Effects of Specimen Geometry on the J1-R Curve for ASTM A533B Steel
Authors:
- 1 January 1980
- book chapter
- Published by ASTM International
- p. 251-270
Abstract
Two experiments were performed with ASTM A533B steel to evaluate effects of compact specimen geometry on the JI versus crack growth resistance curve and evaluate validity limits for J-controlled crack growth. Side groove depth and crack length ratios were investigated with 1T compact tension specimens (1TCT) of HSST-02 plate. An investigation of thickness to ligament ratios over a broad range was conducted with 2T plan compact specimens using HSST-03 plate. All tests were performed at 150°C (302°F) using a computer-interactive unloading compliance test procedure. Results showed that side grooves straightened the crack growth. With HSST-02 plate, total side groove depth of 20 percent is required to eliminate crack tunneling. With this steel, side grooves served to reduce JIc from nonside groove measurements and also resulted in less measurement variability. A change in slip mode from planar to cross-slip did not affect the tearing modulus measurement, which was shown to be insensitive to thickness to ligament ratios ranging from 0.63 to 3.89. The minimum ω required for J-controlled crack growth for this material was shown to be on the order of one when considering less than 6 percent crack extension.Keywords
This publication has 7 references indexed in Scilit:
- The Theory of Instability of the Tearing Mode of Elastic-Plastic Crack Growth1979
- Stability Analysis of J-Controlled Crack Growth1979
- Computer Interactive JIc of Testing Navy Alloys1979
- Initial Experimental Investigation of Tearing Instability Theory1979
- Review and extension of compliance information for common crack growth specimensInternational Journal of Fracture, 1978
- Single Specimen Tests for JIc Determination1976
- A J Integral Analysis for the Compact Specimen, Considering Axial Force as Well as Bending EffectsJournal of Pressure Vessel Technology, 1974