transcritical carbon dioxide air-conditioning applicationsInternational Journal of Refrigeration, 2011
- Experimental validation of a prototype ejector designed to reduce throttling losses encountered in transcritical R744 system operationInternational Journal of Refrigeration, 2008
- Experimental investigation of oil retention in air conditioning systemsInternational Journal of Refrigeration, 2005
- Effects of synthetic oil in a compression refrigeration system using R410A. Part I: modelling of the whole system and analysis of its response to an increase in the amount of circulating oilInternational Journal of Refrigeration, 2003