Microstructure engineering during directed energy deposition of Al-0.5Sc-0.5Si using heated build platform
Authors:
- Amit Kumar SinghASAmit Kumar Singh
- Yasham MundadaYMYasham Mundada
- Priyanshu BajajPBPriyanshu Bajaj
- Markus B. WilmsMWMarkus B. Wilms
- Jeet P PatilJPJeet P Patil
- Sushil Kumar MishraSMSushil Kumar Mishra
- Amit AroraAAAmit Arora
- 28 November 2022
- journal article
- research article
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 202
Abstract
No abstract availableKeywords
Funding Information
- Anusandhan National Research Foundation (CRG/2018/004944)
- Board of Research in Nuclear Sciences (57/14/05/2019-BRNS)
This publication has 41 references indexed in Scilit:
- The application of computational thermodynamics and a numerical model for the determination of surface tension and Gibbs–Thomson coefficient of aluminum based alloysThermochimica Acta, 2011
- Unusual wavy weld pool boundary from dimensional analysisScripta Materialia, 2008
- Micromechanisms of multistage fatigue crack growth in a high-strength aluminum alloyActa Materialia, 2007
- Effect of Mg addition on the creep and yield behavior of an Al–Sc alloyActa Materialia, 2003
- Single-crystal laser deposition of superalloys: processing–microstructure mapsActa Materialia, 2001
- Columnar to equiaxed transition in solidification processingScience and Technology of Advanced Materials, 2001
- Theory of microstructural development during rapid solidificationActa Metallurgica, 1986
- Steady state columnar and equiaxed growth of dendrites and eutecticMaterials Science and Engineering, 1984
- Dendrite growth at the limit of stability: tip radius and spacingActa Metallurgica, 1981
- Stereology, or the quantitative evaluation of microstructuresJournal of Microscopy, 1969